2015 Nissan Pathfinder

The Office of Defects Investigation (ODI) opened this preliminary evaluation to investigate consumer complaints alleging hood latch failures occurring on certain model year (MY) 2013-2016 Nissan Pathfinder vehicles. Complaints received indicated a sudden and unexpected opening of the hood while the vehicle was in motion, blocking the driver's visibility.During this investigation Nissan collected parts from the field to analyze for root cause of the alleged failures. On June 13, 2022, Nissan submitted a Defect Information Report (DIR) to NHTSA regarding a hood bell crank assembly defect in certain MY2013-2016 Nissan Pathfinder vehicles produced at the Smyrna, TN plant. According to Nissan's DIR, an accumulation of dust and dirt contamination on and around the bell crank lever pivot joint, which actuates the secondary hood latch, can create a condition that can cause the lever to remain in the open position after it has been disengaged. In this condition, the secondary hood latch may not hold the hood closed as designed while the vehicle is in motion obstructing the driver's forward view and increasing the risk of a crash.A remedy plan for all affected vehicles is currently under development. See recall action 22V-420 for further details. Nissan's action resolves the issues raised by this investigation, and therefore, this investigation is closed.The VOQs cited above can be found with ID numbers: 11456378, 11448298, 11436637, 11431131, 11427702, 11423321, 11406574, 11398825, 11389741, 11387952, 11375938, 11349105,11306735, 11302647, 11190468, 11166607.

The contact owns a 2015 Nissan Pathfinder. The contact stated that while driving 65 MPH, the front driver’s side curtain air bag deployed without impact. No warning lights were illuminated. The contact slowed down and veered over to the side of the road to park and inspect the vehicle. The Fire Department and the local EMT was contacted to inspect; however, there was no injury reported. The vehicle was towed to a local body shop, and the local dealer was contacted, however the vehicle was not diagnosed or repaired. The VIN was not under recall. The manufacturer was not notified of the failure. The failure mileage was 200,000.

NHTSA ID

11750809

Incident

Jul 9, 2026

Mileage

200,000 mi

The control arm detached from the front subframe due to massive rust on a car that was well cared for and only 10 years old. This happened as we were driving: the front passenger-side wheel became loose and began flopping back and forth, forcing me to immediately pull over into a gas station. I do not want to imagine what would have happened if this had detached on the highway instead of on a town side road. There were NO warnings or symptoms before this catastrophic failure. I had it towed to my regular mechanic, not realizing the extent of the damage—they wouldn't even put it on a lift. I then had it towed to the dealership, where they confirmed the damage was so extensive that (1) both control arms and the front subframe would need to be replaced due to rust ($5,800), and (2) the rear subframe was also extensively rusted, unsafe, and in need of imminent replacement, quoted at an additional $7,000. This being an exorbitant amount for a 10-year-old Nissan Pathfinder, I was forced to sell it to a salvage yard for a pittance just to buy a vehicle I could drive to work—and I can only hope it lasts until I can afford something better. I purchased this Pathfinder about 14 months ago. It was "inspected" by the dealer as well as by my regular mechanic at that time, with no indication that rust was a concern or even worth a comment. I am horrified by how much worse this could have been. We were on a trip more than an hour from home, heading toward the highway to return, when this occurred. No one should have to worry about something like this. Especially because, when I began researching, I found that this is a KNOWN defect on this model and others like it. It is NOT okay to put people at risk of serious or deadly injury when manufacturers KNOW water pools in places that can't be seen or checked, rotting the frame and subframe from the INSIDE out.

NHTSA ID

11742196

Incident

May 30, 2026

CVT judder problems on acceleration

NHTSA ID

11729594

Incident

Apr 6, 2026

The contact owns a 2015 Nissan Pathfinder. The contact stated that the rear brake lights failed to illuminate when the vehicle was parked. The contact depressed the brake pedal to disengage the brake lights. While driving at various speeds, the brake lights illuminated without the brake pedal being depressed. The dealer was contacted and confirmed that there were recalls associated with the VIN related to the failure. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and confirmed that the vehicle was previously included in NHTSA Campaign Number: 21V020000 (Exterior Lighting) and was repaired in 2021. The failure mileage was approximately 115,000.

NHTSA ID

11728739

Incident

Mar 19, 2026

Mileage

115,000 mi

While driving at a rate of 20mph +, the pathfinder will start jerking back and forth then turn off. This happened in the middle of a highway lane. Good thing no one was hurt. This was also sudden

NHTSA ID

11721655

Incident

Sep 26, 2025

1. CODE P0101 not removed after replacing MAF sensor. 2. power steering motor is annoying noise, high pitched sound.

NHTSA ID

11712378

Incident

Nov 22, 2024

The contact owns a 2015 Nissan Pathfinder. The contact stated that while driving at an undisclosed speed, there was a loud sound coming from the front of the vehicle. There was no warning light illuminated. Additionally, the contact stated that a family member had driven the vehicle and informed the contact that the vehicle was experiencing a transmission failure. The dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 81,954.

NHTSA ID

11707746

Incident

Dec 30, 2025

Mileage

81,954 mi

The contact owns a 2015 Nissan Pathfinder. The contact stated that while driving at an undisclosed speed, the vehicle jerked and vibrated, causing the steering wheel to lock up. The contact used force to maneuver the steering wheel. The contact was unsure if any warning lights were illuminated. The vehicle was not taken to the dealer. A mobile mechanic arrived at the residence and inspected the vehicle. The contact was informed that the CVT transmission had failed. The vehicle was not repaired. The failure recurred, and the contact parked the vehicle. The vehicle was no longer driven due to safety concerns. The manufacturer was not notified of the failure. The failure mileage was unknown.

NHTSA ID

11695011

Incident

May 22, 2024

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)

CVT/TCM CALIBRATION DATA “WRITE” PROCEDURE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.