2006 Toyota Sienna

Please see the attached closing resume summary.It has been attached to this document as a PDF.

ODI'S ANALYSIS OF WARRANTY DATA SHOWS THAT THE ALLEGED DEFECT HAS OCCURRED IN JUST 0.2 PERCENT OF THE SUBJECT VEHICLE POPULATION.WHEN THE ANALYSIS IS LIMITED TO SALT-BELT STATES, THE RATE IS STILL WELL BELOW ONE PERCENT OF THE POPULATION (0.4 PERCENT).IN ADDITION, TESTS CONDUCTED BY ODI AND TOYOTA HAVE SHOWN THAT THE ALLEGED DEFECT HAS A MINIMAL AFFECT ON STEERING EFFORTS.ODI INTERVIEWS OF OWNERS WHO EXPERIENCED THE ALLEGED DEFECT INDICATED THAT IN MOST CASES THE PROBLEM WAS PRECEDED BY MONTHS OR YEARS OF NOISE OR A GRADUAL INCREASE IN STEERING EFFORTS IN THE INITIAL STEERING MANEUVERS AFTER FIRST STARTING A COLD VEHICLE.THE SUBJECT VEHICLES HAVE BEEN IN SERVICE FOR 4 TO 5 YEARS WITH NO CRASHES OR INJURIES ASSOCIATED WITH THE ALLEGED DEFECT.TOYOTA'S TECHNICAL SERVICE BULLETIN PROVIDES ASSISTANCE TO SERVICE TECHNICIANS IN THE EARLY DIAGNOSIS AND REPAIR OF THE ALLEGED DEFECT CONDITION. ACCORDINGLY, THIS INVESTIGATION HAS BEEN CLOSED. THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY-RELATED DEFECT DOES NOT EXIST.THE AGENCY WILL CONTINUE TO MONITOR COMPLAINTS AND OTHER INFORMATION RELATING TO THE ALLEGED DEFECT IN THE SUBJECT VEHICLES AND TAKE FURTHER ACTION IN THE FUTURE IF WARRANTED.FOR ADDITIONAL INFORMATION REGARDING THIS ENGINEERING ANALYSIS REFER TO THE EA08-024 CLOSING REPORT.

ON MAY 30, 2008, TOYOTA INITIATED A SAFETY RECALL TO REPLACE THE LIFTGATE STRUTS IN APPROXIMATELY 196,000 MODEL YEAR 2004-2006 TOYOTA SIENNA VEHICLES EQUIPPED WITH POWER LIFTGATES (RECALL 08V-244).THE RECALL WILL PROVIDE THE OPPORTUNITY FOR VEHICLE OWNERS TO OBTAIN NEW STRUTS THAT ARE MORE ROBUST.BASED ON THESE ACTIONS, THE AGENCY HAS DECIDED TO CLOSE THE INVESTIGATION.WHILE TOYOTA HAS NOT MADE A DECISION THAT THE RECALLED VEHICLES CONTAIN A SAFETY-RELATED DEFECT, IN VIEW OF THE RECALL, FURTHER USE OF THE AGENCY'S RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE ANY FINDING BY NHTSA.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.ADDITIONAL INFORMATION CAN BE FOUND IN THE ENGINEERING ANALYSIS REPORT.

The TPMS system failed in the ECM or engine computer. It uses the wheel speed sensors on each hub to measure differences in wheel speed and uses this to infer if any one wheel has low tire pressure. (This vehicle does not have TPMS sensors in the wheels.) However, with this failure, it reports a tire pressure problem even though all 4 tires are inflated properly. This problem persists even after cleaning then replacing wheel speed sensors. The problem appears to be in the ECM or engine computer, which is very difficult and expensive to replace. With this problem, the driver is never able to tell if any tire actually has low pressure because the system always reports that a tire has low pressure. Toyota should be required to fix this issue in all affected vehicles.

NHTSA ID

11722856

Incident

Apr 15, 2023

While driving, there was a recurrent sound like doors locking and unlocking, several dozen times over a half hour drive at 50 miles per hour. When stopped, the passenger side sliding door opened by itself. Luckily, my dogs were in a kennel or they might have jumped out of the car. I closed it and it opened by itself again. At home, the passenger side sliding door opens when my neighbor presses the button on his key fob to open his non-Toyota pickup truck. It will not open or close when I press the button on my Sienna key fob.

