2011 Toyota Tundra

Odometer Fraud. The contact purchased a 2011 Toyota Tundra. It was discovered that there was a mileage discrepancy after the purchase. The vehicle was a private sale. At the time of the purchase, the mileage was 147,497, and at the time of registration, it was discovered that the mileage was 275,143.

NHTSA ID

11724911

Incident

Mar 16, 2026

Mileage

275,143 mi

The contact owns a 2011 Toyota Tundra. The contact stated that while attempting to accelerate from a red traffic light, the vehicle failed to accelerate as intended while depressing the accelerator pedal. No warning light was illuminated. The vehicle was towed to the residence and remained at the residence for further investigation. In addition, a local independent mechanic was contacted, and the contact was informed that the failure was possibly related to NHTSA Campaign Number: 11V254000 (Power Train). The local dealer was contacted; however, the VIN was not included in the recall. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 174,000.

NHTSA ID

11700289

Incident

Nov 18, 2025

Mileage

174,000 mi

I took my truck to the dealership of Toyota in Riverside, CA and the staff there told me there was no recall for my vehicle. Can you please verify if my vehicle is under warranty? I also went to the smog inspection and told them about my situation and they said my vehicle may not be under recall since sometimes certain vehicles under the same year are grouped together with a specific recall.

NHTSA ID

11668003

Incident

Jun 19, 2025

Paint prematurely chipping in areas that’s would and would not be affected by wind down to bare metal.

NHTSA ID

11618111

Incident

Oct 4, 2024

Extensive rust and rot of entire frame, and undercarriage. The truck bed unsafe to walk on has several soft spots almost broken through, gas tank holder rusted out- worry about gas tank dropping from frame, tow hitch and rear bumper rot etc. Side step fell off. Toyota has a Service Campaign and Warranty Enhancement Program for Tundra but not this year- built 9/2010 San Antonio but listed as 2011 model on VIN. I am original registered owner and have never been contacted about this factory failure use of inferior untreated frame materials but learned about it from internet research. Would like my vehicle covered under current Service Campaign.

NHTSA ID

11604233

Incident

Jul 23, 2024

The contact owns a 2011 Toyota Tundra. The contact stated while driving 40-50 MPH downhill, the vehicle lost power steering functionality. There was no warning light illuminated. The contact pulled to the side of the road. The contact stated that upon inspecting the vehicle, there was an oil leak on the passenger's side of the steering gear onto the ground. The contact was able to drive the vehicle to the destination without power steering functionality. The vehicle was towed to the dealer, where it was diagnosed that the steering rack had failed and needed to be replaced. The dealer informed the contact that the steering rack replacement could not be covered under warranty due the part number. The vehicle was not repaired and remained at the dealer. The contact related the failure to NHTSA Campaign Number: 21E103000 (Steering); however, the VIN was not included. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 121,000.

NHTSA ID

11600862

Incident

Jun 8, 2024

Mileage

121,000 mi

Rack and pinion is leaking oil.

NHTSA ID

11578834

Incident

Mar 1, 2024

The contact owns a 2011 Toyota Tundra. The contact stated that upon loading the bed of the truck, a worker stepped on the bed and his foot went through the bed. There was no injury sustained. The contact then noticed that there were four 3-inch holes located near the bed bolts of the vehicle due to corrosion. Additionally, the contact stated that the frame was corroded. The contact related the failure to TSB Number: [XXX]. The contact stated that he was an independent mechanic and had determined that the failure occurred because there was no underbody coating on the vehicle, which caused water to be trapped on the underbody. The local dealer was contacted, but no assistance was provided. Another dealer, Oakbrook Toyota (550 E Ogden Ave, Westmont, IL 60559), was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that they could not assist because the VIN was not included in a recall. The failure mileage was approximately 68,000. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11569985

Incident

Feb 1, 2024

Mileage

68,000 mi

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

Toyota vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.