2009 GMC Sierra 1500

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.

This letter serves as a formal notice of concern and demand for accountability regarding the 2009 GMC Sierra LD, VIN [XXX] , owned by [XXX] . There are numerous documented complaints and safety investigations concerning premature tie rod failure in 2009 GMC Sierra models. While the 2009 model year may not have been subject to a sweeping, industry-wide recall specific to tie rods in the 1500 series, it is undeniably and consistently associated with premature steering component failure — including both inner and outer tie rods. The refusal to proactively address this defect, assign a broader recall, or take ownership of the recurring issue reflects a troubling disregard for consumer safety. Documented and Reported Issues Include: • Premature Wear: Tie rods becoming loose or failing between 50,000–100,000 miles, resulting in steering wander and excessive play in the steering wheel. • Clunking/Knocking Noises: Audible front-end knocking at low speeds, a well-known symptom of failing tie rod joints. • Severe Safety Risk: Instances where tie rods have separated or become dangerously compromised, directly affecting steering control. • Uneven Tire Wear: Excessive inner or outer tire edge wear caused by steering instability. • Recall 14V-246000: A related recall acknowledging improper tightening of tie rods where they thread into the steering gear rack — a defect that could cause separation and loss of steering control. The common symptoms — steering vibration, looseness, clunking when turning, and vehicle pulling due to misalignment — are not minor inconveniences. They represent serious safety hazards that endanger drivers, passengers, and the public. It is unacceptable for GMAC and General Motors to minimize or compartmentalize this issue when patterns clearly demonstrate a systemic steering component weakness in this model year. The presence of Recall 14V-246000 further demonstrates that the manufacturer was aware of tie rod-related risks ! INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5

NHTSA ID

11717359

Incident

Jan 4, 2026

Early October my passenger side airbag deployed and I was sitting in the drivers seat and had just put the key into the key hole but did not turn the key to start the vehicle. 3 weeks later I was going into the passenger side of the vehicle and the key was in my pocket and the drivers side airbag deployed. Both times the vehicle was not started and the airbags deployed I called GMC and they had the vehicle towed to a dealer to investigate why the airbags deployed. They said it was a sensor that was corroded and that’s why the airbags deployed. I asked GMC, why didn’t the sensor left the driver know that it was going bad, just like it notifies the driver if you have low tire pressure or needs an oil change. I had no notifications that the airbags were going to deploy. I’m so grateful that no one was driving the vehicle when they deployed. GMC said the vehicle is not safe to drive so they had it towed from my house to the dealership and then back to my house however they said they are not taking responsibility for the deployment and said it’s my responsibility to get the airbags fixed. I told GMC that I was filing a complaint with you all. Thank you for looking into this matter.

NHTSA ID

11697435

Incident

Oct 3, 2025

The contact owns a 2009 GMC Sierra 1500. The contact stated that while driving at highway speeds, the vehicle hesitated while depressing the accelerator pedal. The traction control and check engine warning lights were illuminated. The contact used a code reader and discovered a misfire in cylinder #4, and performed a compression test, which verified that cylinder #4 was failing to maintain compression. The vehicle was taken to a dealer where it was discovered that there was a failure with the lifter in cylinder #4. The vehicle was not repaired and remained with the dealer for additional diagnostic tests. The manufacturer was notified of the failure but offered no assistance. The contact was referred to the NHTSA Hotline to report the failure. The failure mileage was approximately 56,000.

NHTSA ID

11681424

Incident

Jul 8, 2013

Mileage

56,000 mi

To Whom It May Concern, I am submitting this report regarding repeated engine and valve lifter failures in my 2009 GMC Sierra 1500 with a 5.3L V8 engine, VIN: [XXX] . 1. Component/System Malfunctioned: Both the original engine and a replacement engine—professionally installed by a Chevrolet dealership—experienced valve lifter failure related to the Active Fuel Management (AFM) system. The most recent failure was sudden and unexpected. The engine may be available for inspection upon request. 2. Safety Risk: Engine failure puts driver and passenger safety at serious risk, particularly if the vehicle loses power unexpectedly while in motion. In both instances, the failure created unsafe driving conditions. 3. Reproduction/Confirmation: The issue was confirmed by a Chevrolet dealership during the initial engine failure and again more recently on the current engine, which is now exhibiting the same failure. 4. Inspection Status: The vehicle has been inspected by the same dealership that performed the original engine replacement. To my knowledge, it has not been inspected by GM corporate, police, or insurance representatives. 5. Warning Signs: There were no warning lamps, messages, or clear symptoms prior to the failure. The problem occurred without advance notice and did not provide an opportunity to address it before damage occurred. This is the second engine failure my truck has suffered from the same issue, even after dealership installation of a new motor. I urge the NHTSA to investigate whether this represents a broader defect in GM 5.3L AFM-equipped engines. It is unacceptable that repeated critical failures can occur in these engines with no warning and no resolution, even after following proper replacement procedures. Thank you for your attention. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11667844

Incident

Jun 5, 2016

Allison transmission - random hard shifts, random multiple DTC's, random limp mode. Clear codes and works fine until it doesn't. Might have to clear codes 3-4 times a day or it might make it a week before it goes into limp mode again.

NHTSA ID

11647697

Incident

Jan 1, 2020

General Published an article about the Takata Airbag recall stating that the dashboard would be inspected prior to doing the recall work and if already cracked or damaged the dashboard would not be replaced. My dash board is like new with no damage or cracks. The dealer told me (contrary to this article) that if their service men damaged my dashboard while doing the recall replacement I would be responsible for any replacement even if my dashboard is in perfect condition prior to the work. I find this unacceptable and will not have my airbag replaced under these conditions. The dealer/GM should be responsible for any damage they cause during the repair.

NHTSA ID

11632137

Incident

Dec 23, 2024

TCM and electrical transmission grounded out TCM IN MY RESEARCH a lot of people are having issues with these. Dealers are of no help “backordered” so having to rebuild them. This is an expensive failure!

NHTSA ID

11564073

Incident

Dec 29, 2023

While driving on Saturday, July 29th, I went to make a right turn @ intersection of Nottingham Way onto Ledo Rd. The vehicle started jerking and suddenly shutoff. I had no power steering, No power brakes. I had to manually steer and stop the truck into the median, while avoiding oncoming traffic. I got the vehicle to stop. I tried to restart and the engine turned over, but would not start. I contacted the local Chevrolet dealership, and was told they don't work on anything older than 2013 vehicles. I had the truck towed to the house. After further investigation, there was a service bulletin 14515B, that replaced 14515A. The Safety recall stated CHASSIS ELECTRONIC CONTROL MODULE INTERNAL CONTAMINATION. So GM is aware of this issue, that could have caused an accident. The local dealership is denying that my truck is involved in this recall. They knew of the problem and never contacted me about this issue. This is a severe SAFETY issue. GM should be responsible for repairing a defective Control module as they knew of contamination as of January 2015. This almost cause multiple head on collisions.

NHTSA ID

11535542

Incident

Jul 29, 2023

New Vehicle Monitoring Programs Section in IVH

This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, B3935, C0750, C0755, C0760, C0765, and/or C0775.

This Preliminary Information communication provides information to the technician about vehicles that may have a bump feel or clunk noise at a stop or on launch. Dealer should communicate to the customer this condition is a normal operating characteristic

This PI communicates the requirement to provide a pico file to receive diagnostic assistance from TAC.

This service bulletin provides technicians with information on available BCM calibrations to restore bulb outage detection on vehicles produced by a second stage manufacturer (Upfitter), and/or turn signals flash fast after factory box removed.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.