2010 Chrysler 300

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

I have a 2010 Chrysler 300 and when I fill my tank up I take the handle out when it clicks I don’t keep filling because I know not to. My car will smell like someone poured gas into my backseat and if I roll the driver side window down for air it seems to get stronger for a little over 3 months now until it gets a quarter in a half below full. Now I don’t fill my car up all the way due to that and no one has figured it out yet. I have replaced lines and caps and now the fuel pump to find out none of it was the problem. I was followed home tonight to be told my car was pouring out gas from under the fuel pump area while I was driving. So I took a video of it pouring out under the driver back seat area and then I pulled off the back seat to find gas all on top of my brand new fuel pump. First I figured maybe the seal wasn’t on right but everything was put on correctly but yet I have no clue why there is gas everywhere especially seeing the pump is in correct. I can’t drive my car nor take my grandson anywhere with my car smelling like gas. Not understanding why my old and new fuel pump is backing up and I wouldn’t run my car on empty nor overfill. I have spent a bit of money into my car replacing things to continue to have the same problem. Major issue scared to ride in my car not knowing if it is going to catch on fire and that is my main transportation. By the way I changed my fuel pump because my car wouldn’t start yesterday and I didn’t hear the fuel pump turning on so tapped it a few times and it clicked on and it was whining so loud I parked it a few blocks away at a family members house scared to be stuck on the side of the road going home yesterday. Seatbelt lock box quit working as well I literally have to push it in 50 times to get it to click very irritating especially if you are in a hurry but that is way minor compared to my gas issue for the last few months Wish I could share video to show gas pouring out can’t see in pictures

NHTSA ID

11725728

Incident

Dec 2, 2025

Mileage

257,139 mi

The contact owned a 2010 Chrysler 300. The contact stated that while her partner was driving at 30 MPH, he crashed into a vehicle due to his vision being obstructed by the sun. The air bags did not deploy upon impact. The contact's partner was taken to the hospital by ambulance, where he was treated for whiplash, a cervical strain on his hips, and pain in his right side of his ribs. The other driver was also taken to the hospital as a precautionary measure, but did not sustain any injuries. A police report was filed. Due to the failure, the vehicle was towed to an independent tow yard. The manufacturer had yet to be notified of the failure. The vehicle was deemed a total loss. The failure mileage was 188,760.

NHTSA ID

11699385

Incident

Nov 10, 2025

Mileage

188,760 mi

See attached document for complaint.

NHTSA ID

11692358

Incident

Sep 15, 2025

TIPM prevented safe operation of vehicle. Stopped for no reason. Horn blowing repeatedly uncontrollable. Transmission locked.

NHTSA ID

11506171

Incident

Jan 10, 2023

The contact owns a 2010 Chrysler 300. The contact stated while attempting to turn off the vehicle, the vehicle remained powered on without the key in the ignition. The vehicle was taken to a local dealer where it was diagnosed with needing the WIN module replaced however, the vehicle was not repaired. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 10V200000 (Electrical System) however, the VIN was not included. The manufacturer was informed of the failure and informed the contact that the VIN was not under recall. The failure mileage was 124,725.

NHTSA ID

11452298

Incident

Feb 9, 2022

Mileage

124,725 mi

Odometer been tampered with and also my car caught on fire the other day

NHTSA ID

11440319

Incident

Nov 10, 2021

On May 9th I went to pick up my check and I freaking ran over run over a big rock in the street and it it put like a little hole in my oil pan well this is my first car I've had already my second car I haven't had it for that long so what I did was I'm going to try to get home as the oil slowly leaking out but I was going to try to get home and I drive for like for like 3 minutes at like 20 at like 25 miles per hour 30 miles per hour and like probably like three or four minutes from that incident and I stopped before that too to get the money and then I tried to raise home whatever I'm driving and in the key pops out the addition but it always pops out the ignition crazy and s*** but then the car just like like the lights just act like they they just died on me while I was driving he pops out the lights or whatever and then I stayed that day with my car that happened at 5:00 I was trying to patch up the oil coming out and it turned out to be 2:00 when I noticed it was 2:00 and the oil still coming out all this extra s*** I was probably 1:00 and I bought a oil I bought a one thing oil just to keep keep it in there and stuff cuz I thought I lightweight patched up and I end up getting it towed to my house and I'm the person I'm going to make sure it gets fixed before I drive this stuff is 138,000 Miles only had it for like 2 months now would be like three or four months but yeah and put the oil pan on and somebody stole my radio so I don't know they f***** up some stuff in there but I go to turn on like finally turning the car and stuff and then it is giving me a mobilizer warning it it dies out the battery when I was trying to do it excessively but it's like this stuff thing going on the key won't f****** stand in ignition you like pops out every time I turn it all the way over no matter what key it is only got two of the fob and the transponder the door maybe they've been broken into or something so it looks all sketchy can't put a key into the door and p0 513..

NHTSA ID

11424261

Incident

May 9, 2021

LOW OIL PRESSURES LITE COMES ON BLINKS GOES OUT WHEN YOU PRESS DOWN ON THE PEDDLE TO ACCELERATE CAR REPLACED OIL SENDING UNIT STILL DOES IT HAS TO BE ELECTRICAL PROBLEM CAR 10 YEARS OLD

NHTSA ID

11372792

Incident

Nov 1, 2020

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Lubrication and Maintenance Fluids If MOPAR fluids and chemicals are not readily available, please review Service Library for specifications so a suitable alternative can be used

Fuel Pump Connector Replacement The technician may experience a crank/no start after the fuel pump module was replaced. This bulletin involves replacing the fuel pump connector harness (pigtail) when replacing the fuel pump module.