1992 Mazda MPV

EVAPORATIVE EMISSIONS CONTROL SYSTEM LIQUID-VAPOR SEPARATOR MAY FAIL AT NIPPLE FOR FUEL TANK HOSE CONNECTION RESULTING IN FUEL LEAKAGE IN THE AREA BEHIND THE RIGHT REAR TRIM PANEL.

RATORS AREEVAPORATIVE EMISSIONS CONTROL SYSTEM LIQUID-VAPOR SEPARATORS ARE ALLEGEDLY FAILING AND LEAKING FUEL LIQUID/VAPOR.

WHILE DRIVING, THE ACCELERATOR PEDAL WENT COMPLETELY TO THE FLOOR. THE VEHICLE THEN DOWN SHIFTED TO FIRST GEAR WITH THE THROTTLE WIDE OPEN. THE CRUISE CONTROL ENGAGED. THIS HAD NOT BEEN USED FOR A WHILE WHICH CAUSED AN ACCIDENT AND BROUGHT THE VEHICLE TO A COMPLETE STOP. *AK THE CONSUMERS GRANDDAUGHTER HAD GONE ON A RETURN TRIP, THE ACCELERATOR SUDDENLY WENT TO THE FLOOR, STAYED THERE AND HIT A VEHICLE. *SC *JB

NHTSA ID

10113144

Incident

Jan 1, 2005

WHILE VEHICLE WAS IN REVERSE ACCELERATOR PEDAL GOT STUCK, CAUSING VEHICLE TO BECOME UNCONTROLLABLE.*AK

NHTSA ID

10043951

Incident

Oct 12, 2003

WHILE DRIVING AT 50 MPH VEHICLE WAS INVOLVED IN A HEAD ON COLLISION, AIR BAGS DID NOT DEPLOY. VEHICLE WAS TOTALED. *AK

NHTSA ID

10043949

Incident

Oct 13, 2003

THERE WAS A VERY STRONG GAS ODOR IN THE CAB OF THE VEHICLE. *NLM

NHTSA ID

10019357

Mileage

142,000 mi

APPROACHING INTERSECTION WENT TO SLOW DOWN/STOP VEHICLE. BRAKES FAILED, UPON PRESSING ON BRAKE THERE WAS NOTHING BUT AIR. PEDAL TO THE FLOOR. CAR SKREECHED A FEW TIMES. ENDED UP GOING THROUGH RED LIGHT CAUSING ACCIDENT & INJURY.*JB

NHTSA ID

764713

Incident

Jul 15, 2002

WITH THIS VAN THERE HAVE BEEN NUMEROUS INCIDENTS SINCE AUGUST OF 1993. THE FIRST PROBLEM WAS A TICKING NOISE IN THE ENGINE. THE VAN WAS OUT OF SERVICE FOR 3 MONTHS WHILE THEY DALLIED AROUND TO FIX IT. I HAD IT TAKEN TO NORTHTOWNE MAZDA AND IT TOOK THEM A WEEK TO FIX IT. THE SECOND PROBLEM WAS A CONSTANT BREAKAGE OF THE LITTLE PIN THAT SHIFTS THE GEARS. THE THING BREAKS CONSTANTLY AND CAUSES THE GEAR DIAL LETTERS TO BE OFF BY ONE LETTER FOR INSTANCE THE R FOR REVERSE IS D FOR DRIVE. THE NEXT PROBLEM WAS A GAS LEAK THAT I TOOK IN TO HAVE FIXED THREE TIMES BEFORE IT WAS FINALLY FOUND. I WAS TOLD ON TWO DIFFERENT OCCASIONS THAT IT WAS JUST EXHAUST AND THAT THE PROBLEM COULD NOT BE FOUND. I DROVE THE VEHICLE TO MEMPHIS AND LIKED TO GAS MYSELF TO DEATH FROM THE FUMES ON THE WAY THERE AND BACK. UPON RETURN TO KCMO I TOOK IT DIRECTLY BACK TO THE DEALER. THE SERVICE MANAGER SAID JUST LEAVE IT OUTSIDE AND WE WILL BRING IT IN AND CHECK IT. I MADE HIM COME OUTSIDE TO THE CAR. YOU COULD SMELL THE GAS FROM 50 FEET AWAY. WHEN HE TOOK IT IN THERE WAS A RUPTURE INTHE FOURTH QUARTER PANEL HOSE THAT WHEN YOU TOOK A LEFT TURN IT SPILLED GAS INTO THE PASSENGER REAR SEAT. THE NEXT PROBLEM THAT I HAD WITH THIS VEHICLE WAS THAT THE CALIPERS, ROTORS AND BRAKES WORE CLEAN THROUGH AFTER ONLY 20,000 MILES OF WEAR ON THE NEW BRAKES. FIRESTONE FIXED THEM. THEN I HAVE HAD TO REPLACE THE TIMING BELT NOW 5 TIMES. I HAD THE FIRST TIMING BELT WAS REPLACED AT 66,000 MILES, THE SECOND AT 78,000 MILES, THE NEXT AT 108,000, AND THEN 138,000, NOW AT 139,463. S MEMO CAME OUT FROM MAZDA TO SERVICE REPAIR SHOPS THAT THE SPACERS ARE DEFECTIVE AND THAT WHEN THE TIMING BELT IS CHANGED THESE NEED TO BE REPLACED ALSO. THIS MEMO JUST CAME OUT IN JUNE 2002. THE OTHER PROBLEM THAT I HAVE HAD IS THE TRANSMISSION WENT OUT BECAUSE MAZDA HAS A DEFECTIVEPART THAT WON'T LET ENOUGH OIL IN TO ALLOW THE ENGINE TO RUN, THIS CAUSES A LOUD TICKING NOISE IN THE ENGINE. THE NEXT PROBLEM WAS THE SWAY BAR.

