2022 Ford Mustang

It's the 4th time in the last 3 weeks that the passenger door which is locked just opens on its own. I start to hear the air hissing and I get a door open alarm in the dashboard. Scary because 2x it was while on I -4 and almost lost control of the car trying to figure out what was happening and trying to reach for the door.

NHTSA ID

11754318

Incident

Jul 13, 2026

Steering u-joint sticks and prevents steering wheel from turning without a catch/hitch . Not evident at lower speeds but is prevalent at speeds 50 and above. The photos attached show the part and one picture shows a YouTube video showing the EXACT problem. The video title is shown in picture: Dangerous Steering Problem And it is very scary at the higher speeds when it sticks and you have to exert force to move it to right or left. Trying to stay in a lane is a problem!! Electronic steering was checked by dealer last year and they found nothing as they probably didn’t test drive it at the higher speeds; has continued till today and after a road trip yesterday I went online and found this information!

NHTSA ID

11742787

Incident

Jun 8, 2026

The contact owns a . The contact received notification of NHTSA Campaign Number: 25V455000(FUEL SYSTEM, GASOLINE); however, the part to do the recall repair was unavailable. The local dealer was contacted and it was confirmed that the part was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced the failure while driving up a hill the vehicle did not properly accelerate when pressing the accelerator pedal. The failure mileage was 27,000.

NHTSA ID

11740535

Incident

May 1, 2025

Mileage

27,000 mi

The contact owns a 2022 Ford Mustang. The contact received notification of NHTSA Campaign Number: 25V455000 (Fuel System, Gasoline); however, the part to do the recall repair was not yet available. The contact stated while driving 60 MPH, the engine shuddered as if it was starving from fuel. The check engine warning light illuminated. The contact was able to drive to the residence, and the vehicle was parked in the garage. The contact had stopped driving the vehicle due to safety concerns.  The dealer and several other unknown dealers were contacted but were unable to advise when the parts would be available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 10,102.

NHTSA ID

11740129

Incident

Mar 26, 2026

Mileage

10,102 mi

Other cars for the same year model have a recall for the issue I’m having. 24S44 Is the ford recall code. Power steering is boosted and can oscillate side side. I’ve seen other mustangs with this recall have the same issue get repaired. Mine has the exact same issue. I didn’t notice it was an issue until I had an alignment. The alignment from factory was so bad the inside of the

NHTSA ID

11740019

Incident

Feb 15, 2025

Vehicle still does not have a remedy after nearly a year preventing use.

NHTSA ID

11737271

Incident

May 11, 2026

The vehicle is a 2022 Ford Mustang EcoBoost. While driving in traffic, the engine suddenly stalled and shut off without warning. This created an immediate safety risk as the vehicle lost power in the middle of active traffic flow, requiring me to quickly maneuver to avoid blocking traffic and potential collision. The issue appears consistent with a fuel delivery or fuel pressure failure, as the engine restarted immediately after the stall. Prior to this incident, the vehicle had shown intermittent warning signs including check engine light activation and suspected misfire-related alerts. The problem has not yet been fully reproduced or confirmed by a dealer as a root cause, although the vehicle has been presented for service and was found to have no active recall tied to the VIN according to the dealership. No formal inspection or diagnosis confirming the exact failed component has been completed yet. No police, insurance representatives, or manufacturer inspectors have examined the vehicle at this time. Warning lamps (check engine light) and possible misfire-related symptoms were present prior to the failure. These symptoms appeared intermittently over the weeks leading up to the stall, particularly after periods of low fuel operation. Based on the symptoms and behavior, the incident closely matches known fuel system issues reported in similar Ford Mustang EcoBoost vehicles, including those associated with fuel pressure loss leading to engine stall while driving. The suspected system involved is the low-pressure fuel delivery system (fuel pump or related components), which is available for inspection upon request.

NHTSA ID

11730267

Incident

Feb 21, 2026

The contact owns a 2022 Ford Mustang. The contact stated that the rear-view camera image was blank or distorted. The contact attempted to update the software to reboot the system; however, the failure persisted. The vehicle was taken to a dealer where it was diagnosed, and the failure was associated with NHTSA Campaign Number: 25V442000 (BACK OVER PREVENTION); however, the VIN was not included in the recall repair. The vehicle was not included. The manufacturer was notified of the failure. The failure mileage was 103,244.

