2010 Chrysler Town And Country

In a letter dated August 21, 2014, the Center for Auto Safety (CAS) petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a defect investigation of alleged failures associated with the Totally Integrated Power Module (TIPM) installed in Chrysler SUV?s, trucks, and vans beginning in the 2007 model year. The petitioner alleges that TIPM defects may result in engine stall, airbag non-deployment, failure of fuel pump shutoff resulting in unintended acceleration, fire, and other symptoms. On September 25, 2014, the Office of Defects Investigation (ODI) opened DP14-004 to evaluate the petition for a grant or deny decision. ODI analyzed complaint data provided by CAS as well as complaints submitted to ODI from consumers. In total, there were 296 complaints submitted by the petitioner in the original petition and five supplements, including 271 complaints related to the subject vehicles equipped with TIPM-7. Approximately 3 percent of CAS complaints are related to vehicles equipped with TIPM-6 and ODI?s review of these complaints did not identify any safety defect trends. ODI conducted a detailed review of complaints narratives submitted by CAS and consumers including careful analysis of vehicle repair histories, warranty claims obtained from the manufacturer and any available Customer Assistance Inquiry reports (CAIR). Analysis of the field data indicated that MY2011-2013 Jeep Grand Cherokee and Dodge Durango vehicles exhibited significantly higher complaint rates related to fuel pump relay (FPR) failures than other subject vehicles. In a September 3, 2014 letter to NHTSA, Chrysler submitted a Defect Information Report (DIR) identifying a defect in the FPR within the TIPM-7 which can result in a no start or stall condition in approximately 188,723 model year (MY) 2011 Jeep Grand Cherokee (WK) and Dodge Durango (WD) vehicles manufactured from January 5, 2010 through July 20, 2011 (14V-530).In a February 24, 2015 letter, Chrysler submitted a second DIR expanding the scope of the FPR defect condition to include an additional 338,216 MY 2012 through 2013 Jeep Grand Cherokee vehicles manufactured from September 17, 2010 through August 19, 2013 and MY 2012 through 2013 Dodge Durango vehicles manufactured from January 18, 2011 through August 19, 2013 (15V-115).ODI analysis of the CAS allegations of TIPM defects resulting in stall while driving, airbag non-deployment, unintended acceleration, fire and other faults identified a single defect condition related to 1 of over 60 different circuits in the TIPM assembly. The most common effect of this defect condition, related to the fuel pump relay, was a no-start concern, but it could also result in stall while driving (76 complaints). No valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components.Except insofar as the petitioner's contentions relate to the defect condition addressed by the Chrysler recalls, the factual bases of the petitioner's contentions that any further investigation is necessary are unsupported. In our view, additional investigation is unlikely to result in a finding that a defect related to motor vehicle safety exists or a NHTSA order for the notification and remedy of a safety-related defect as alleged by the petitioner at the conclusion of the requested investigation. Therefore, in view of the need to allocate and prioritize NHTSA's limited resources to best accomplish the agency's safety mission, the petition is den

In March 2011 Chrysler submitted a defect information report for NHTSA Recall No. 11V139 declaring a defect condition that could cause the ignition key to inadvertently move from the RUN to the ACC position on model year (MY) 2010 Dodge Journey, Grand Caravan, and Chrysler Town and Country.The report identified engine stalling as the defect consequence and cited customer complaints and warranty claims, as well as two rear-end collisions, as leading to the recall action.Chrysler determined that a defective WIN module, which is effectively the equivalent of the ignition switch, was the cause of the inadvertent key rotation, and that a new design WIN module would be installed as a remedy.In Spring 2014 ODI conducted outreach to major light vehicle manufacturers regarding ignition key position and its effect on air bag system availability.The outreach was conducted in connection with NHTSA Recall No. 14V047, a recent recall involving inadvertent ignition key rotation and subsequent air bag disablement in certain GM products.During discussions held in April 2014, Chrysler advised ODI that Chrysler air bag systems of this vintage, including the subject vehicles, revert to energy reserve when the ignition key moves to the ACC or OFF position, and that under energy reserve the air bags would only be available for a short period, approximately two tenths of a second (ODI notes this consequence was not identified in the 11V139 recall report).A review of the ODI consumer database conducted after the April 2014 discussions identified complaints alleging that MY 2008-2009 vehicles may have a similar defect as the MY 2010 vehicles, and that some MY 2010 consumers reported experiencing ignition key position concerns after the 11V139 recall remedy was applied.Accordingly this investigation was opened.In response to ODI?s information request letter, Chrysler reported that MY 2008-2009 subject vehicles used the same design WIN module as the recalled vehicles, and also identified 66 consumer reports and one non-injury crash incident potentially related to inadvertent ignition key rotation.Chrysler?s review of the MY 2010 remedy used in 11V139, which involved installation of a Trim Ring as opposed to replacement of the WIN module, showed the remedy did not adequately address ignition key position concerns, and in some use-cases could cause other systems to operate improperly (radio, instrument panel lighting, HVAC fan motor, etc.).Chrysler subsequently filed multiple defect information reports to 1) add the MY 2008-2009 Dodge Grand Caravan and Chrysler Town and Country, and the MY 2009 Dodge Journey to the original recall scope, and 2) stating that the complete WIN module would be replaced with a new design component in all recalled vehicles (including those that had the Trim Ring installed during 11V139).Chrysler?s report also advises of constrained remedy parts availability, see NHTSA Recall No. 14V373 for further details.Accordingly, the investigation is closed based on the recall action Chrysler is undertaking.The ODI reports cited above can be reviewed online at http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10584873, 10583399, 10573295, 10566365, 10546805, 10513060, 10509284, 10503121, 10496599, 10475027, 10456099, 10450629, 10443680, 10422766, 10410447, 10409269, 10402947, 10402751, 10402660, 10396943, 10394957, 10356632, 10315972

