2015 Ford F-53

The contact owns a 2015 Ford F-53. The contact stated while driving at an undisclosed speed, the contact stated the windshield wipers on both sides of the vehicle were not functioning properly. There was no warning light illuminated. The contact stated that the windshield wipers had completely stopped working. The vehicle was taken to the dealer but was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 23,000.

NHTSA ID

11615599

Incident

Sep 20, 2024

Mileage

23,000 mi

The contact owns a 2015 Bounder Class A RV built on a 2015 Ford F-53 Chassis. The contact stated while driving 60 MPH, the engine made an abnormal ticking sound. The check engine warning light was illuminated. The contact was able to continue driving. The RV was taken to the dealer, where it was diagnosed that the camshaft needed to be replaced. The RV was not repaired. The contact related the failure to Ford Campaign Number: 17B30. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 29,000.

NHTSA ID

11564878

Incident

Dec 5, 2023

Mileage

29,000 mi

I BOUGHT THIS RV, 6 MONTHS AGO AND HAVE PUT APPROXIMATELY 4,000 MILES ON IT. THE PASSENGER SIDE WIPER ARM FELL BELOW THE WINDOW AND CAUSED THE DRIVER SIDE NOT TO FUNCTION. I TOOK IT TO THE DEALER AND WAS TOLD THE RECALL HAD ALREADY BEEN PERFORMED. I THEN CONTACTED THOR WHO INFORMED ME MY RV WAS OUT OF WARRANTY. IT WOULD APPEAR FROM THE PHOTOS ATTACHED THAT THE RECALL WAS NOT PERFORMED PROPERLY. *TT *TR*JB

NHTSA ID

11113769

Incident

Jul 2, 2018

TL* THE CONTACT OWNS A 2015 FORD F-53. THE CONTACT STATED THAT THE PASSENGER DOOR FAILED TO OPEN. THE CONTACT AND HER PETS WERE LOCKED INSIDE THE VEHICLE. THE CONTACT, AN ENGINEER, WAS ABLE TO TAKE THE LOCK APART AS A TEMPORARY REMEDY TO ALLOW THE PASSENGERS TO EXIT THE VEHICLE. THE VEHICLE WAS NOT TAKEN TO THE DEALER, DIAGNOSED, OR REPAIRED. THE MANUFACTURER WAS NOT CONTACTED. THE APPROXIMATE FAILURE MILEAGE WAS 18,000.

NHTSA ID

11029983

Incident

Sep 9, 2017

Mileage

18,000 mi

TL* THE CONTACT OWNS A 2015 FORD F-53. THE CONTACT STATED THAT WHILE DRIVING AT VARIOUS SPEEDS WHILE IT WAS RAINING AND HAD TURN THE WINDSHIELD SWITCH ON, THE PASSENGER SIDE WIPERS WOULD GET TANGLED WITH THE DRIVER SIDE WIPERS AND BOTH WOULD STAYED DOWN UNDER THE WINDSHIELD FAILING TO FUNCTION. THE VEHICLE WAS TAKEN TO THE DEALER MULTIPLE TIMES WHERE THE TECHNICIAN TIGHTENED THE NUTS ON THE WINDSHIELD HOWEVER THE FAILURE WAS NOT CORRECTED. THE DEALER INFORMED THE CONTACT THAT THEY BELIEVED IT WAS A DESIGN FLAW. THE CONTACT CALLED THE MANUFACTURER AND NOTIFIED THEM OF THE FAILURE, THE MANUFACTURER DID NOT OFFER FURTHER ASSISTANCE AND HAD TOLD THE CONTACT IT WAS NOT THEIR PROBLEM. THE VIN WAS INCLUDED IN NHTSA CAMPAIGN NUMBER: 17V162000 (VISIBILITY). THE APPROXIMATE FAILURE MILEAGE WAS 5,000.

