2005 Ford Escape

In a letter dated August 30, 2012, The North Carolina Consumers Council (NCCC) petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a defect investigation of alleged electronic throttle body failures resulting in engine stall or surge while driving in model year (MY) 2005 through 2012 Ford Escape vehicles. On October 2, 2012 the Office of Defects Investigation (ODI) opened a Defect Petition DP12-006 to evaluate whether to grant or deny the petition. The petition is hereby granted on certain model years. The NCCC letter cites two complaints of stall while driving in MY 2009 Ford Escape vehicles that were diagnosed as failed throttle bodies with diagnostic trouble codes (DTC) P2111, Throttle Body Stuck Open, and P2112, Throttle Body Stuck Closed. The petitioner indicates that the owners of both vehicles reported experiencing repeated incidents of stalling and engine surging. According to Ford, Escape non-hybrid vehicles are equipped with Electronic Throttle Body (ETB) assemblies beginning with MY 2009. Vehicles manufactured between June 22, 2009 and October 15, 2009 may contain contaminated printed circuit boards (PCB) with plating variations. Plating variations could lead to a lack of continuity in the throttle position sensor circuit where P2111 and/or other DTCs would be generated and stored. Ford and its electronic throttle body supplier, Delphi, modified the PCB manufacturing process and issued a technical service bulletin (TSB) 09-23-5. Vehicles produced after October 15, 2009 incorporated ETBs manufactured with a PCB process that resolved this condition. ODI's analysis identified a total of 123 unique reports indicating allegations of reduced motive power or vehicle stall. Depending on the condition of throttle control system malfunction, a driver may experience varying levels of reduced engine performance associated with three limp home modes. In two limp modes, reduced engine performance may maintain vehicle speeds above 20mph while the third is a limited limp home mode with engine speeds limited to approximately 900 RPM. Allegations of stall appear to be related to the limited limp home mode. Vehicles are not likely to unexpectedly stall as a result of this condition, but drivers may characterize the reduced functionality as a stall, even though their vehicle may still has motive capability. Allegations of vehicle surge appear to be related to limp home mode operation. Complaints alleging surge are most likely related to engine RPM fluctuations at low vehicle speeds or idle as the control system engages to prevent engine stall. In limited limp mode, rough-idle conditions may exist while the control system attempts to modulate engine RPMs once the vehicle reaches a reduced speed to maintain approximately 900 RPM. Separately, ODI received 59 complaints alleging incidents of engine stall while driving in model year (MY) 2010-2011 Ford Fusion vehicles. Approximately 60 percent (36) of the incidents occurred at speeds of 40 miles per hour or more. Eighty percent of complaints (47) were received beginning March 2012 and 14 complaints reported that the throttle body was replaced or DTCs associated with limp home modes. Additionally, Ford issued TSB 10-21-6 addressing DTCs associated with idle speed drops and limited limp home mode. The petition is granted on certain model years.Preliminary Evaluation PE13-003 has been opened to assess the scope, frequency and potential safety consequences associated with the alleged defect.See full copy of the closing resume for this defect petition for list of the VOQs associated with the defect petition analysis.

On November 18, 2010, NHTSA's Recall Management Division (RMD) opened an audit query (AQ10-001) to investigate recall remedy completion by rental car companies on safety recall campaigns.It was expected to provide the agency an indication of how completely and how quickly rental car fleets perform necessary recall-related remedies on the vehicles owned and then rented/leased for use on the roadways.RMD queried three (3) major motor vehicle manufacturers (Ford, Chrysler, and General Motors) and requested data regarding completion figures for fifteen (15) discreet safety recalls.Analysis of this data demonstrated that rental car recalls completion was neither complete nor consistent.The rental car companies representing the largest market share in the industry were then queried as to their respective policies for the rental, lease, and sale of vehicles with open recalls.The data and responses from the manufacturers and the rental car companies can be found in the document repository by accessing the ?Associated Documents link above.In December 2015, Congress enacted the Fixing America's Surface Transportation (FAST) Act.One section of the Act prohibits rental car companies from renting, leasing, or selling motor vehicles subject to open safety recalls.With the passage of the FAST Act and its prohibition, there is no continuing need for the agency to investigate rental car recall completions.Accordingly, this investigation is closed.The agency reserves the right to open any future investigations, including audits of individual recalls, or groups of recalls, or rental car companies, to examine more closely safety recalls performance and completion issues in this area.

I bought a 2005 Ford escape the VIN number on the dash and the title do match however the ECU and the door jamb VIN [XXX] which is for a 2006 Ford escape 4 cylinder 2.3. the vehicle I bought should be a 6 cylinder with a 3.0 l the mechanic says mismatched VIN the dealership refuses to listen. About the vehicle on [XXX] drove it 30 miles then was able to call the mechanic for some maintenance as his car was for my daughter and that is when I got to bad news of a mismatched VIN. Not even your odometer reading is correct has less on it now than it did back in 2018 and it's documented as accurate. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11706432

Incident

Dec 12, 2025

Odometer Fraud. The contact purchased a 2005 Ford Escape on November 25, 2025. The contact discovered a mileage and VIN discrepancy after the purchase. The vehicle was a dealer sale. At the time of purchase, the mileage was 199,500. The vehicle was taken to the dealer for a routine inspection, and the dealer informed the contact that during the diagnostic test there was another VIN was associated with the vehicle, and the mileage listed on the diagnostic test was 199,345. The other VIN linked in the diagnostic test for the vehicle was associated with a 2006 Ford Escape, and the mileage was 199,345. It was later discovered that the dealer who had sold the vehicle to the contact had purchased the vehicle in 2018, and the mileage was 199,876. The contact stated that the mileage on the reverse side of the Title was 199,876. The Police were notified; however, no assistance was provided.

NHTSA ID

11705617

Incident

Dec 13, 2025

Mileage

199,876 mi

I had just started up my 05 Ford hybrid Escape reversed out of a parking space, applied my brakes and a loud warning noise went off, the ABS light & the Brake light went on, then I tried to brake while backing out of the parking stall. I had no brakes, petal went all the way to the floor. I shifted into drive to pull forward. The car wouldn’t stop petal just went right to the floor, had very little resistance. I almost drove through the front glass doors of the P/T office across from the pharmacy in Cool, CA. The roads are mountainous windy and steep. I was definitely scared for my safety. I had to coast very slowly on the way home. I was on my way to work but instead I dropped it off at home and called ride share to take me to work! I had to use my emergency brake to make the turn up my dirt road. I still had little to no brakes to stop the car. I parked it and haven’t driven it since. Much to dangerous to drive this car. I could have easily been killed not having brakes. It Showed no codes, had no warning at all. I just bought the car about 6 months prior. The next day it was as if it never happened.

NHTSA ID

11702633

Incident

Nov 15, 2025

Front Subframe rusted out causing loss of steering and control. Car came to a complete skidded stop . The front wheel nearly came off. The subframe issue is the same problem that resulted in a recall of the 2001-2004 Ford Escape.

NHTSA ID

11657235

Incident

Dec 11, 2024

The contact owns a 2005 Ford Escape. Upon starting of the vehicle, the contact placed the vehicle into drive(D); however, the vehicle failed to accelerate upon the depression of the accelerator pedal. The contact stated that prior to the failure, the check engine warning light illuminated and remained illuminated on the instrument panel. The contact stated while driving at highway speeds, the vehicle independently downshifted and the vehicle failed to accelerate above 30 MPH. The vehicle was shaking, and the vehicle failed to accelerate upon the depression of the accelerator pedal. The vehicle was taken to an independent mechanic where and the contact was informed that the transmission torque converter was defective and needed to be replaced. Neither the dealer nor the manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was approximately 105,000.

NHTSA ID

11581658

Incident

Nov 1, 2023

Mileage

105,000 mi

The right lower control arm separated from the subframe due to subframe rust. It caused loss of handling and rendered the car immobile. It was caused by a panic stop at a low speed. The car was towed to an independent garage where it is awaiting repair. Parts affected were the subframe, CV axle joint and the front fender (From the wheel hitting it when it broke).

NHTSA ID

11577074

Incident

Mar 11, 2024

Hello, The engine cradle subframe on my 2005 Ford Escape has completely rusted through on the right hand side where it attaches to the steering control arm. As I was driving the subframe broke which made it impossible to steer the car. This pulled my car off the road to the passenger side. Fortunately I was not injured. Having now researched this issue, it is a common problem with 2005 Ford Escapes. This is very dangerous, and it should be addressed as it creates a life threatening situation.

NHTSA ID

11565921

Incident

Jun 1, 2023

The right back tire shock and spring mount broke right off

NHTSA ID

11533399

Incident

Jul 10, 2023

For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.

The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.

FORD/MERCURY: MIL ON WITH DTC P0351-P0356; MULTIPLE COIL PRIMARY CIRCUIT. BUILT ON OR BEFORE 10/03/05. SOME VEHICLES EQUIPPED WITH A 3.0L ENGINE MAY EXHIBIT A MULFUNCTION INDICATOR LAMP (MIL) ON WITH TWO OR MORE DIAGNOSTIC TROUBLE CODES (DTCS) FOR COIL ON PLUG (COP) PRIMARY CIRCUIT FAULTS. *PE

2005-08 ESCAPE/ESCAPE HYBRID/MARINER - 2006-08 MARINER HYBRID - WHEEL SPEED SENSOR RING REPLACEMENT PROCEDURE UPDATE TO WORKSHOP MANUAL. *NJ

SLOW FUEL FILL AND/OR DTC P0451. *NJ

SLOW FUEL FILL DUE TO CLOGGED VENT. *KB