NHTSA ID

764617

Incident

Jun 15, 2000

RECEIVED INFORMATION ON SPECIAL PROGRAM #SSP-33 FROM MAZDA REGARDING FUEL FUMES. TOOK VEHICLE TO DEALERSHIP. MECHANIC REFUSED TO DO ANY REPAIRS ON VEHICLE. *AK CONSUMER ADDS WHILE DRIVING UP HILL, VEHICLE WILL ONLY ACCELERATE UP TO 10 MPH, ONCE REACHED LIGHTS FLICKER ENGINE, BRAKES AND STEERING LOCKED UP, RESULTING IN LOSS OF CONTROL, VEHICLE STARTED SMOKING AND STEAMING CAUSING THE ENGINE AND TRANSMISSION TO FAIL, ON SEVERAL OCCASIONS ENGINE IS OVERHEATING, COOLANT LEAKS AT ENGINE, THE WATER PUMP BELT BROKE, DEALER REPLACED COOLANT HOSES, WATER PUMP, TIMING BELTS, HEAD CYLINDER, THERMOSTAT, RADIATOR HOSE AND FAN CLUTCH. *TT

NHTSA ID

8004326

Incident

Feb 15, 2002

WHILE DRIVING ON THE HIGHWAY, CONSUMER WENT TO CHANGE LANES WHEN THE RIGHT REAR TIRE BLEW OUT, CAUSING CONSUMER TO LOOSE CONTROL OF VEHICLE AND HIT A GUARDRAIL TWICE, PASSENGERS IN THE VEHICLE SUFFERED INJURIES, IN WHICH ONE PASSENGER WAS EJECTED FROM VEHICLE, TIRE INFORMATION (THOROBRED STEEL P205/75R14 M/6 DOT MYKCEA9.(OHIO TRAFFIC CRASH REPORT #10-89-181).*JB

NHTSA ID

562271

Incident

Jun 16, 2001

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to comply with Federal, State, and local laws concerning odometerand related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the ?SpeedometerReplacement Label?.Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda?s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service.With the use of SPECMO?s services, a Mazda dealer can get the odometer setting updated to reflect the correct mileage at the time of replacement for both warranty and customer pay repairs, therefore resulting in a higher level of customer satisfaction. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

Speedometer replacement procedure

IN ACCORDANCE WITH FEDERAL REGULATIONS, FOLLOW THE PROCEDURE LISTED BELOW WHEN REPLACING A SPEEDOMETER.NOTE:•MAZDA VEHICLES ARE MANUFACTURED WITH TAMPER-PROOF SPEEDOMETERS.•WHEN A SPEEDOMETER IS REPLACED, THE NEW SPEEDOMETER WILL READ ZERO (0) MILES.•THIS PROCEDURE IS EXTREMELY IMPORTANT TO ACCURATELY REPRESENT ACTUAL VEHICLE MILEAGE.•PRIOR TO SPEEDOMETER REMOVAL, COMPLETE THE INFORMATION REQUIRED ON THE “SPEEDOMETER REPLACE-MENT LABEL”. •LABELS CAN ONLY BE ORDERED THROUGH MSTORE, NOT MDCS.