NHTSA ID

11728926

Incident

Sep 1, 2025

Mileage

103,244 mi

NEW VEHICLE DELIVERY HOLD - Emissions Recall 26E04 Certain 2021-2025 Model Year F-150, Maverick, Mustang, Ranger, Expedition, Bronco Sport, Explorer, Bronco, Navigator, and Aviator Vehicles Powertrain Control Module Software Update

This bulletin supersedes 26-2241. Reason For Update: update the parts list to correct the claim quantity of the part number JB3Z-4B496-B from 3 to 6. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: * Harsh 3-4, 4-5 upshifts * Harsh 5-3, 4-3 downshifts * Harsh reverse engagements These symptoms may be worse when cold. This may be due to the F clutch friction plates brinelling into the clutch and planetary container cylinder (7B177).

This bulletin supersedes 25-2587. Reason For Update: update the Parts list to add the F-clutch friction plates HL3Z-7B164-D and the F-clutch steel plates PR3Z-7B164-A for the proper vehicle lines, replace the transfer case mounting bolt part number from W714288-S438 to W714288-S437, update the part number W720688-S439 quantity from 2 to 1, update the part number ML3Z-7869-C claim quantity from 2 to 1 (only if necessary), update the description of CXT-10-LV6 and XT-10-QLVC by adding "transfer case fluid, 4WD only", move HL3Z-7A191-B and L1MZ-7F396-A fluid pan gaskets to the parts to inspect and replace list, and remove TL1Z-6775-A self adhesive heat shield from the F-150/Expedition/Navigator parts list as it is not a discard item. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: * Harsh 3-4, 4-5 upshifts * Harsh 5-3, 4-3 downshifts * Harsh reverse engagements These symptoms may be worse when cold. This may be due to the F clutch friction plates brinelling into the clutch and planetary container cylinder (7B177).

This bulletin supersedes 26-2046. Reason For Update: update the parts list to change the claim quantity of the C clutch friction plates (HL3Z-7B164-A), C clutch steel plates (HL3Z-7B442-F), D clutch steel plates (HL3Z-7B442-D), add the rear driveshaft flange CV joint-to-pinion flange cup bolts and retaining straps (LK4Z-4B496-B) for Transit, and update the parts description for the transfer case fluids applicable for each vehicle line. Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: * Harsh engagement * Delayed engagement * Harsh shift * Delayed shift * Illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0751, P0752, P0756, P0757, P0761, P0762, P0766, P0767, P0771, P0772, P2700, P2701, P2702, P2703, P2704, P2705, P2707, P2708, P0729, P0731, P0732, P0733, P0734, P0735, P0736, P076F, P07D9, P07F6 and/or P07F7 stored in the powertrain control module (PCM) or transmission control module (TCM). This may be due to PCM software and/or axial movement of the CDF clutch cylinder (7H351) sleeve causing hydraulic circuit

For 20212026 vehicles equipped with the 10R80 transmission, a new Transmission Clutch Circuit Leak Test has been introduced in the Ford Diagnosis and Repair System (FDRS). This test utilizes the pressure and vacuum transducer (PVT) when available. When referred to a specific clutch (A-F) test by a pinpoint test in Workshop Manual (WSM), Section 307-01 > Diagnosis and Testing, the Clutch Assembly tests have been updated with a hyperlink to the new Transmission Line Pressure Test - Pressure Vacuum Transducer (PVT) Is Available procedure in WSM, Section 307-01 > General Procedures. This procedure provides instructions to perform the FDRS Transmission Clutch Circuit Leak Test when applicable. The new test improves the accuracy of detecting leaks within transmission fluid circuits and replaces the previous air check method. The previous air check procedure has been shown to produce a high rate of false positives, which may lead to unnecessary repairs when no actual leak is present. Accordingly, the air check procedure is not to be used for diagnosing internal transmission hydraulic leaks or as justification

Various 2020-2026 Ford and Lincoln vehicles equipped with blind spot information system (BLIS) may experience an inoperative blind spot monitoring with a "Blind Spot System Fault" message displayed in the instrument panel cluster (IPC). This may also be accompanied by diagnostic trouble codes (DTCs) B118C:11 and/or B118C:15 stored in the driver door module (DDM), and/or B118D:11 and/or B118D:15 stored in the passenger door module (PDM). This may be due to the wiring connector from the mirror to the BLIS module. If diagnostics lead to an internal mirror wiring harness fault, a new lower level BLIS light pigtail is now released for service. It is not necessary to replace the exterior mirror assembly. Use part number SC3Z-14A411-B to resolve the concern.