2010 Toyota Sienna

[XXX] [XXX] / [XXX] [XXX] 2010 Toyota Sienna Possible Shifter Interlock Failure: On [XXX] my [XXX] child found his way into the driver’s seat of our 2010 Toyota Sienna while the vehicle was parked in the driveway. According to my wife, there were no keys in the vehicle, and the vehicle was in park. In an instant, my wife (who was outside the van) helplessly observed the van begin to roll backward down the driveway and then across the sidewalk (on our side of the street), then across the street, and then across the sidewalk on the other side of the street and into the neighbor’s yard where it finally came to a rest. She said she heard something like grinding gears. I presume my son was trying to put it in park. Thankfully no property damage or personal injuries occurred during the incident. I [XXX] ) was not home when this happened. When I returned home, I inspected the van to see if my son was able activate the emergency shift lock release. I found the cover was intact and evidence of tampering was not observed. I then checked to see if I was able to pull the shifter out of park. Initially, I was unable to, but after a few tries and a little force, I was able to pull the shifter out of park (no keys in ignition, no brake compression, vehicle off) and the van began to roll. Our driveway is somewhat sloped. I replicated this procedure several times: a little force and a little wiggle and clunk, the shifter released and the van rolled. I discovered there was a recall for this very problem on 2010 Sienna’s (NHTSA Recall No.: 17V-657). I entered the Sienna’s VIN number on NHTSA’s website and found no active recall for the VIN number entered. I contacted Toyota of North America (1-800-331-4331) and chose to advocate and spoke to an agent and reported the problem. She was able to determine that the vehicle had been under the recall, but the van was “repaired” in 2020 which is the year we bought the van INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11733508

Incident

Apr 11, 2026

We recently had a full diagnostic check done on our vehicle (199 point at Parkway Automotive in Little Rock, Arkansas) that listed some components in need of repair. The only part involving the electrical system needing repair was our battery which was testing as no longer holding enough charge. We took the vehicle to Sam's Club in North Little Rock, AR within the last 2-3 weeks and had the battery replaced with a new Duracell with 3 year warranty. We drove away with no issues with the vehicle and used it for local driving without issues for those 2-3 weeks. The morning of Thursday, December 29, 2022 we started the car to drive to our church about 2 miles away with our four young children (1, 5, 8, 10). In the short drive, dash lights were flickering and the nav/audio screen system was turning off and restarting. Upon arrival at the church, as we were parking the car, gray smoke began to come from the hood quickly. The children were all still strapped in seatbelts and carseat, so we quickly unloaded them from the car and took them inside the building. While we were unloading them from the vehicle we observed the following: -black smoke pouring from driver's side hood -sparks falling on the ground from driver's side engine compartment, near bumper -spurts of fire coming from the hood and below the bumper on driver's side -charring and melting coming from the vents/lights where each child was seated in the 2nd and 3rd row seating After calling the fire department and locating a fire extinguisher, the fire quickly grew into an uncontrollable blaze so we all went inside the building as quickly as possible to avoid injury. Shortly thereafter, the battery itself seemed to explode (a loud explosion was heard and then a smaller one) and the driver windshield was blown. The fire was large enough to seem to be traveling toward the gas tank and we were afraid of a big disaster. The fire department then arrived and extinguished the fire and made a report.

NHTSA ID

11499914

Incident

Dec 29, 2022

Massive Oil Leak and Loss of Oil Pressure: Oil line burst while driving on the HWY coming back home from a work. Loss nearly all of the oil, but there were no warning lights. Pulled over into gas station. Checked dip stick, completely dry! Catastrophic oil leak without warning. Could have been stalled on the HWY and caused major ACCIDENT. Tried to refill oil but it all leaked out as soon as I started engine. Research around the web and find out that this is a known issue to Toyota for using rubber VVTI oil line - Part # 15772-31030 Now this part is made all metal!

NHTSA ID

11492041

Incident

Nov 1, 2022

The contact's father owned a 2010 Toyota Sienna. The contact stated while his father was driving to the hospital at 30-40 MPH for a medical emergency, he lost consciousness. The vehicle crashed into a steel fence. The air bags failed to deploy. The contact's father was transported to the hospital by emergency units where it was diagnosed that he had sustained a broken neck, which made it impossible for the medical personnel to treat him. The contact's father deceased while in the hospital. A police report was filed. The vehicle was towed to a tow yard where it was totaled. The dealer was not notified of the failure. The manufacturer was not notified of the failure. The failure mileage was unknown.

NHTSA ID

11465982

Incident

Mar 27, 2022

The contact owns a 2010 Toyota Sienna. The contact stated while driving approximately 15-20 MPH, the vehicle stalled inadvertently. The check engine warning light, the traction control warning light, and other unknown warning lights illuminated. Additionally, the contact stated that the steering wheel lost power steering functionality. The contact was able to veer to the side of the road. The contact stated that the vehicle failed to restart while in Park; however, the vehicle restarted when he shifted into Neutral. The contact drove the vehicle to his residence. The dealer was not notified of the failure. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and informed the contact that they could not assist as there were no open recalls associated with the failure. The failure mileage was approximately 115,000.

NHTSA ID

11456022

Incident

Mar 9, 2022

Mileage

115,000 mi

One day when we tried to buckle the driver's side seat belt, little pieces flew out of the receiver side and it will no longer buckle. We took it to the Toyota dealer in N Syracuse NY and were told it would be a cost of $212 to replace and that it would be a two-week wait for the part to come in. This means that the owner and her two young babies would have to drive in an unsafe car, ILLEGALLY for two weeks putting her life and the life of her children in danger. The Toyota dealer inspected the seat belt and confirmed it was a defect and had failed. I called Toyota customer service and was told that there were no recalls for this defect and they would take no responsibility for the dangerous situation or consequences because the car was no longer under warranty. In fact, this is a problem that has been affecting many owners as indicated by an online search. Also, the fact that the dealer has to wait two weeks to obtain the part indicates that this seatbelt has failed many owners and they have used up the supply. This should be a recall situation but Toyota will take no responsibility.

NHTSA ID

11422816

Incident

Jun 27, 2021

THE DASHBOARD IS DEFECTIVE. TOYOTA ACKNOWLEDGE THIS DEFECT, AND ISSUES A FREE REPLACEMENT. HOWEVER, TOYOTA CLAIMS THE WARRANTY PERIOD HAS EXPIRED, AND WILL NOT REPLACE MY DASHBOARD. DUE TO COVID 19 LOCKDOWN, I DID NOT GET IT FIXED EARLIER, AND WAS NOT AWARE THAT RECALLS HAVE EXPIRING AN EXPIRING DATE.

NHTSA ID

11365075

Incident

Oct 6, 2020

DASHBOARD HAS RECENTLY BECOME STICKY EVEN THOUGH WIINDSHIELD IS ROUTINELY COVERED.

NHTSA ID

11363691

Incident

Sep 15, 2020

Mileage

166,152 mi

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.