2001 Toyota Sienna

A KNOWN ISSUE WITH THESE 3.0 L V6 ENGINE. HEAVY SMOKE FROM THE EXHAUST PIPE. VISIBLE OIL SLUDGE UNDER THE OIL REFILL CAP.

NHTSA ID

11402825

Incident

Mar 13, 2021

Mileage

75 mi

THE DRIVER'S SIDE REAR SLIDING DOOR HAS SEVERAL TIMES NOW REFUSED TO LATCH, AND WHEN IN EMERGENCY SITUATION I HAVE LOCKED IT AND FORCED IT TO SHUT THEN IT WILL NOT UNLOCK AND IT HAS TO BE TAKEN APART TO BE OPENED AND THE WHOLE LATCH AND LOCK MECHANISM REWORKED BY THE MECHANIC, AND IN THE MEANTIME THE DOOR IS UNABLE TO BE OPENED WHICH IS EXTREMELY UNSAFE WHEN I HAVE CHILDREN IN THE MIDDLE AND BACK ROWS OF THE VAN. THIS IS THE THIRD TIME IN THE PAST 3 YEARS THAT THIS PROBLEM HAS OCCURRED, SO IT IS DEFINITELY AN ACTUAL PROBLEM WITH THE HARDWARE OF THE DOOR LATCH MECHANISM ITSELF AND NOT SIMPLY A GLITCH THAT OCCURRED ONCE OR SOMETHING.

NHTSA ID

11098879

Incident

May 24, 2018

Mileage

147,000 mi

MY 9 YEAR OLD SON AND I WERE ON OUR WAY HOME FROM WORK LAST NIGHT AND I HEARD SOMETHING SNAP ON MY 2001 TOYOTA SIENNA. I THEN HEARD SOMETHING DRAGGING SO I IMMEDIATELY PULLED OVER TO CHECK AND REALIZED THE FUEL TANK WAS DRAGGING AND THE BACK STRAPS HOLDING THE GAS TANK UP HAD BROKEN LOOSE CAUSING THE BACK SECTION OF THE TANK TO DRAG ON THE ROAD. I HAD TO CALL A TOW TRUCK TO TOW VEHICLE TO THE MECHANICS. SINCE I WORK 18 MILES AWAY I FIND GETTING TO WORK DIFFICULT.

NHTSA ID

11000310

Incident

Jun 19, 2017

Mileage

154,000 mi

I HAD JUST DROPPED MY YOUNGEST DAUGHTER OFF AT SCHOOL AND AS I WAS LEAVING I HAD TO STOP BECAUSE SOME CHILDREN WITH THEIR PARENTS NEEDED TO CROSS IN FRONT OF ME I APPLIED MY BRAKES AS NORMAL AND I HAD NO ISSUES IN STOPPING BUT THEN IT FEELS LIKE A "GHOST" PUSHES THE GAS PEDAL DOWN BECAUSE I CAN FEEL IT MOVE AND SEE MY RPM GAUGE GO UP AND I HEAR MY ENGINE "VRRRROOOMMMM" I PUSHED MY BRAKES HARDER AND STILL NOTHING, THE END RESULTS ME HAVING TO PUT MY CAR INTO PARK TO KEEP IT FROM MOVING INTO THE CROSSWALK ONTO THE PEOPLE. WHEN I GET HOME IT DOES THE SAME THING AND I ALMOST CRASH INTO MY GARAGE BECAUSE THE CAR IS ACCELERATING ON ITS OWN AND AGAIN. IT WOULD ALWAYS HAPPEN AT RANDOM, AFTER I WOULD LET GO OF THE BRAKES ITS ALREADY MOVING FAST AS IF MY FOOT IS ON THE GAS, I SAY TO MY PASSENGER WHICH IS MY WIFE "LOOK THE VAN IS GOING ON IT'S OWN, I'M NOT EVEN PUSHING THE GAS" THE VAN WAS MOVING PRETTY FAST, BUT FAST ENOUGH FOR THE FLOW OF TRAFFIC FROM A STOP AND GO MOVEMENT. I NO LONGER DRIVE THE VAN BECAUSE I AM SCARED THAT I AM GOING TO GET INTO AN ACCIDENT AND I DON'T WANT THAT TO HAPPEN. NO CHECK ENGINE LIGHT IS ON I EVEN HAD THE VAN CHECKED FOR CODES AND NOTHING CAME UP.

