2023 Ford E-450

The contact owns a 2023 Ford E-450. The contact discovered shortly after the purchase of the vehicle, that during the manufacturing, the vehicle was improperly assembled and was missing the fasteners, the housing to the frame, and the bottom of the vehicle was missing several bolts. The dealer was contacted; however, the vehicle remained at the residence. The manufacturer was not notified of the failure. The failure mileage was approximately 22,400.

NHTSA ID

11663099

Incident

Apr 23, 2025

Mileage

22,400 mi

The contact owns a 2023 Ford E-450. The contact stated that while driving after a cold start at approximately 2 mph, the vehicle suddenly accelerated without warning. The rear wheels were spinning and smoking was detected. The driver depressed the brake pedal but the trailer fishtailed and crashed into a parked Toyota Venza Hybrid. There were no reported injuries, fire or air bag deployment. A police report was filed. The contact called the local dealer but the vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 1,395.

NHTSA ID

11505753

Incident

Feb 3, 2023

Mileage

1,395 mi

This article supersedes TSB 25-2572 to update the Parts List to correct the part number LC3Z-6006-L to LC3Z-6781-A, remove the flex plate bolts AL3Z-6379-BA from the parts list as these bolts are in kit LC3Z-6781-A, update the claim quantity of the part number W709771-S440 to 9 pieces (F-650/F750-Engine Replacement), W706447-S437 and W715068-S437 to 4 pieces, W712861-S439 to 8 pieces(F-Super Duty Pickup And Chassis Cab-Engine Replacement) / 8 pieces (F-53 Motorhome/F-59 Stripped Chassis Cab/F-650,F750 Engine Replacement) / W714286-S442 to 4 pieces (F-Super Duty Pickup And Chassis Cab-Camshaft and Tappet Repair / F-Super Duty Pickup And Chassis Cab-Engine Replacement), include LC3Z-6020-A for the Engine replacement lists, include 1 fuel injector seal kit to the Camshaft and Tappet repair lists, include 4 pieces of W520114-S440 to the E Series-Camshaft and Tappet Repair list, and update the engine oil part numbers XO-5W30-Q1SP and CXO-5W30-LSP6. Some of the vehicles listed in the Model statement above may exhibit an upper engine ticking or tapping noise at idle. Customers may also report experiencing ro

2023-2024 F-Super Duty/F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2023-2025 F-650/F-750/E-Series vehicles equipped with a Dana rear axle and built on or after 01-Jul-2022 may have orange/red RTV sealant used as the gasket on the differential housing cover. This does not indicate any previous repairs as it is used by Dana during assembly.

This article supersedes TSB 25-2322 to update the Service Procedure, Labor Operations and Parts List. Some of the vehicles listed in the Model statement above may exhibit an upper engine ticking or tapping noise at idle. Customers may also report experiencing rough engine performance, engine misfire, or a malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0301-P0308 in the powertrain control module (PCM). This may be due to camshaft and/or valve tappet having excess wear within the engine assembly.

Some 2021-2025 Expedition/Navigator/F-150/F-Super Duty/F-53 Motorhome/F59 Commercial Stripped Chassis/F-650/F-750/Transit vehicles equipped with a 2.7L/3.5L (non hybrid)/6.8L/7.3L engine and 2021-2026 E-Series may exhibit a rattle/scraping noise from the bellhousing area on start-up. Workshop Manual (WSM), Section 303-00 Engine System - General Information > Diagnosis and Testing and 303-06 > Starting System has been updated to address this condition. Additionally, WSM, Section 303-01 > Removal and Installation > Engine to Transmission Spacer Plate has been added to address this condition. Refer to the revised WSM sections for normal diagnosis.

Some 2021-2025 F-150 vehicles equipped with a 5.0L/5.2L engine, 2021-2025 F-Super Duty/F-53 Motorhome/F59 Commercial Stripped Chassis vehicles equipped with a 6.8L/7.3L engine and 2021-2026 E-Series/F-650/F-750 vehicles equipped with a 7.3L engine may exhibit a rattle/scraping noise upon startup that may remain after the engine is running. This may be due to the starter motor drive gear not retracting after starting. To correct this condition, inspect the starter motor drive gear and shaft. If the starter motor drive gear slides back and forth by hand and/or shows signs of scoring or damage, replace the starter motor following Workshop Manual (WSM), Section 303-06 Starting System > Removal and Installation > Starter.

Some of the vehicles listed in the Model statement above may exhibit an incorrectly illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0128, P0420, and/or P0430 stored in the powertrain control module (PCM). This may be due to the software in the PCM.