2016 Nissan Quest

Car need transmission replaced - there is no warning on car that transmission is having major issues (ie no check engine light). My car shakes on turning this has been on going since I purchased the car in 2017. In late 2023 the car did not have as much pick up power like it used to and had a whining noise once you drive for a while (without the power it used to). There were no check engine light warning to date. On 1/12/24 I used auto zone engine diagnostic and following error codes came up - P17FO - CVT JUDDER P17F2 -JUDDER T/C inspection Diagnostic at AAMCO ON 3/25/24 show additional issues that don’t show any warning signs eg check engine light PER AAMCO additional issues: Engine missing cylinder 3,4; and cylinder 1 is misfiring. Transmission juddering around 2nd gear, chain slipping under pressure…transmission having internal mechanical failure. I am not sure if these issues are serious enough to show as check engine. If they should I don’t know why my car check engine light is not on?

NHTSA ID

11582805

Incident

Nov 5, 2023

Check engine light appeared without warning and car would slow down and no longer accelerate on the highway. Took to the dealership and was told it needed a new transmission with only 64,000 miles of use.

NHTSA ID

11537643

Incident

Jul 24, 2023

The contact owns a 2016 Nissan Quest. The contact stated while driving approximately 50 MPH, the contact shifted the CVT transmission into low (L) manually. The contact stated that the vehicle began to vibrate and then began to shake the entire vehicle. The contact removed his foot from the accelerator pedal and started to tap the brakes. The contact stated that the vehicle started to shake more violently while slowing down. The contact stopped the vehicle and felt resistance from the shift lever while attempting to shift the vehicle into park (P). The contact stated that the check engine warning light momentarily illuminated, but then turned off. The contact stated that the failure was intermittent but had reoccurred without manually shifting gear. The contact had taken the vehicle to an independent mechanic who scanned the vehicle and retrieved DTC code: P17F1 (CVT Judder). The vehicle had not been repaired. The manufacturer had been informed of the failure. The failure mileage was 136,022.

NHTSA ID

11536125

Incident

Jul 26, 2023

Mileage

136,022 mi

The control arms on the vehicle malfunctioned and had to be replaced. I typically lost control of steering causing the vehicle to jerk in one direction or the other. This was repaired almost a year ago. I had the vehicle serviced at a independent service center. It could have possible caused an accident had I not been able to counteract the loss of steering. I am currently experiencing this same issue again and was notified in May 2023 that the control arms have once again malfunctioned. There are no warning lights for this issue, I noticed it when the car seemed to need a front end alignment but once I took it to the shop they confirmed that the control arms had malfunctioned. I researched this issue and saw that there was a recall of these exact same parts for 2016 Nissan Quest vehicles used as emergency vehicles. I am concerned that this is some sort of on going issue, that is costing $1600 + on every repair.

NHTSA ID

11530497

Incident

Aug 17, 2022

MY TRANSMISSION WILL NOT GO INTO DRIVE,ITS WILL REVERSE GREAT BUT WILL NOT MOVE IN DRIVE OR LOW

NHTSA ID

11402888

Incident

Feb 28, 2021

Mileage

83,000 mi

NISSAN COMMON PROBLEM IS THE BREAK SENSOR SWITCH. *TR

NHTSA ID

11329498

Incident

Jun 9, 2020

I HAVE A 2016 NISSAN QUEST. IT SNOWED LAST NIGHT, AND A PIECE OF ICE GOT STUCK IN THE DRIVER'S SIDE EXTERIOR DOOR HANDLE AND KEPT THE HANDLE SLIGHTLY AJAR. BECAUSE OF THIS, THE DRIVER'S SIDE DOOR WOULD NOT OPEN USING THE INTERIOR DOOR HANDLE. I HAD TO UNROLL THE WINDOW, AND PUSH THE EXTERIOR HANDLE BACK TO ITS NORMAL POSITION BEFORE THE INTERIOR DOOR HANDLE WOULD OPEN THE DOOR. I AM GRAVELY CONCERNED ABOUT THE DESIGN OF THE DOOR LATCH MECHANISM. IT WOULD BE LOGICAL THAT THE INTERIOR HANDLE SHOULD OVERRIDE ANY STATE THE THAT THE EXTERIOR HANDLE IS IN (FOR EXAMPLE, IF THE EXTERIOR HANDLE WAS DAMAGED IN AN ACCIDENT) AS A SAFETY PRECAUTION.

NHTSA ID

11286994

Incident

Dec 4, 2019

Mileage

65,000 mi

TOOK MY NISSAN IN FOR THE 60000 SERVICES AND FOUND OUT THERE IS A PROBLEM ON THE CVT HAS A CODE P17F1. THE SERVICE TECH EXPLAINED WHAT'S WRONG HOW IS SHAKES AND JUDDER AND I HAVE BEEN FEELING THIS SINCE 45000MILE AND I'M JUST ABOUT 3000 OUT OF WARRANTY AT 63000 MILES AND NISSAN USA DOES NOT WANT TO COVER THE REPAIR. THE CVT JUDDER UPON ACCELERATION 0-40. I WAS ADVISED TO GET THE VALVE BODY REPLACED AND WAS QUOTED $1340.47. I HAVE BEEN A LOYAL NISSAN OWNER FOR YEARS I HAVE NISSAN TITAN 2006 , 1984 NISSAN 300ZX, 2004 INFINITY I35, 2014 NISSAN ALTIMA,AND HAD 2003 NISSAN MAXIMA.

NHTSA ID

11183398

Incident

Feb 19, 2019

Mileage

63,000 mi

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)

CVT/TCM CALIBRATION DATA “WRITE” PROCEDURE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.