2006 Honda Pilot

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The Office of Defects Investigation (ODI) opened PE14-016 in June 2014 based on six inflator rupture incidents involving consumer owned vehicles produced by five vehicle manufacturers.All six vehicles were operated in Florida or Puerto Rico at the time of the rupture and for the majority of their service life, and were equipped with inflators produced by Takata, a tier-one supplier of automotive air bag systems.During the course of PE14-016, ODI determined that five additional vehicle manufacturers used inflators of a similar design and vintage also supplied by Takata. No evidence of field failures was found in vehicles produced by these five additional manufacturers.Nonetheless, at ODI's insistence, all 10 vehicle manufacturers initiated a regional recall within approximately two weeks of the opening of the investigation.The regions recalled initially included Florida, Puerto Rico, Hawaii, and the U.S. Virgin Islands, areas with high absolute humidity and climatic conditions believed to be a significant factor in the inflator ruptures.As part of the recall actions, inflators removed from remedied vehicles are to be returned to Takata for testing.Takata's initial test results on passenger inflators from remedied vehicles indicated a much higher than anticipated rupture frequency for inflators returned from Florida.Accordingly ODI requested all 10 manufacturers expand the regional recalls for passenger inflators to include other geographic areas where high absolute humidity conditions exist, including the Gulf States and other coastal areas.Takata's testing of the passenger inflators to date continues to indicate this geographic area as having the highest risk, with no ruptures occurring from inflators returned from outside the expanded recall regions.During PE14-016 four additional passenger inflator field events occurred, all in vehicles from the same expanded geographic region.Also during PE14-016 four additional driver inflator field events occurred including two in vehicles from regions not known for high absolute humidity, specifically California and North Carolina.Accordingly, ODI requested all five of the affected vehicle manufacturers currently using the subject Takata driver inflators expand to nationwide recalls.Significantly, neither of the affected vehicle manufacturers or Takata provided any explanation to account for these two driver air bag inflator ruptures outside the area of high absolute humidity.Takata testing of returned driver inflators indicates a lower rupture frequency as compared to passenger inflator testing.All test ruptures reported by Takata to date have occurred on inflators returned from high absolute humidity areas.The investigation now includes all manufacturers and vehicles known to be affected at this time.ODI's investigation will focus on, among other things, root cause analysis, other potential defect consequences, identification of affected vehicles scope, and adequacy of the remedy.The five ODI reports cited above can be reviewed online at http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10537899, 10568848, 10585224, 10605877, 10651492

The Office of Defects Investigation (ODI) opened PE14-016 in June 2014 based on six inflator rupture incidents involving consumer owned vehicles produced by five vehicle manufacturers.All six vehicles were operated in Florida or Puerto Rico at the time of the rupture and for the majority of their service life, and were equipped with inflators produced by Takata, a tier-one supplier of automotive air bag systems.During the course of PE14-016, ODI determined that five additional vehicle manufacturers used inflators of a similar design and vintage also supplied by Takata. No evidence of field failures was found in vehicles produced by these five additional manufacturers.Nonetheless, at ODI's insistence, all 10 vehicle manufacturers initiated a regional recall within approximately two weeks of the opening of the investigation.The regions recalled initially included Florida, Puerto Rico, Hawaii, and the U.S. Virgin Islands, areas with consistently high absolute humidity and climatic conditions believed to be a significant factor in the inflator ruptures.As part of the recall actions, inflators removed from remedied vehicles are to be returned to Takata for testing.Takata's initial test results on passenger inflators from remedied vehicles indicated a much higher than anticipated rupture frequency for inflators returned from Florida.Accordingly, ODI requested all 10 manufacturers expand the regional recalls for passenger inflators to include other geographic areas where high absolute humidity conditions exist, including the Gulf States and other coastal areas.Takata's testing of the passenger inflators to date continues to indicate this geographic area as having the highest risk, with no ruptures occurring from inflators returned from outside the expanded recall regions.During PE14-016, four additional passenger inflator field events occurred, all in vehicles from the same expanded geographic region.Also during PE14-016, four additional driver inflator field events occurred including two in vehicles from regions not known for high absolute humidity, specifically California and North Carolina.Accordingly, ODI requested all five of the affected vehicle manufacturers currently using the subject Takata driver inflators expand to nationwide recalls.Significantly, neither of the affected vehicle manufacturers or Takata provided any explanation to account for these two driver air bag inflator ruptures outside the area of high absolute humidity.Takata testing of returned driver inflators indicates a lower rupture frequency as compared to passenger inflator testing.All test ruptures reported by Takata to date have occurred on inflators returned from high absolute humidity areas.The PE is now closed/upgraded to an Engineering Evaluation (EA15-001) to include all manufacturersand vehicles known to be affected at this time.ODI's EA investigation will focus on, among other things, root cause analysis, other potential defect consequences, identification of affected vehicles scope, and adequacy of the remedy.The recalls related to this PE are: 14V343, 14V344, 14V348, 14V351, 14V353, 14V655, 14V700, 14V701, 14V752, 14V763, 14V770, 14V773, 14V787, 14V802 and 14V817.The number of vehicles affected are an estimate since some vehicles may have both the driver and passenger side inflators recalled. The five ODI reports cited above can be reviewed online at http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10537899, 10568848, 10585224, 10605877, 10651492

