2013 Dodge Charger

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

On April 22, 2016, Fiat Chrysler Automotive US LLC, (FCA) submitted a Defect Information Report (DIR) to NHTSA regarding a defect that could result in unattended vehicle rollaway with the engine running in approximately 811,586 model year (MY) 2012 to 2014 Dodge Charger and Chrysler 300 vehicles and MY 2014 to 2015 Jeep Grand Cherokee vehicles equipped with 8-speed transmissions and a monostable gear selector (NHTSA Recall #16V-240, FCA Recall #S27). According to FCA's DIR, The existing strategies built into these vehicles to deter drivers from exiting the vehicle after failing to put the transmission into PARK have not stopped some from doing so. Drivers erroneously concluding that their vehicle's transmission is in the PARK position may be struck by the vehicle and injured if they attempt to get out of the vehicle while the engine is running and the parking brake is not engaged.The vehicles recalled by FCA are equipped with Monostable electronic (shift-by-wire) gearshift assemblies supplied by ZF Group (see Figure 1).The subject Monostable shifter has a single neutral position that it snaps back to when the driver releases the shift knob.Although the Monostable gearshift has the familiar appearance of a conventional console mechanical gearshift assembly, it has an unfamiliar movement that does not provide the tactile or visual feedback that drivers are accustomed to receiving from conventional shifters.Consequently, the driver must take additional time to verify that the desired gear position was achieved by checking the PRNDL display on the shift knob or the Electronic Vehicle Information Center (EVIC) display.

A few weeks ago I was traveling on unfamiliar curvy roads. It had recently rained. I fishtailed going through the curve, and my breaks locked up. Not long after I had the famous “Christmas Tree Lights” on my dash which are the ABS, Break, and FCW. Went to Advance Auto Parts to check code, and it was C2200-49. Took to dealership and paid $200+ to learn the same. They quoted $1955 alone for the ABS Control Module because the part was discontinued by Mopar in 2025. Took to an independent shop for a recheck, and they confirmed they could not fix it because they couldn’t guarantee an added part would work since they were discontinued. I haven’t driven the vehicle for a month, and I’m wary of buying a remanufactured part on eBay. I researched and found the code is a processor failure pandemic on 2011-2014 models, and there was a massive national level backorder even before the part was discontinued. Mopar & Dodge need to make this right with a safety recall. My research shows it is unsafe to drive! Please help!! A recall was issued for Dodge Ram Trucks! 2013 Dodge Charger SXT with adaptive cruise control should be added. Thank you for your time!

NHTSA ID

11755399

Incident

Jul 2, 2026

The contact owns a 2013 Dodge Charger. While attempting to make a right turn, the brake pedal was depressed, and the brake pedal became firm. To avoid crashing with the vehicle ahead, the contact veered out of the lane and the parking brake independently activated and the vehicle jerked to a stop with the parking brake warning light illuminated. The vehicle was coasted to the shoulder and was later towed to a dealer to be diagnosed. The dealer diagnosed the vehicle with brake booster failure and informed the contact that the brake booster needed to be replaced. The vehicle remained with the dealer unrepaired. The manufacturer was not notified of the failure. The failure mileage was approximately 140,000.

NHTSA ID

11745747

Incident

Jun 14, 2026

Mileage

140,000 mi

The abs module lights came on and is not functioning properly. I contacted the dealership and the part has been on back order for years. The abs light, traction, and brake light is on simultaneously. Subsequently my wheel is locked up causing my car to not move at all and brake pedal has no pressure.