NHTSA ID

11708132

Incident

Dec 31, 2025

The contact owns a 2006 Toyota Sienna equipped Hercules Tires, Tire Line: Roadtour 855 SPE, Tire Size: 215/65/R16, DOT Number: U96VH260H21. The contact stated while driving 35 MPH during a trip, the steering wheel started shuddering. The vehicle was taken to a tire shop, and the contact was informed that the two front tires had sustained tread belt separation and bulges. The two front tires were replaced. Additionally, the contact stated while driving 65-70 MPH, the TPMS warning light illuminated. The vehicle was taken to the tire shop, and the contact was informed that the rear passenger's side tire had sustained tread belt separation, and the metallic belt was poking through the rubber. The contact requested that the rear tires be replaced as a precautionary measure. The rear tires were replaced. All four tires were replacement tires. The dealer and the manufacturer were not notified of the failure. The vehicle failure mileage was 173,414. The tire failure mileage was approximately 16,022. The VIN was not available.

NHTSA ID

11680059

Incident

Jul 31, 2025

Mileage

173,414 mi

I am contacting you regarding Toyota Warranty Enhancement Program – ZE6. This concerns sticky and cracking dashboard and glare from this. I had no idea this existed. I own a 2006 and a 2010 sienna. I have not received any mailers from Toyota regarding either Sienna's . My van's dashboards are included in this program. Problem is, I never received notice from Toyota about either dashboard. Is there anything that can be done about this?

NHTSA ID

11610775

Incident

Aug 24, 2024

The contact owns a 2006 Toyota Sienna. The contact stated that while the vehicle was parked, the liftgate was opened and raised; however, the liftgate failed to remain open and raised as intended. The contact stated that when the liftgate was raised, the liftgate independently fell due to faulty liftgate struts. The vehicle was not diagnosed or repaired by an independent mechanic. The manufacturer was made aware of the failure but provided no assistance. The contact was advised to report the failure to the NHTSA Hotline. The failure mileage was unknown. The VIN was unavailable.

NHTSA ID

11608315

Incident

Aug 1, 2024

My vehicle steering/control has frozen a few times in the past 18-24 mos. This happens for me in wet conditions at slow speeds while trying to turn, usually to the right. The car also seems to slow on its own and pull to the side at these times. This has also happened while reversing out of a parking spot. I do not recall seeing any lights engage but I am more focused on steering the car safely and exterior factors at these times so I haven't noticed the dashboard. It feels like the power steering fails, and I have no control. Thankfully, I have not been moving at high rates of speed, nor been in a position to go into the lane of on-coming traffic or had someone in a lane near me, and have been able to hold in position or manually turn as much as needed. Steering seems to return once the turn is complete. I have been fearful of hitting someone or being hit from behind each time. My mechanic has been unable to recreate the experience and was unable to suggest a direct answer. I see others have had similar experiences and the same lack of answers from even Toyota. Having come across this website and seeing responses here to this exact problem I have had, I am hoping for more information or a recall soon!

NHTSA ID

11576496

Incident

Mar 10, 2024

Bought the van used last year. Previous owner said mechanic could not diagnose the issue. On slight curves similar to on-ramps while accelerating the Vehicle stability control (VSC) will engage unexpectedly, sound an alarm and jerk the steering wheel. Some times to the point of pulling the vehicle out of its lane. Road speed is decreased dramatically as it feels as though the ABS is engaging. This has happened to me at least half a dozen times since June 2023. The condition will continue for maybe five or ten seconds until the wheel is straightened and speed reduced. Searching the Internet seems it's a fairly common problem. The fix might be to replace the steering rack or disable the VSC system. It's reported by those experiencing the issue get little to no help from the dealerships which strikes me as quite strange... From what I've read it seems to affect 2004-2009 Siennas

NHTSA ID

11548154

Incident

Jun 1, 2023

The bushing for the gear shift is broken causing the lever to disconnect from the cord preventing the vehicle from shifting gears. This caused the vehicle to become stuck in reverse. The car was stuck in reverse when attempting to shift to drive, nearly causing my wife to crash into another vehicle. There are multiple videos on YouTube demonstrating this problem, it is a known issue. The vehicle/component has not been manufactured. No warning lamps, messages or other symptoms.

NHTSA ID

11544413

Incident

Sep 13, 2023

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.