Suspension is rusted out and falling apart

NHTSA ID

11725138

Incident

Aug 1, 2025

Unknown

NHTSA ID

11694291

Incident

Sep 17, 2025

Odometer Fraud. The contact purchased a 2006 Honda Pilot. The contact stated that while attempting to register the vehicle, it was discovered that there was a mileage discrepancy. The vehicle was an auction sale. At the time of purchase, the vehicle mileage was 74,009 and at the time of registration, it was discovered that the mileage was 300,151.

NHTSA ID

11690295

Incident

Sep 1, 2025

Mileage

300,151 mi

The Vehicle Stability Assit (VSA) system in activating inappropriately causing the vehicle to brake unexpectedly. There is a Honda Service Bulletin (13-026) for this problem for 2005 Honda Pilots. Well, the same problem is happening to my 2006 Pilot.

NHTSA ID

11676493

Incident

Jul 22, 2025

When I got into the vehicle this morning, I opened the door and smoke came out from inside, then I noticed in the driver's seat there was fire from the control panel of the driver's seat. Where the fire affected the seat, the seat belt and the interior panel of the driver's door.

NHTSA ID

11675877

Incident

Jul 24, 2025

Rear suspension cradle attachment points at the frame corrode. This is common on all pilots in northern climates. Honda has recalled both the Ridgeline and CRV models for corrosion issues related to suspension attachment point corrosion but refuses to recall the pilot. While they claim you will not lose control when the suspension disconnects from the frame the vehicle cannot pass inspection and thus becomes disposable. When vehicles are otherwise perfect this is not acceptable from both safety and fiscal aspects. Please investigate this further as Honda has a repair kit and guidelines but charges thousands for the work .

NHTSA ID

11653782

Incident

Apr 1, 2025

While driving, the seat came off the base and something was loose, the seat basically will fall back if you just lean back, while stop and go the seat will also move back, something is loose or broken, this is a defect from Honda. Yes this can be inspected upon request this is dangerous because the seat can break off and just fall back anytime not only impact the driver safety while it can also hurt someone sitting behind it No the seat has not been inspected by anyone other during oil change check was told to have someone to look at it. No there is no warning or message or any symptoms before the failure

NHTSA ID

11624295

Incident

Oct 1, 2024

The contact owns a 2006 Honda Pilot. The contact stated that following a State Safety Inspection, the vehicle failed due to extensive corrosion to the rear suspension and to the rear trailing arm. The contact was advised by the State Inspector not to drive the vehicle due to the advanced state of corrosion. The contact had researched online and related the failure to NHTSA Campaign Number: 23V228000 (Structure). The contact had called the manufacturer and was informed that the vehicle was not included in the recall. The vehicle was not taken to a dealer or independent mechanic. The vehicle was not diagnosed and was not repaired. The failure mileage was approximately 175,000.

NHTSA ID

11607352

Incident

Jul 29, 2024

Mileage

175,000 mi

Service Bulletin - Warranty Extension: Customer Support Program For Front Passenger's Airbag Inflator.

Service News - The navigation clock and date are incorrect. This is due to a limited GPS receiver Capacity resulting in rollover of the internal chip memory; the rollover occurred on January 1, 2022, at 12:00AM local time.

Service bulletin - This bulletin is a notification of a class action settlement relating to airbag inflators. American Honda is offering a Customer Support Program (Warranty Extension) to cover any manufacturing defects in the replacement front passenger's airbag inflator only.

Service Bulletin - Corrosion of the frame rail that supports the rear subframe may occur on some vehicles that are commonly driven in harsh environments. The subframe mounts may pull away from the body of the vehicle (see images below), but extensive testing has concluded that vehicle stability will be maintained. As an alternative to a complete frame replacement, a frame repair kit has been developed.

ServiceNews Article - The clock shows the incorrect time. This issue is due to a limited GPS receiver capacity resulting in "rollover" of the internal chip memory; the "rollover" will occur on January 1, 2022, at 12:00AM local time. As a result, once specific triggers are met, the navigation date and time will be incorrect.

"Service Bulletin - There are several A/C leak detection tools available. -Refrigerant Gas Leak Detector -Ultrasonic Leak Detector -Leak Dye"