2019 Nissan Maxima

My 2019 Nissan Maxima (approximately 70,000 miles) displayed a hazard warning indicating a vehicle failure and began stalling without warning. The vehicle was brought to Mossy Nissan on May 28, 2025, where it has remained for over 11 days. The dealership has been unable to identify or repair the root cause of the electrical failure. The vehicle has been observed stalling while in the dealership's possession. This is a safety defect — a vehicle that stalls without warning poses a direct risk to the driver, passengers, and others on the road. I am formally requesting NHTSA investigate this issue as a potential safety defect in the 2019 Nissan Maxima.

NHTSA ID

11742646

Incident

May 28, 2026

I was driving at night when I got a headlight system error message on my instrument panel and I noticed my driver side headlight was not on. A few seconds later the light came back on and a minute or so later it went off again and came back on and I got the error message again. It came back on and has worked pretty much since but I have seen it flickering at night on a few occasions. The next day when it was light out I looked at both headlights and noticed a lot I mean a lot of condensation inside the headlight assembly. I know some fogging and some light condensation is normal on these LED lights but the amount inside the driver side headlight is not normal. And I was lucky enough to have the error and light go off and on in a fairly well lit area so thankfully I was not in an accident or driving on road that’s not well lit. There’s clearly a defect in the sealing of the headlight that’s allowing that much water in. And not having a headlight working because of an error caused by water that can disable my visibility especially on the driver side to due to the headlight not being sealed properly. There is not physical damage like a crack or anything in the housing of the headlight. And since the whole headlight needs to be replaced since it’s LED that’s $2200 before labor. And there didn’t appear to be anything wrong with the headlight no condensation when I looked at it on the car lot when I bought it on 3-4-26. I tried to have my Nissan dealer repair/replace it using the Endurance Apex Unlimited warranty I bought when I purchased the car but they won’t cover it due to a faulty seal. I’ve seen a couple post about the same side headlight on others 2019 Maxima’s with the same issue so this doesn’t appear to be a one off. And I would think headlights going out from moisture and condensation causing errors to the electric contacts controlling the headlights would be a serious safety issue that could potentially cause bodily harm or even death from an accident.

NHTSA ID

11727083

Incident

Mar 12, 2026

I recently purchased a 2019 Nissan Maxima in November of 2025 from the Nissan dealership, with in the matter of 2 weeks after getting the car as I was driving the sunroof just exploded sounding like a gunshot. My son was in the car and luckily, I had the shade up, so no glass got all over us. The issue almost caused a wreck due to me having to swerve after thinking someone was shooting and or something fell out of the sky. I have a panoramic sunroof, and the insurance company say they do not cover sunroofs.

NHTSA ID

11718735

Incident

Dec 10, 2025

On 12.102025 the panoramic sunroof exploded while I was driving home, with my son in the car. Out of no where it was this huge explosive sound that, sounded like a gun shot or something. It was day time the sun out just driving along. The dealer did not state anything was wrong with the sunroof. I purchased this vehicle in November of 2025. The sunroof was not inspected upon purchase it was explained that they only inspected the engine, abiding by basic inspection protocol. No warning lamps or anything was on and all warning lights work. With my son in the car I was terrified and I'm glad I did not wreck vehicle due to being frantic on behalf of the sound, and also glad that it was cold out and the inside was closed. I have been in contact with my insurance provider and awaiting on the adjuster to come out and see the damage, From research there seems that many Nissan owners have experienced this issue and yet Nissan has failed to to take accountability or acknowledge this known issue

NHTSA ID

11704475

Incident

Dec 10, 2025

I purchased my 2019 Nissan Maxima [XXX] from Hyundai of Pineville I'm Charlotte NC. Over the past months including after purchase which I made Hyundai aware. The vehicle has an ongoing noise coming from I side the front hood of the vehicle. It sounds as of a pan etc... is hitting something, at times in slow motion there is a whining noise coming from the car, when just sitting in driver seat and pressing gas pedal when the car idle down after pressing the gas pedal there is a thump noise. The original owner of the vehicle traded the vehicle at Hyundai and appears they were from out of state is where the vehicle is from. So I have not received no recall etc... info also the prior owner, I keep getting stuff with there name. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11671273

Incident

Aug 5, 2024

The back sunshade cover for the back panorama sunroof juat snapped. A couple of plastic parts were found on the floor. The sunroof was not open at the time it just snapped while driving. I took it to the dealership and they stated it wasn’t under warranty and it would cost over $3000 to replace. For a sunshade that seemed pretty pricey. The sunroof hasn’t been open in month or years.

NHTSA ID

11671083

Incident

Jun 2, 2025

Unknown I was trying to trying to purchase vehicle and was approved 1 sales man told me there was transmission problem they didn't want to disclose and I kept asking them as I test drive it and heard it it's seems to be something wrong with it but everyone said no it turns out that there was damage not only to transmission when it had accident but body damage dealership hasn't donet want to report rear fender and it's misleading alot and

NHTSA ID

11632801

Incident

Dec 24, 2024

The contact owns a 2019 Nissan Maxima. The contact stated while driving 60 MPH, the oil level warning light illuminated and the vehicle started smoking under the hood. The contact checked the oil level and notice there was no oil in the engine. The contact added engine oil however, the smoking continued. The vehicle was taken to the dealer to be diagnosed. The contact stated that the spark plugs and intake gasket were replaced; however, the vehicle continued to smoke and the oil level remained low. The vehicle was taken to the dealer and the contact was informed that the engine needed to be replaced. The manufacturer was contacted and confirmed that the engine needed to be replaced. The failure mileage was 70,000.

NHTSA ID

11470259

Incident

May 3, 2022

Mileage

70,000 mi

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

TELEMATICS SERVICE INFORMATION HINT: This bulletin applies to vehicles equipped with a 4G network compatible TCU. TCUs compatible with 3G network only are no longer supported. SERVICE INFORMATION The APPLIED VEHICLES that come equipped with a factory installed SOS switch, located near the overhead map lamp, also come equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active NissanConnect® Services subscription, the TCU communicates with the NissanConnect® Services Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the APPLIED VEHICLES. · A table has been provided on the next page that lists the steps required to successfully configure a TCU after it has been replaced. · A CHECK-OFF SHEET has been provided on page 20 to print and check off steps as they are performed. Staple the completed CHECK-OFF SHEET to the repair order.

AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions:  When contamination or foreign material adhere to the lane camera viewing window on the windshield.  When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield.  When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information:  Refer to the following pages.  Use the search keyword “blinking” in the ESM.

INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

LANE CAMERA AIMING VEHICLE REFERENCE VALUES NOT IN ESM SERVICE INFORMATION If the lane camera requires aiming, the values in Table A on page 4 must be used.  For all other models/model years, consult the Electronic Service Manual (ESM).