2015 Chrysler 300

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

On July 23, 2015, Fiat Chrysler Automobiles (FCA) launched Safety Recall 15V-461 to remedy security vulnerabilities in approximately 1.4 million model year (MY) 2013 through 2015 vehicles equipped with Uconnect head units (HU) 8.4A (RA3 radio) and 8.4AN (RA4 radio) manufactured by Harman International.On July 24, 2015, the Office of Defects Investigation (ODI) opened Recall Query, RQ 15-004, to investigate HU security vulnerabilities and remedy effectiveness in the recalled population and to determine whether similar units have been supplied for use in other FCA vehicles.In an August 11, 2015 letter, FCA submitted a second Part 573 safety recall report expanding the scope of the Uconnect RA4 model radio to include additional 7,810 MY 2015 Jeep Renegade vehicles manufactured from September 18, 2014 through June 25, 2015 (Recall 15V-508).Scope analysis indicated that Uconnect radios installed in FCA vehicles not included in recalls 15V-461 or 15V-508 (subject recalls) are not equipped with built-in cellular access or short range wireless communication features and, thus, do not contain the security vulnerabilities addressed by the subject recalls. SUBJECT VEHICLES: MY2014 through 2015 Dodge Durango, Jeep Grand Cherokee and Jeep Cherokee sport utility vehicles; MY2013 through 2015 Ram 1500, 2500, 3500 and 4500/5500 pickup trucks; MY2013 through 2015 Dodge Viper vehicles; and MY2015 Chrysler 200, 300, Jeep Renegade, Dodge Charger and Challenger vehicles.According to FCA, long and short range wireless vulnerabilities identified in the recalled vehicles could allow unauthorized third-party access to, and manipulation of, networked vehicle control systems.Successful exploitation of the vulnerabilities, coupled with reverse engineering of networked microprocessor control modules, could result in unauthorized manipulation of vehicle control systems. This unauthorized manipulation of vehicle controls and systems could expose the driver, vehicle occupants or other highway users to an increased risk of injury.FCA and its network provider, Sprint, conducted a nationwide campaign to block access to a radio communications port that was unintentionally left open.On July 27, 2015, short range wireless vulnerabilities were also blocked.Finally, third party security evaluation and regression testing identified vulnerabilities that were either remedied by Sprint or through updates to the FCA Uconnect software.ODI identified a total of 30 complaints or field reports on unique vehicles submitted by FCA (29) or received by NHTSA (1) alleging incidents of theft from a vehicle or anomalous performance that the owner alleged were caused by, or may have been caused by, remote hacking.Twenty-six (87%) of these reports were submitted after a magazine article was published on July 21, 2015, describing the remote hacking of an FCA vehicle by researchers who were able to affect the operation of various vehicle control systems, including the service brakes, steering, throttle and ignition.Most of the complaints involved vehicle systems that were not safety critical (e.g., complaints related to radio, navigation system, or air-conditioning control) and did not affect vehicle control.Three complaints reported engine stalls.One owner reported sudden unintended acceleration allegedly related to hacking.None of the complaints or field reports reviewed involved the steering and braking vehicle control effects demonstrated by the research hackers prior to the recall.There were no confirmed incidents of hacking in any of the records reviewed by ODI.The remedies completed by Sprint and FCA appear to have eliminated vulnerabilities that mi

The contact owns a 2015 Chrysler 300. The contact stated that while driving at 69 MPH on the freeway, when the contact attempted to switch lanes and the vehicle spun independently, causing her to collide with another vehicle on the front driver side. The contact mentioned her rear bumper detached from the vehicle. No air bags deployed. The contact did not sustain any injuries. No medical attention was required. The contact vehicle was towed to Emerine's Central Auto and Towing. The contact stated that a police report was filed. The contact stated the vehicle was previously diagnosed by an independent mechanic, and the ABS speed sensor needed to be replaced. The vehicle was repaired prior to the accident, as the ABS speed sensor was replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 141,000.

