2012 GMC Yukon

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The contact owns a 2012 GMC Yukon. The contact stated that years ago, the engine was replaced with a rebuilt engine. Recently, after starting the vehicle, there was an abnormal banging sound coming from the engine. The banging sound continued, and the vehicle shut off without warning. Due to the failure, the vehicle was towed to an independent mechanic, and it was discovered that an engine bearing had failed, and the vehicle was diagnosed with engine failure. Neither the dealer nor the manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was approximately 47,000.

NHTSA ID

11717094

Incident

Feb 3, 2026

Mileage

47,000 mi

Driving on loop 20 overpass on Hwy 59 in Laredo Texas suddenly the engine lost power and started to skip and miss fire while a loud tapping noise was generated, due to the loss of power and skipping, alarms showed in the main console requiring immediate service to the engine, traction and braking sys, the lack of engine power place me in a very critical and unsafe situation wherein I was about to be rear collision by the vehicle behind me. This event happened on October 17th, 2025 . I brought the vehicle to Powell Watson Motors who is the GMC dealership in Laredo Texas for inspection but they refused to accept the vehicle due to the age of the vehicle. I feel this safety issue must me corrected and resolved in order to avoid accidents and deaths.

NHTSA ID

11696097

Incident

Oct 17, 2025

Yesterday while unloading the rear of our 2021 GMC Yukon Denali the tailgate came down on me without warning and with force. I googled to see what might have caused this to happen and it stated that the struts might be worn out. (I am having that checked out today) Fortunately, I am a 6 foot 220 pound man and was not hurt but just the day before my 14 year old, 100 pound grand daughter was taking things things out of the rear of the vehicle. If the rear door would have come down on her it would have been a lot worse

NHTSA ID

11609310

Incident

Aug 18, 2024

Dashboard cracked, afraid that if airbag deploys shards of dashboard will come flying at both driver and passenger. It started as a little crack, than expanded across the entire dashboard

NHTSA ID

11566052

Incident

Jan 17, 2019

The problem started a couple of years ago as a small crack in the dashboard at the upper left corner of the airbag. The crack widened and lengthened after replacement of the air bag last year. Then the dash cracked earlier this year at the crown above the instrument cluster. It has completely separated and is nearly 12” in length. Not only does it rattle to the point of driver distraction, but I would think there is a high risk of shattering during a collision potentially causing facial lacerations, blindness and the like. I really don’t want to wait to find out. According to [XXX] , this is a well known issue with GM trucks, Suburbans and Yukons from 2007 to 2014 and GM has failed to make good on the problem. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11559602

Incident

Mar 1, 2021

The contact's son owned a 2012 GMC Yukon. The contact received notification of NHTSA Campaign Number: 21V051000 (Air Bags) and requested to be removed from the recall distribution list as her son no longer owns the vehicle. The local dealer and manufacturer were contacted.

NHTSA ID

11554375

Incident

Nov 9, 2023

Dash panel cracked via design defect. Damage has spread and poses a safety risk if airbags are deployed.

NHTSA ID

11517424

Incident

Apr 1, 2016

I HAVE A 2012 GMC YUKON DENALI XL THAT STARTED HAVING TRANSMISSION "6L80" ISSUES AT 120,000 MILES.(03/20/2019) BEAMAN GMC STATED THE TRANSMISSION WAS OUT AND NEEDED TO BE REPLACED. OF COURSE JUST OUT OF WARRANTY. SO ON I SPENT $6031.19 TO HAVE IT REPLACED/REBUILT, NOW 80,000 MILES LATER ON 3/24/2023 I JUST HAD TO HAVE IT REPLACED/REBUILT AGAIN FOR THE SAME PROBLEM, THIS TIME TO THE TUNE OF $9454.00. I DECIDED TO DO SOME INVESTIGATIVE WORK AND FOUND THAT THERE IS A SERVICE BULLETIN ABOUT THIS TRANSMISSION THAT WAS DATED NOVEMBER OF 2022. BULLETIN # 16-NA-338 FOR A TRANSMISSION ASSEMBLY REPLACEMENT. ALSO ANOTHER BULLETIN (PL0773)DATED JULY 2012 AND ONE DATED FEBRUARY 2012 BULLETIN PI0488A. I CAN EMAIL YOU COPIES OF THESE IF YOU WOULD LIKE. THERE WAS ALSO A PRELIMINARY REPORT/BULLETIN PUT OUT JUNE 6TH, 2020 BULLETIN # PIP5175D WITH ALL OF THESE BULLETINS THERE SHOULD HAVE BEEN A RECALL. REBUILDING WHAT THEY ARE ALREADY ARE HAVING ISSUES WITH IS INSANE. PLEASE CONSIDER HELPING ME WITH THIS. I FEEL LIKE THERE ARE ALOT OF OTHER PEOPLE DEALING WITH THE SAME THING AND JUST HAVEN'T DONE THEIR RESEARCH.

NHTSA ID

11514664

Incident

Mar 20, 2019

This preliminary information communicates information about how to determine if a wheel and tires size change is available.

This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This PI Communications information on an alternative product dealers can use to perform 19-NA-255: Wax Coating on Frame Peeling, Metal Shows Corrosion/Rusting due to issue with getting product from current supplier listed in the bulletin.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts that are being performed on customer’s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer complaint, contact General Motors Technical Assistance Center for further support. For any vehicles that remains unrepaired after being at the dealer for three days or more and a related bulletin or PI is not found, contact General Motors Technical Assistance Center for further support.