2020 Nissan Titan

The contact owns a 2020 Nissan Titan. The contact stated that while driving at an undisclosed speed, the vehicle intermittently stalled; the contact waited several minutes for the vehicle to return to normal operation. The Check Engine warning light was illuminated. The failure had occurred on several occasions. The contact researched and was made aware of an unknown recall; however, the VIN was not under recall. The vehicle was taken to a dealer where it was diagnosed and determined that the fuel temperature valve needed to be replaced. The vehicle was repaired; however, the failure persisted. The vehicle was taken back to the dealer where it was diagnosed and determined that the radiator needed to be flushed and refilled. The vehicle was repaired; however, the failure persisted. The manufacturer was not notified of the failure. The failure mileage was approximately 85,000.

NHTSA ID

11745630

Incident

May 22, 2026

Mileage

85,000 mi

Unknown, vehicle was purchased from Insurance Auto Auctions with minor front collision damage that occurred in the State of Georgia. Suspension damage was not revealed until vehicle was delivered by a transporter to my home. Upon inspection of the vehicle it was determined that the McPherson shock absorber was defective and broke in 2 pieces causing the release of the spring tension. The Nissan manufacturing defect occurred in the factory welds of the upper strut tower support in that the welds of the shock tower never fused with the vehicle chassis which caused the rupture of the entire upper right front suspension.

NHTSA ID

11742246

Incident

May 1, 2026

The Rear Automatic Braking (RAB) software fails to detect a connected trailer harness. The truck experiences un-commanded, sudden emergency braking during multi-point turns when going from forward to reverse when manueverimg a trailer, creating an immediate hazard of neck injury, trailer jackknifing on public roadways or loss of control. this is on a truck that has a brake controller for trailers, the truck knows a trailer is hooked up but repeatedly turns the RAB back on after it driver disables it, furthermore the truck does not have a driver configuration option in settings to permanently disable these features but rather has a temporary button on the center console which resets every time the truck goes from forward to reverse.

NHTSA ID

11740235

Incident

May 26, 2026

After replacing the truck frame and one day after returning the truck to me the transmission slipped out of gear while driving 75mph on the freeway. While attempting to brake the transmission seemed to lock up. When I slowed the truck down enough I hit the brakes and shifted the transmission into park. By doing this I was able to stop before hitting other vehicles and a guard rail. Nissan replaced the transmission. After several test drives they replaced the second transmission because of shifting problems. The current transmission just recently would not shift into second gear. I’ll be taking it back Monday. In short my transmission has been replaced twice in a months time and is going back to the dealership for additional repairs.

NHTSA ID

11676077

Incident

Jun 18, 2025

Peoria Nissan found a bad weld at the right front strut tower. The weld failed causing a crack in the frame. As a result the entire frame required replacement. Nissan refuses to offer any warranty other than a one year parts warranty for the frame beyond the original manufactures warranty which ends August 2025. Two service advisors advised me they have seen three frames fail in the same area at their dealership.

NHTSA ID

11676076

Incident

May 12, 2025

The issues I'm experiencing with this vehicle is delayed pedal response and a whole slew of transmission problems. There are no codes or check engine lights on. When coming to a stop and the vehicle downshifts you can visibly see the RPMs go up with each down shift and sometimes the downshift is so harsh going to 1st gear that it feels like another vehicle has bumped me from behind causing the truck to jerk forward and make a clunking sound. There is also a problem when upshifting where the RPMs will jump up before shifting into the next gear. I had a situation where I was turning left on a green light with traffic coming and had plenty of time to make it but when I rolled out into the intersection and hit the gas nothing happened for over 2 seconds. The RPMs didn't move and when I pressed the gas harder the vehicle went into a low gear and the RPMs shot up to about 5000 RPMs and accelerated rapidly to just miss an incoming vehicle. Vehicle has inconsistent shifting where it shifts ok one day and other days it acts erratically. I have been to two different dealerships and both say the truck drives as designed. I have had all the software updates done on this truck that were supposed to correct these issues but they have not helped. I opened up a case with Nissan support and they admitted these transmission problems were being addressed by their engineering team and a new software update would be available some point in the future, this was a year ago.

NHTSA ID

11639611

Incident

Jan 22, 2025

Truck was exiting highway driver tried to disengage cruise control, would not disengage. Driver put truck in neutral to slow down truck but didnt slow down enough to avoid accident. Driver and passenger are in hospital with several injuries. The air bags did not deploy during accident. Insurance is inspecting vehicle.

NHTSA ID

11597529

Incident

Jun 22, 2024

from day one, it has had a hesitation on acceleration from both still and moving normal highway speeds. rarely is acceleration steady, smooth and immediate. dealer has had for regular oil change and this problem has been reported every time . answer was that factory recall was performed and should be better. but NO. over a year now, several visits and nothing resolved. a couple times when i needed that immediate acceleration but with severe hesitation and a semi truck hitting his brakes and blowing horn i would call it a safety problem. im not sure what work was preformed, assuming most time transmission but after research on computer there have been nissans with engine components causing this. please help. where do i go from here?

NHTSA ID

11532702

Incident

Jul 17, 2023

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions:  When contamination or foreign material adhere to the lane camera viewing window on the windshield.  When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield.  When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information:  Refer to the following pages.  Use the search keyword “blinking” in the ESM.

INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

FLUID LEAK FROM THE FRONT DIFFERENTIAL CASE ACTUATOR MOTOR PLASTIC THREADS SERVICE INFORMATION Figure 1 Figure 2 If the front differential has a fluid leak coming from the actuator motor plastic threads (Figure 1): a. Place an alignment mark on the splined actuator body and the gear carrier (Figure 2). b. Remove the actuator and thoroughly clean the threads, making sure not to allow RTV to fall into the differential case. c. Once clean, apply Three Bond sealant to the threads, and then reinstall the actuator motor, making sure to line up the alignment marks. d. Check the front differential gear oil level and top to specification. o Refer to the ESM: TRANSMISSION & DRIVELINE > DRIVELINE > FRONT FINAL DRIVE: MA235/MA210 > PERIODIC MAINTENANCE > FRONT DIFFERENTIAL GEAR OIL DO NOT replace the front differential due to a fluid leak from the actuator motor plastic threads unless there has been consequential damage due to fluid loss (bearing failure or gear noise) to the front differential.

LANE CAMERA AIMING VEHICLE REFERENCE VALUES NOT IN ESM SERVICE INFORMATION If the lane camera requires aiming, the values in Table A on page 4 must be used.  For all other models/model years, consult the Electronic Service Manual (ESM).