2013 GMC Sierra 1500

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.

Failure of frame on left side of vehicle between frame rail and fuel tank. For a approx 10 year old vehicle that is garaged and does not drive in inclement weather this SHOULD NOT be happening.

NHTSA ID

11706633

Incident

Dec 22, 2025

The contact owns a 2013 GMC Sierra 1500. The contact stated that while having the vehicle inspected, the vehicle failed inspection due to the rear subframe being detached from rust. The contact stated that the failure was related to Technical Service Bulletin: 19-NA-255. The contact used the undercarriage wash due to residing in a snow and salt State. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 75,000. The VIN was not available.

NHTSA ID

11696358

Incident

Oct 28, 2025

Mileage

75,000 mi

On 9-12-25 I was pulling a utility trailer when I went to back it in the driveway my 2013 gmc 1500 5.3 stalled . I restarted it only to have a lifter claddering !!!! I checked the oil it was good ! Oil pressure was good not over heating . It is just the lifter!!!!!! After doing some investigating I found that this is a common problem with GM's 5.3 with the AFM system!!! Companies should be held accountable for fraudulent designs!!! This is Not the first time for GM screwing consumers!!! GM had a similar situation back in the 70s and 80s Cadillac!!!! I bought this truck from a GM Dealer with 67000 miles only drove it in 1 winter it now has 149900 miles!!!! 5 years !!! Change oil and filter every 3000-4000 miles ,use Mobile 5w- 30w !!!! I feel a recall should be made to hold GM Accountable for what they new was a problem but produced and Screwed consumers to make SALES !!!!!!!!!!!!! Ask any quality Repair facility that works on GM'S or Even Auto Parts personal. When it stalled it left me in the middle of the Road with traffic!!! Even if it did start right back up !! Clacking!! The cost is unbearable!!!!!!

NHTSA ID

11687166

Incident

Sep 12, 2025

DURING AN OIL CHANGE IN MAY I WAS INFORMED THAT MY FRAME WAS EXTREMELY ROTTED AND WAS IN JEOPARDY OF CRACKING IN HALF . THE FURTHER I DIG INTO THIS, I'M FINDING THAT GM IS AWARE OF THIS ISSUE. THE VEHICLE IS AVAILABLE FOR INSPECTION.

NHTSA ID

11670958

Incident

May 8, 2025

Roof rust at the windshield on a perfect condition vehicle. Paint is excellent on rest of vehicle. No damage or accidents and properly maintained. Premature rust is now visible at the roof of the of the vehicle. Soon could rot and allow water into cab of vehicle.

NHTSA ID

11624825

Incident

Nov 12, 2024

The frame on my 2013 GMC Sierra has a considerable amount of rust & corrosion on it, to the point of being a safety concern because it's actually rusted through to where there are holes rusted through the frame!!

NHTSA ID

11615420

Incident

Sep 19, 2024

I found out that the frame was rusted through beside the gas tank and was told there was a memo put out to the dealers that there was a problem with the frames not being coated properly and if the customer notice it they were to repair it. My truck was service regularly and undercoated regularly by the dealer the body is rust free but I am being told the frame is on safe and can't be repaired and GM will not make it right even though they knew there was a problem. I pull a travel trailer and if the frame was to break in half I am sure someone would be seriously hurt or killed.

NHTSA ID

11613418

Incident

Sep 1, 2024

I hit a bump and both rear shock mounts blew off the rear cross member because the frame is rusted out despite having rust protection. It is available for inspection. The truck then began bouncing wildly. Meanwhile the underside of the bed isn't rusted at all, not one speck. It just seems weird to me, reminds me of the Toyota frame problems from a while back. It has not been inspected by a mechanic or insurance, my insurance company didn't seem to care in the slightest. I have had traction control and abs warnings on for a while but my mechanic said that was a faulty tire sensor.

NHTSA ID

11609433

Incident

Aug 16, 2024

This preliminary information communicates information about how to determine if a wheel and tires size change is available.

This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This PI Communications information on an alternative product dealers can use to perform 19-NA-255: Wax Coating on Frame Peeling, Metal Shows Corrosion/Rusting due to issue with getting product from current supplier listed in the bulletin.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts that are being performed on customer’s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer complaint, contact General Motors Technical Assistance Center for further support. For any vehicles that remains unrepaired after being at the dealer for three days or more and a related bulletin or PI is not found, contact General Motors Technical Assistance Center for further support.