The contact owns a 2010 Chrysler Town and Country. The contact stated that while pulling out of the parking space or while driving at an undisclosed speed, the vehicle started stalling. The contact stated that the ignition key was loose, and whenever the key was jiggled, the vehicle became inoperable. The contact associated the failure with NHTSA Campaign Number: 14V373000 (Electrical System, Air Bags); however, the VIN was not included in the recall. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 130,000.

NHTSA ID

11754964

Incident

Jun 5, 2026

Mileage

130,000 mi

The contact owns a 2010 Chrysler Town & Country. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly lost motive power. The failure caused a loss of power steering and power braking. The contact coasted the vehicle to the side of the road. The vehicle was turned off and restarted. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The contact related the failure to NHTSA Campaign Number: 14V373000 (Electrical System, Air bags); however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 168,000.

NHTSA ID

11735808

Incident

Feb 28, 2026

Mileage

168,000 mi

While driving my car it stopped all of a sudden leaving the car behind to slide out of control so not to hit me. A light came on. when I read the code it said vehicle ignition switch. This also happened a year ago only the car didn’t stop it slowed down to 5 miles an hour. I did repair it a year ago only for it to happen again. This is a very serious thing as I had my grand babies with me and the car behind me had three children.

NHTSA ID

11714690

Incident

Dec 4, 2025

The contact owned a 2010 Chrysler Town and Country. The contact stated that the vehicle was taken to a tire center, where a routine alignment was performed. The contact stated that while driving at 35 MPH, the wheels locked up, and the driver lost control of the vehicle. The vehicle was towed to the tire center, which eventually took possession of the vehicle due to the contact's inability to pay the service fee. The contact walked to the residence. The contact called the FTC and was referred to the NHTSA Hotline for assistance. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 100,000.

NHTSA ID

11707550

Incident

Oct 22, 2025

Mileage

100,000 mi

while driving my kids to school going on a curve about 15 mph, the car shutdown and loss control of power steering and the braking. Findings upon inspection and diagnostics review, it was determined that the Wireless Ignition Node (WIN) Module is faulty. This component is critical to vehicle ignition and operation. The failure of the WIN module causes the engine to complete shut down while the vehicle was in motion on the highway. The shutdown resulted in an immediate loss of power steering and power breaking functions, leaving the driver with severely reduced control of the vehicle. Such a malfunction poses a significant safety hazard, as the driver is unable to maintain proper handling or safely maneuver the vehicle during operation. The WIN Module has fail and must be replace immediately. Continued operation without repair could result in repeated engine shutdowns, increasing the risk of a crash or serious injury. Need replace the WIN Module with an OEM or certified equivalent part. Reprogram/ reinitialize the module as per manufacturer specifications. Test drive post-repair to ensure reliability and safety.

NHTSA ID

11687941

Incident

Sep 17, 2025

See attached document for complaint.

NHTSA ID

11686216

Incident

Jan 6, 2020

Recall repair for Chrysler recall W09 did not work. Airbag emblem still peeled from steering wheel. In event that drivers airbag deploys the emblem would be launched at the drivers face which could cause injury.

NHTSA ID

11682948

Incident

Aug 25, 2025

I have a 2010 Chrysler Town & Country (Sport Van) that has broken down and will not start. At first we thought it was the battery and then the starter. after replacing both parts that could cause for the van to not start. The problem still wasn't fix. We then had an car service center run a diagnostic check to pin point the issue. The diagnostic code shown Number (p0513). This code described the symptoms the van is having, but not while driving. After learning about the diagnostic code we learned that there was a recall. The summary of the recall is as follow: "Chrysler is recalling certain model year 2010 Dodge Journey, Grand Caravan, and Chrysler Town & Country vehicles manufacturer from August 3, 2009. through June 17, 2010. Some vehicles may experience inadvertent ignition key displacement from the run to accessory position while driving causing the engine to shut off". After reading about the issues with this recall, I immediately contacted 2 separate Chrysler dealerships about the recall and the issue I am having with my 2010 Chrysler Town & Country. Both dealerships told me the same thing, that my van wasn't covered under the recall. I was confused as to why and wanted more answers. I did have the pleasure with speaking to service person by the name given "Ash" at the Chrysler dealership at Whitten Brothers Chrysler Jeep, Midlothian, VA. Who then directed me to contact FCA Chrysler Service Corporation. After contacting Chrysler Corporation I had the pleasure with speaking with (Mina) a customer service representative, which further explained how recalls work. After explaining what happen with my van and the symptoms with no starting and the diagnostic coding shown to why. Mina, recommended that I should contact you guy to look further into my case in hope to grant us a recall and service to our 2010 Chrysler Town & Country that is showing and giving us the same effects listed in Chrysler recall for this year, make, and model. Please consider helping

NHTSA ID

11657949

Incident

Apr 25, 2025

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Lubrication and Maintenance Fluids If MOPAR fluids and chemicals are not readily available, please review Service Library for specifications so a suitable alternative can be used

If a Mopar oil filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils.