AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
2010 GMC Sierra 3500
Recalls, owner-reported complaints, investigations and safety data
Data refreshed
Overview
Our database contains 2 NHTSA owner-reported complaints for the 2010 GMC Sierra 3500, most frequently naming the electrical and steering categories. 5 safety recalls have been issued covering this model year; 1 NHTSA investigation names it; and 606 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Complaint activity over time
When owners filed reports about this model year
Not enough dated records to plot a meaningful trend — 2 months of data.
What owners report
Complaints grouped by the component NHTSA recorded
- Electrical150.0%
- Steering150.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Safety recalls
5 campaigns cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govAIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect.
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
The transmission control module stopped working leaving the vehicle unable to be driven and no part support from gmc/allison and part is backordered with no eta. There are reports the module becomes defective due to its placement near engine heat. There should be a recall for this issue. Many people are experiencing this issue
- NHTSA ID
- 11688680
- Incident
- Sep 8, 2025
TL* THE CONTACT OWNS A 2010 GMC SIERRA 3500. THE CONTACT STATED THAT WHILE REVERSING AT VARIOUS SPEEDS, THE VEHICLE FAILED TO RESPOND TO DECELERATION ATTEMPTS AS THE POWER STEERING ASSIST FAILED. THE VEHICLE WAS TAKEN TO THE DEALER WHERE IT WAS FOUND THAT THE POWER STEERING PUMP NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS CONTACTED ABOUT THE FAILURE. THE FAILURE MILEAGE WAS 32,232. UPDATED 06/10/14*LJ
- NHTSA ID
- 10583312
- Incident
- Apr 1, 2014
- Mileage
- 32,232 mi
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
This preliminary information communicates information about how to determine if a wheel and tires size change is available.
This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.
This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.
This Preliminary Information communication provides information to the technician that some owners of Heavy Duty Trucks and Utilities may ask if they can lower their tire pressures. Tire pressures being set to the "Tire and Loading Label" will ensure the safe handling and ride characteristics of the truck and should not be lowered.
This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.
This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts that are being performed on customer’s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer complaint, contact General Motors Technical Assistance Center for further support. For any vehicles that remains unrepaired after being at the dealer for three days or more and a related bulletin or PI is not found, contact General Motors Technical Assistance Center for further support.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
| Year | Complaints | Recalls | Investigations | Issue Index |
|---|---|---|---|---|
| 2026 | 2 | 2 | 0 | — |
| 2025 | 16 | 1 | 0 | 42.5 |
| 2024 | 43 | 3 | 0 | 51.6 |
| 2023 | 28 | 1 | 0 | 55.9 |
| 2022 | 30 | 3 | 0 | 61.5 |
| 2021 | 20 | 5 | 1 | 52.6 |
| 2020 | 51 | 8 | 1 | 62.6 |
| 2019 | 13 | 7 | 0 | 63.0 |
| 2018 | 14 | 6 | 0 | 49.9 |
| 2017 | 13 | 7 | 0 | 62.4 |
| 2016 | 19 | 6 | 0 | 42.0 |
| 2015 | 30 | 7 | 1 | 55.2 |
| 2014 | 7 | 3 | 1 | — |
| 2013 | 14 | 4 | 1 | 58.5 |
| 2012 | 9 | 4 | 1 | — |
| 2011 | 20 | 5 | 1 | 50.3 |
| 2010Viewing | 2 | 5 | 1 | — |
| 2009 | 5 | 5 | 1 | — |
| 2008 | 25 | 3 | 3 | 55.8 |
| 2007 | 16 | 3 | 3 | 52.4 |
| 2006 | 11 | 0 | 0 | 49.5 |
| 2005 | 24 | 1 | 0 | 35.0 |
| 2004 | 24 | 1 | 0 | 38.9 |
| 2003 | 7 | 1 | 0 | — |
| 2002 | 20 | 3 | 1 | 57.4 |
| 2001 | 36 | 3 | 2 | 59.7 |
| 2000 | 26 | 4 | 1 | 57.8 |
| 1999 | 19 | 3 | 0 | 49.5 |
| 1998 | 12 | 4 | 0 | 52.4 |
| 1997 | 10 | 3 | 0 | 59.7 |
| 1996 | 1 | 0 | 0 | — |
| 1995 | 0 | 0 | 0 | — |
| 1994 | 0 | 0 | 0 | — |
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.