2009 Ford Focus

incident [XXX], Parking in front of Physical Therapy clinic, suddenly the motor revved and car shot across the sidewalk and went through the wall of the clinic. No one was there and no one was hurt. Insurance was notified. (Hartford) Googling Auro malfunctions for Ford Focus, I come across several things which could have malfunctioned and caused "unpredictable acceleration. Car had within 2 weeks had been to automotive shop for maintenance. I think this was a serious malfunction and should have been noticed. thanks, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11739783

Incident

Apr 20, 2026

Rocker panels rust out and cause the lifting points on the car unable to be used. Mechanics refuse to work on my car due to not being able to lift the vehicle per manufacturer lifting points.

NHTSA ID

11549212

Incident

Oct 10, 2023

The contact owns a 2009 Ford Focus. The contact stated while parked in the driveway, the contact opened both rear doors; however, while attempting to close the doors, the doors failed to latch securely. No warning light was illuminated. The vehicle was taken to an independent mechanic to be diagnosed. The mechanic determined that the latch was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was unknown.

NHTSA ID

11541362

Incident

Aug 3, 2023

The contact owns a 2009 Ford Focus. The contact stated while driving 35 MPH, the contact felt the front passenger’s side brake was seizing. The contact stated there was smoke coming from the brakes. There was no warning light illuminated. The contact pulled over on the side of the road and waited for the vehicle to cool down and the vehicle started operating normally. The vehicle was not diagnosed. The contact had the brakes replaced; however, the failure reoccurred. The manufacturer was not contacted. The failure mileage was 80,000.

NHTSA ID

11532153

Incident

Feb 8, 2021

Mileage

80,000 mi

My car started to rough idle, when I go to press the gas pedal there is no rev or acceleration or anything. It came up with a code for the throttle body and had it replaced and it worked fine for a while and then it happened again, so I replaced the throttle body again and it started happening right away again. This has happened at 80 MPH and almost caused an accident! I just want this to be understood, and I am not the only other person having this issue!!

NHTSA ID

11432987

Incident

Aug 18, 2021

The contact owns a 2009 Ford Focus. The contact stated that the vehicle failed to start-up after multiple attempts without warning. The contact initially took the vehicle to an independent mechanic and the ignition switch and housing were replaced. A few months later, the failure recurred, and the contact took the vehicle back to the same mechanic and had the starter replaced. A few months later after the repair, the failure recurred, and the contact took the vehicle to another independent mechanic who replaced the ignition switch and housing for a second time. After the failure occurred for the fourth time, the initial independent mechanic instructed her to place the vehicle in neutral to see if the restarted. The vehicle was started in neutral and the mechanic replaced the neutral safety switch. Despite the repair, the failure recurred. A dealer was notified of the failure and a representative acknowledged that the failure was a known issue; however, there were no recall for the failure. The manufacturer was also notified of the failure and the contact was provided the same information as the dealer. The manufacturer was then referred to the NHTSA for assistance. The vehicle was not repaired. The failure mileage was approximately 170,000.

NHTSA ID

11428924

Incident

Jul 1, 2019

Mileage

170,000 mi

THE FUEL PUMP KEEP DISABLING! WHEN TRYING TO CRANK THE CAR IT WILL CONTINUE TO TURN OVER AFTER THE KEY HAS BEEN PULLED BACK OUT OF THE START POSITION

NHTSA ID

11349109

Incident

Aug 11, 2020

Mileage

130,000 mi

TL* THE CONTACT'S SON OWNS A 2009 FORD FOCUS. THE CONTACT SON STATED THAT WHILE DRIVING AT VARIOUS SPEEDS, THE VEHICLE LOSS MOTIVE POWER WITHOUT WARNING. THE VEHICLE WAS JUMP STARTED AND RESUMED NORMAL VEHICLE OPERATION. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC TO BE DIAGNOSED. THE CONTACT WAS INFORMED THAT THE IGNITION SWITCH NEEDED TO BE REPLACED. AN UNKNOWN DEALER WAS CONTACTED HOWEVER, NO ASSISTANCE WAS PROVIDED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS INFORMED OF FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 122,827.