NHTSA ID

10986077

Incident

May 12, 2016

Mileage

5,000 mi

I WAS INJURED WALKING INTO THE SLIDE LOCATED ON THE RIGHT HAND PASSENGER SIDE OVER THE REAR PASS THROUGH STORAGE AREA.BECAUSE OF THIS LOCATION/DESIGN THE BACK SLIDER IS 57 INCHES FROM THE GROUND .THE PLASTIC MOLDING OF THIS PARTICULAR CORNER HAD SEPARATED FROM THE VEHICLE RESULTING IN THE EXPOSURE OF SHARP SHEET METAL EDGE BEING EXPOSED.TWO OF THE FOUR CORNERS HAD SEPARATED IN THIS MANNER POSSIBLY BECAUSE OF A DESIGN FLAW IN WHICH A FOURTH SCREW BEING APPLIED DEAD CENTER IN THE CORNER INSTEAD OF 3 SCREWS APPLIED IN A L - SHAPED MANNER.THIS SEPARATION WAS DISCOVERED AFTER I THE INJURY.THERE ARE NO WARNING/CAUTIONARY SIGNS TO INSPECT CORNERS B/C OF THIS HAPPENING.OUR OWNERS MANUAL DOES NOT WARN OF THIS POSSIBLE DANGER.IF A SHORTER PERSON(I AM 5 FT 2 INCHES TALL) OR A CHILD MADE CONTACT WITH THE CORNER,THE RESULTING INJURY COULD HAVE RESULTED IN SERIOUS EYE INJURIES OR "SCALPING" THIS IS OUR FOURTH MOTORHOME SO WE ARE FAMILIAR WITH SLIDERS..... THE FIRST TIME I OR ANY MEMBER OF OUR CAMPING FAMILY WAS INJURED. MOTORHOME WAS PARKED IN OUR DRIVEWAY IN AN AREA DESIGNATED FOR STORAGE IN THE DRIVEWAY.IT IS MARKED WITH DECORATIVE RAILROAD TIES AND GRAVELLED.THE INJURY RESULTED IN A V - SHAPED FILLETEDSKIN FLAP .LEFT SIDE CAUSED BY SEPARATED PLASTIC REQUIRING 6 SUTURES ; RIGHT SIDE CAUSED BY EXPOSED SHARP SHEET METAL CAUSING DEEPER LACERATIONS REQUIRING 14 SUTURES.....WITH THE LAST SUTURE BEING REMOVED AND REDONE TOTALLING 21 STITCHES.IT IS UNKNOWN IF I PASSED OUT BUT THERE IS TIME NOT ACCOUNTED FOR WHICH MAKES ME BELIEVE THAT I DID PASS OUT.ACCIDENT OCCURRED @ 10:30 AM ON THURSDAY,JULY 21,2016.MY HUSBAND AND 2 FRIENDS CARED FOR MY INJURIES IN A TIMELY MANNER,ICING THE INJURY,STOPPING(SLOWING THE HEAVY BLEEDING,AND COVERING ME WITH A BLANKET B/C OF CONCERN THAT I WAS IN SHOCK.I WAS TRANSPORTED BY CAR TO THE LOCAL URGENT CARE CENTER WHERE I WAS ADMITTED @ 11:45 AM.

NHTSA ID

10896472

Incident

Jul 21, 2016

Mileage

4,000 mi

BOLT HOLDING UPPER PART OF REAR DRIVER SIDE SWAY BAR BRACKET MISSING. SAME BOLT ON PASSENGER SIDE LOOSE. BRACKET ON DRIVER SIDE BENT AND OUT OF POSITION. BUSHING WALKED UP BAR AND IN CONTACT WITH SPRING SEAT BOLT.

NHTSA ID

10862217

Incident

Aug 28, 2015

Mileage

5,000 mi

Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k

While performing a transmission repair on some 2012-2024 Ford and Lincoln vehicles, a transmission seal kit may be on backorder due to supply chain interruptions. While performing a transmission repair on some 2012-2024 Ford and Lincoln vehicles, a transmission seal kit may be on backorder due to supply chain interruptions.

All accessory stick-on keyless entry keypads come with a wallet card containing the master code. If the accessory keypad was factory installed, this card will be placed in the glove box and should be handed to the vehicles owner during initial delivery. Unlike the integrated (wired) factory keypad, the accessory keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool. If the wallet card for an accessory keypad is lost, follow these steps to recover the code. Dealer Key Code access is granted through the Dealer Program Enrollment System (DPES); dealership management can authorize users. The authorized user must go to FMCDealer.com > Parts and Service > Parts Product Line Information > Keys/Entry Devices > Aftermarket Keyless Entry Keypad Code Access. Follow the instructions on the screen to obtain the master code for the accessory keypad.

Various 2013-2019 vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P264F after powertrain control module (PCM) replacement. This DTC indicates that the engine serial number (ESN) must be programmed into the PCM. The ESN is located on PTS > Diagnostics tab > HVBoM > Features > Engine Serial Number. Once the ESN is obtained from the historical vehicle bill of materials (HvBOM), it can be programmed into the PCM using the appropriate Ford diagnostic scan tool. Navigate to the toolbox tab> powertrain menu> Service Functions> ESN.

Various 2013-2019 vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P264F after powertrain control module (PCM) replacement. This DTC indicates that the engine serial number (ESN) must be programmed into the PCM. The ESN is located on PTS> OASIS> Features> Engine Serial Number. Once the ESN is obtained from the historical vehicle bill of materials (HvBOM), it can be programmed into the PCM using the appropriate Ford diagnostic scan tool. Navigate to the toolbox tab> powertrain menu> Service Functions> ESN.

For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.