2024 Nissan Titan

The vehicles front Automatic Emergency Braking (AEB) system, part of the Safety Shield 360 suite, has activated several times without any obstacle, vehicle, pedestrian or hazard present in the roadway. This is commonly known as phantom braking. The system triggers unexpected braking during normal driving conditions, which creates a risk of read end collision from following traffic and loss of vehicle control response time. In my specific case the issue happens during bright sunshine when the sun casts a shadow from the overpass at [XXX] and highway [XXX] in the [XXX] area. This has happened several times to me at that location and the vehicle locks the brakes and traffic behind me must quickly brake to avoid hitting my vehicle. I temporarily remedy the problem by disabling the front emergency brake using the vehicle menu before my commute but that menu resets when the vehicle is turned off and i have on occasion forgot to disable the front emergency braking. This malfunction will also occur at higher speeds but the vehicle does not have time to react and all that I get is a bright flashing warning light on the dash indicators as I drive under overpasses at higher speeds. At lower speeds this is very dangerous. I have reported this problem to my local Nissan Dealer, Bommarito Nissan on [XXX] in [XXX] but as of now they do not have a solution. I plan to report the problem again today and tell them that I have filed a report with this agency. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11750626

Incident

Jul 9, 2026

Regarding the 2024 Titan roof, the rain cutters seem to have seam bonding and no weather stripping. The seam sealant only goes 3/4 of the way along rain cutters on the roof. This is leaving a pocket where water collects and starts to rust. Nissan should repair this under it corrosion warranty . It’s also causing an issue with the windshield where the seam sealant or bonding material is coming apart and leaking into the windshield where rust could form. This is a know issue per some service techs.

NHTSA ID

11732675

Incident

Mar 28, 2026

The engine just shut off. I was in traffic moving up to a light and the vehicle just shut down. The second time when I was exiting the freeway got to the yield sign and the vehicle just shut down. The third time was turning left and the vehicle just shut down. the fourth time I was in traffic that was coming to a stop and the vehicle shut down. 5th time I was turning slow rate and the vehicle shut off. 6th and 7th time were in stop and go traffic as it was decelerating. The 8th time coming up to a stop sign and the vehicle shut off. I took the vehicle to Nissan 2 different locations and since there are no codes they can't duplicate the error. My fear is what happens if this shuts down at speed. There was no warning, no rough idle or anything significant. The vehicle has been looked at two different Nissan Dealership without being able to confirm or reproduce the problem. The worst factor is the fear my wife has about the vehicle just shutting off.

NHTSA ID

11717679

Incident

Feb 2, 2026

The automatic transmission in my 2024 Nissan Titan PRO-4X intermittently malfunctions when slowing to a stop. As the vehicle decelerates to about 1–2 mph, there is a distinct “bump” or “lurch” as if the truck has been lightly rear-ended. The sensation occurs most often at traffic lights or rolling stops. •Component/system failed: Power Train – Automatic Transmission (9-speed). Vehicle is available for inspection upon request. •Safety risk: The unexpected jolt can cause distraction and abrupt braking. It raises concerns about long-term durability and could increase the risk of a rear-end collision in traffic. •Reproduced/confirmed: Yes. I reported this under warranty to a Nissan dealer. The dealer replaced a transmission bracket, but the issue persists. The downshift/lurch can still be reproduced. •Inspected by others: The dealer service department has inspected it. Manufacturer has not provided a lasting fix. •Warning lamps/messages: No warning lights or diagnostic messages appear before, during, or after the issue. •First appearance: Issue began when I purchased the vehicle (at approx 4700 miles) and continues intermittently (currently 19000 Miles). •Similar complaints: Other 2024 Nissan Titan owners have reported the same problem publicly, describing the downshift bump/lurch at low speed. Earlier Titan model years (2020–2023) had recalls and TSBs for TCM/ECM software updates (e.g., Campaigns R22B1, R22A9; TSBs NTB21-028A, NTB22-085) addressing low-speed hesitation and harsh downshifts. My request: I am requesting NHTSA investigate whether the 2024 Titan shares the same transmission calibration defect as prior years and determine if Nissan must provide updated software or other corrective measures to fix this unsafe low-speed downshift behavior. Thank you

NHTSA ID

11682128

Incident

Dec 26, 2024

The contact owns a 2024 Nissan Titan. The contact stated that while attempting to accelerate from a stop, the transmission was slipping, and the vehicle jolted and jerked while shifting between 4th and 5th gears. The contact stated that while attempting to stop the vehicle, there was an abnormal clunking sound coming from the transmission, with the vehicle jolting. There was no warning light illuminated. The vehicle was taken to a local dealer to be diagnosed, and the contact was informed that the TCM needed to be reprogrammed. The contact also stated that water was leaking through the sunroof. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 9,000.

NHTSA ID

11675585

Incident

Jan 23, 2025

Mileage

9,000 mi

See attached document for complaint.

NHTSA ID

11673874

Incident

Jun 30, 2025

Transmission. When coming to a stop the truck lurches forward from a hard downshift that can potentially cause a rear end collision. I have taken to two Nissan dealerships (Marietta, Ga and Roswell, Ga) and both claimed they could not replicate this issue. I am not sure when the problem started as the salesman drove it from Carrollton, Ga to Marietta for me to purchase. The first time it happened to me was at 150 miles. The truck is currently at 4,500 miles and continues to shift incorrectly. There are no warning lights and the dealership refuses to spend any time solving the problem. I took the service manager for a drive and he confirmed that there is an issue and said he would open a service ticket. Three weeks later he said the mechanic cannot duplicate the problem and says the truck drives normally.

NHTSA ID

11662947

Incident

May 24, 2025

vehicle has 2900 miles, it has a noticeable hum/whining sound coming from rear end area. sound is very pronounced at 46-50 mph under throttle. Issue has been addressed with a local dealership. They found metal shavings in the rear end assembly. Their assessment is such that the rear differential has prematurely failed. They recomend replacing the rear differential carrier at 2900 mi, mind you. That said, they warned the vehicle has the potential of causing a "lock up" but have made no concerted effort to actually replace the part. instead, they claim the part is order

NHTSA ID

11644001

Incident

Jan 15, 2025

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions:  When contamination or foreign material adhere to the lane camera viewing window on the windshield.  When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield.  When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information:  Refer to the following pages.  Use the search keyword “blinking” in the ESM.

INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

FLUID LEAK FROM THE FRONT DIFFERENTIAL CASE ACTUATOR MOTOR PLASTIC THREADS SERVICE INFORMATION Figure 1 Figure 2 If the front differential has a fluid leak coming from the actuator motor plastic threads (Figure 1): a. Place an alignment mark on the splined actuator body and the gear carrier (Figure 2). b. Remove the actuator and thoroughly clean the threads, making sure not to allow RTV to fall into the differential case. c. Once clean, apply Three Bond sealant to the threads, and then reinstall the actuator motor, making sure to line up the alignment marks. d. Check the front differential gear oil level and top to specification. o Refer to the ESM: TRANSMISSION & DRIVELINE > DRIVELINE > FRONT FINAL DRIVE: MA235/MA210 > PERIODIC MAINTENANCE > FRONT DIFFERENTIAL GEAR OIL DO NOT replace the front differential due to a fluid leak from the actuator motor plastic threads unless there has been consequential damage due to fluid loss (bearing failure or gear noise) to the front differential.

DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)