NHTSA ID

10905861

Incident

Aug 30, 2016

Mileage

160,000 mi

TAKATA RECALL. WHITE SMOKE COMES OUT OF THE EXHAUST WHEN I START THE CAR. THEN SMOKE DISAPPEARS OR STAY AT LOW LEVEL DURING DRIVING. DECREASE OIL. I PUT ONE QUARTER OIL EACH WEEK. MECHANICS SAYS IT MAY HEAD GASKIT OR SEALS. COSTS 2000 AND ABOVE TO REPAIR. IF NOT BETTER TO GARBAGE THIS VEHICLE. IT HAS A CLEAN TITLE WITH 106K.

NHTSA ID

10893839

Incident

Dec 15, 2015

THE SEAT BELT PRETENSIONER WAS FAULTY AND NOT WORKING PROPERLY. IT STOPPED THE SRS DEPLOY AND HAVE THE AIRBAG LIGHT ON.

NHTSA ID

10875380

Incident

Jun 3, 2016

Mileage

90,000 mi

THE HORN ON THE SIENNA WORKS INTERMITTENTLY. THIS IS A VERY UNSAFE SITUATION WHEN DRIVING AS A HORN COULD POSSIBLY PREVENT AN ACCIDENT WITH A CAR OR PEDESTRIAN. FIRST HAD THE PROBLEM IN 2014, BUT WHEN WE BROUGHT IT TO TOYOTA, IT WOULD WORK, SO THEY COULDN'T CHECK IT OUT. IN APRIL 2015, THEY FINALLY THOUGHT IT WAS A DEFECTIVE SPIRAL CABLE, SO THEY REPLACED IT, TO THE TUNE OF $400+. THREE DAYS LATER, WE HAD THE PROBLEM AGAIN. WEREN'T ABLE TO BRING IT BACK UNTIL RECENTLY. REPLACED SPIRAL CABLE AGAIN. PROBLEM RETURNED BEFORE THE CAR MADE IT HOME. VEHICLE IS BACK IN SHOP. I BELIEVE THEY SAID THEY ARE REPLACING THE HORN PAD ASSEMBLY, WHICH WILL COST ANOTHER $150 FOR THE PART. THEY ARE NOT CHARGING FOR LABOR AS IT IS UNDER A 1 YEAR SERVICE WARRANTY. FOUND OUT TODAY A COWORKER HAS A SIMILAR PROBLEM WITH A 2005 SIENNA. I GOOGLED, "PROBLEMS WITH SIENNA HORN" AND FOUND MANY PEOPLE WITH THE SAME PROBLEM. WHY HAS THERE NOT BEEN A RECALL AS THIS IS CLEARLY A SAFETY ISSUE. I FEEL THAT MAYBE THERE HAS NOT BEEN ANY SERIOUS ACCIDENTS ATTRIBUTED TO THIS PROBLEM AND SO IT'S "FLOWN UNDER THE RADAR", SO TO SPEAK.

NHTSA ID

10865275

Incident

Oct 14, 2014

Mileage

118,203 mi

HORN WILL NOT WORK IN THE RAIN OR WHEN YOU DRIVE IN WATER. IT TAKES ABOUT A DAY FOR THE HORN TO DRY OUT FOR THE HORN TO WORK AT ALL. PEOPLE COULD GET KILLED WHEN THE HORN WILL NOT WORK IN THE RAIN OR WATER. TOYOTA NEEDS TO HAVE A RECALL NOW TO SAVE THE LIVES OF MILLIONS OF MEN, WOMEN AND CHILDREN IN THE USA.

NHTSA ID

10861483

Incident

Jan 15, 2016

Mileage

142,112 mi

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.