NHTSA ID

11695281

Incident

Oct 23, 2025

Mileage

141,000 mi

Possibly a failing axle shaft. Which after researching it is a common problem in this make & model.

NHTSA ID

11688068

Incident

Sep 8, 2025

The contact owns a 2015 Chrysler 300. The contact stated that while driving at an undisclosed speed, the steering wheel failed to turn in the intended direction. The contact stated that the traction control warning light was illuminated. The contact stated that the failure had occurred while reversing or while making a turn. In addition, the failure had occurred several times, including once while driving in the rain. The vehicle was taken to an independent mechanic; however, the failure was not duplicated. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The contact referenced an unknown recall; however, the VIN was not associated. The manufacturer was not made aware of the failure. The failure mileage was approximately 32,000. The VIN was unavailable.

NHTSA ID

11685784

Incident

Feb 10, 2022

Mileage

32,000 mi

This issue has been going on since February 2024. The vehicle will completely shutdown while driving ( no matter what speed I'm going ) it will say SERVICE THE SHIFTER and stop. The first time this happened I took (towed bc vehicle willl have no power since this a SAFTEY issue ) the Vero beach Chrysler dealership the vehicle to Commuter Cars in Port St Lucie which is the dealer I purchased the car from. They kept the vehicle for 2 weeks. I paid 644$ they said they replaced the shifter and that was the problem. 2 weeks later the same thing happened while driving , I took ( towed )the car to Chrysler . Chrysler charge me 200$ and said there was nothing wrong it was the safety recalls. 5 months later it happens again I take the car to Chrysler they charged me 1000$ and said it was some type of connecter . A month later it happens again I (towed) it to chysler they said the ECM shifter module had dried up coffee on it and they wiped it off and its working fine. They charge me 445$ said it needed a battery. Now it has happened again 2 months later and they are just now saying my ECM SHIFTER is bad. The service manager was rude and disrespectful. I have our conversation recorded. I said WHY am I just now knowing this after spending thousands of dollars towing this vehicle back and forth. My son and I could have been in a major accident because the car shuts completely down while driving. They never once check this and the car has been to them 4 times.

NHTSA ID

11659687

Incident

May 1, 2025

The oil filter housing cracks due to the plastic material it is made out of causing immediate loss of oil and disabling vehicle in traffic.

NHTSA ID

11637229

Incident

Jan 21, 2025

Blend doors keep failing. Keeps switching from cold to hot.

NHTSA ID

11636818

Incident

Jan 18, 2025

The contact owns a 2015 Chrysler 300. The contact stated while driving approximately 40 MPH, the brake pedal was depressed but felt soft. The contact stated that the failure occurred at various speeds, requiring that the brake pedal be depressed with excessive force. The contact stated that the ABS and ESC warning lights were illuminated. The contact stated that while braking following a curve in the road, the rear end of the vehicle started swaying slightly to the right and left. The contact stated that the warning lights were constantly illuminated. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that one of the wheel sensors needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The contact had not taken the vehicle back to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 18,000.

NHTSA ID

11629681

Incident

Aug 7, 2020

Mileage

18,000 mi

At least 20 times. Driving down the highway doesn't matter if driving straight or cornering. The engine dies. Once I get it stopped. I put it back in park. Restart the engine and it runs. There are no codes, and can't get it to duplicate the problem at the garage. I've searched the internet and this seems to be a continuous problem and no one is finding the problem. From what I've read dealerships are just throwing parts at the problem. This is a safety issue. My daughter was almost rear-ended today.

NHTSA ID

11608844

Incident

Aug 15, 2024

The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.

Active Diagnostic Trouble Code (DTC) B1A10-00, B1A11-00, B1A12- 00, B1A13-00-, B1A14-00, B1A15-00, B1A16-00, and B1A17-00 in The Radio Frequency Hub (RFH)

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

PAD KIT - REAR DISC BRAKE, FRONT DISC BRAKE

Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.

Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.