NHTSA ID

11330138

Incident

Jun 19, 2020

Mileage

122,827 mi

Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k

All accessory stick-on keyless entry keypads come with a wallet card containing the master code. If the accessory keypad was factory installed, this card will be placed in the glove box and should be handed to the vehicles owner during initial delivery. Unlike the integrated (wired) factory keypad, the accessory keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool. If the wallet card for an accessory keypad is lost, follow these steps to recover the code. Dealer Key Code access is granted through the Dealer Program Enrollment System (DPES); dealership management can authorize users. The authorized user must go to FMCDealer.com > Parts and Service > Parts Product Line Information > Keys/Entry Devices > Aftermarket Keyless Entry Keypad Code Access. Follow the instructions on the screen to obtain the master code for the accessory keypad.

The Accessory (Wireless) Keyless Entry Keypad can only be used with vehicles that are factory built with Remote Keyless Entry (RKE). The master code for the Accessory (Wireless) Keyless Entry Keypad can be retrieved from FMCDealer - Parts and Service - Parts Product Line Information - Keys/Entry Devices - Aftermarket Keyless Entry Keypad Code Access. Access to this site is granted through Dealer Program Enrollment System (DPES) and Dealer Principal, General Manager or Parts and Service Director can authorize users. Once authorized the retrieval process for master code can be obtained. The master code for the Accessory Keyless Entry Keypad cannot be retrieved from the body control module(BCM) with a diagnostic tool.

The Accessory (Wireless) Keyless Entry Keypad can only be used with vehicles that are factory built with Remote Keyless Entry (RKE). The master code for the Accessory (Wireless) Keyless Entry Keypad can be retrieved from FMCDealer - Parts and Service - Parts Product Line Information - Keys/Entry Devices - Aftermarket Keyless Entry Keypad Code Access. Access to this site is granted through Dealer Program Enrollment System (DPES) and Dealer Principal, General Manager or Parts and Service Director can authorize users. Once authorized the retrieval process for master code can be obtained. The master code for the Accessory Keyless Entry Keypad cannot be retrieved from the body control module(BCM) with a diagnostic tool.

REPLACING THE ORIGINAL EQUIPMENT SYNC/NAVIGATION SYSTEM WITH EITHER AN AFTERMARKET SYNC/NAVIGATION KIT OR MODIFYING ORIGINAL SYNC/NAVIGATION PARTS TO PROVIDE ADDITIONAL FEATURES IS NOT RECOMMENDED NOR SUPPORTED ON ANY FORD, MERCURY OR LINCOLN VEHICLE. ONLY APPROVED GENUINE FORD ACCESSORIES OR ORIGINALLY INSTALLED SYSTEMS ARE SUPPORTED AND CERTIFIED TO FUNCTION CORRECTLY WITH OTHER VEHICLE SYSTEMS. IF YOU SUSPECT A SYSTEM HAS BEEN MODIFIED, THE FOLLOWING RESOURCES CAN BE USED TO VERIFY ORIGINAL EQUIPMENT: MONRONEY LABEL (WINDOW STICKER), PROFESSIONAL TECHNICIAN SOCIETY (PTS) OASIS TAB  SELECT SYNC OR HVBOM. FOR GENUINE FORD ACCESSORIES USE: PTS WORKSHOP TAB  SELECT DEALER INSTALLED ACCESSORY OR ACCESSORY INSTALLATION.

SOME 2008-2017 FORD/MERCURY/LINCOLN VEHICLES EQUIPPED WITH SYNC MAY GENERATE A VHR THAT IDENTIFIES A CONCERN WITH THE BRAKES AND SUSPENSION CATEGORY INDICATING SERVICE IS REQUIRED DUE TO A BRAKE SYSTEM WARNING LAMP BEING ILLUMINATED. IF THE PARK BRAKE WAS APPLIED WHEN THE VHR WAS GATHERING DATA FROM THE MAJOR VEHICLE SYSTEMS, THE BRAKES AND SUSPENSION MESSAGE WILL BE REPORTED AS THE VHR LOOKS FOR ANY WARNING LAMPS ILLUMINATED IN THE INSTRUMENT CLUSTER. RERUN THE VHR WITH THE ENGINE ON AND VEHICLE IN PARK, AND ENSURE THE PARK BRAKE IS DISENGAGED. IF THE SYNC VHR IS STILL REPORTING A CONCERN TO THE CUSTOMERS SYNC OWNERS ACCOUNT, REFER TO THE APPROPRIATE WORKSHOP MANUAL SECTION FOR DIAGNOSIS BY DTC OR SYMPTOM. STARTING IN 2015 NOT ALL SYNC EQUIPPED VEHICLES SUPPORT VHR, REFER TO THE OWNERS MANUAL FOR VHR OPERATION.