NHTSA ID

11675779

Incident

Feb 20, 2021

Vehicle: 2013 Dodge Charger R/T I’m reaching out because my car has been showing signs that seem to match the symptoms of the V62 recall that FCA issued for the fuel pump relay issue. I have a 2013 Dodge Charger R/T with the 5.7L HEMI engine. Lately, the car has been having trouble starting, especially after it’s been driven and sits in the heat. Sometimes it cranks but won’t turn over, and other times it randomly dies or stalls when I’m coming to a stop. It recently sat for a couple of days and then started again like nothing happened. This keeps happening on and off, and I’ve noticed it’s worse when it’s really hot outside or after it’s been driving a lot I took it to the dealership and they said my specific VIN isn’t part of the recall, but I wanted to report this because it really seems like the same issue. From what I’ve read, the V62 recall had to do with a faulty fuel pump relay that’s built into the TIPM and causes exactly these kinds of problems. I understand not all vehicles were included, but since I’m having the same symptoms and my car matches the year, make, and engine that recall applied to, I think it’s something that should be looked into. I’d really appreciate it if this could be reviewed. I just want to make sure my vehicle is safe and functioning properly, especially since the stalling can be risky depending on where and when it happens.

NHTSA ID

11673932

Incident

Jul 16, 2025

Anti-lock brake system and stability control system control module has failed and replacement parts have been unavailable. (For over a year me dealer has said.)

NHTSA ID

11636271

Incident

Aug 1, 2014

The "Vehicle Not in Park" warning message is a safety feature designed to prevent accidents and injuries. It's a standard safety feature in most modern vehicles, including the Dodge Charger. Here's what it's intended to do: When the vehicle is shifted out of Park (P) and the transmission is not fully engaged, the system will display a "Vehicle Not in Park" warning message on the dashboard. This message is triggered by the vehicle's Transmission Control Module (TCM) or Electronic Stability Control (ESC) system, which monitors the vehicle's gear position and transmission status. The purpose of this warning is to alert the driver that the vehicle is not properly secured and may roll or move unexpectedly, potentially causing an accident or injury. This can happen when: The parking brake is not engaged: If the parking brake is not fully engaged or is released before shifting into gear, the system will detect this and display the warning message. The transmission is not fully engaged: If the transmission is not fully engaged in gear, such as when shifting from Park to Reverse or Drive, the system will detect this and display the warning message. The vehicle is not properly positioned: If the vehicle is not properly positioned on a level surface or on a slope, the system may detect this and display the warning message. To resolve the "Vehicle Not in Park" issue on your Dodge Charger: Ensure the parking brake is fully engaged. Check that the transmission is fully engaged in gear (e.g., Park, Reverse, Drive). Make sure the vehicle is properly positioned on a level surface or adjust it to a flat surface. The car is in park but will not turn off instead it runs until it decides it wants to turn off which can take several hours. This is a safety concern and issue that needs to resolved we pay to much money on these vehicles to deal with crappy problems due to bad mechanical issues and features

NHTSA ID

11603558

Incident

Jul 19, 2024

The contact called on behalf of a customer who owns a 2013 Dodge Charger. The contact who is an independent mechanic, stated that the vehicle was driven to his place of business; however, upon arrival the vehicle was smoking with an abnormally strong fuel odor. The contact stated upon inspecting the vehicle, the contact became aware that the fuel pump was dry, and fuel was leaking onto the ground from the side of the fuel tank. The contact stated that upon removal of the exhaust, the contact became aware that fuel was leaking from the exhaust pipe. The contact stated that when the muffler was removed, there was fuel pouring out of the muffler. Additionally, the contact stated that there was a hole in the heat shield and the fuel tank. The contact stated that the vehicle had two mufflers and no resonators installed. The contact stated that the fuel tank, muffler, exhaust pipe, and heat shield needed to be replaced. The vehicle was currently being repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 168,237.

NHTSA ID

11602282

Incident

Jul 11, 2024

Mileage

168,237 mi

The contact owns a 2013 Dodge Charger. The contact stated while driving at undisclosed speeds, the lifters were making an abnormal tapping sound. There were no warning lights illuminated. The contact called the local dealer and was informed that there was no recall coverage for the failure. The mechanic determined that the tapping sound was due to the lifters, which were causing excessed wear on the camshaft. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The approximate failure mileage was 145,000.

NHTSA ID

11601583

Incident

May 1, 2024

Mileage

145,000 mi

The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

AIR BAG - SIDE CURTAIN

LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.

LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.