2006 Ford Escape

In a letter dated August 30, 2012, The North Carolina Consumers Council (NCCC) petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a defect investigation of alleged electronic throttle body failures resulting in engine stall or surge while driving in model year (MY) 2005 through 2012 Ford Escape vehicles. On October 2, 2012 the Office of Defects Investigation (ODI) opened a Defect Petition DP12-006 to evaluate whether to grant or deny the petition. The petition is hereby granted on certain model years. The NCCC letter cites two complaints of stall while driving in MY 2009 Ford Escape vehicles that were diagnosed as failed throttle bodies with diagnostic trouble codes (DTC) P2111, Throttle Body Stuck Open, and P2112, Throttle Body Stuck Closed. The petitioner indicates that the owners of both vehicles reported experiencing repeated incidents of stalling and engine surging. According to Ford, Escape non-hybrid vehicles are equipped with Electronic Throttle Body (ETB) assemblies beginning with MY 2009. Vehicles manufactured between June 22, 2009 and October 15, 2009 may contain contaminated printed circuit boards (PCB) with plating variations. Plating variations could lead to a lack of continuity in the throttle position sensor circuit where P2111 and/or other DTCs would be generated and stored. Ford and its electronic throttle body supplier, Delphi, modified the PCB manufacturing process and issued a technical service bulletin (TSB) 09-23-5. Vehicles produced after October 15, 2009 incorporated ETBs manufactured with a PCB process that resolved this condition. ODI's analysis identified a total of 123 unique reports indicating allegations of reduced motive power or vehicle stall. Depending on the condition of throttle control system malfunction, a driver may experience varying levels of reduced engine performance associated with three limp home modes. In two limp modes, reduced engine performance may maintain vehicle speeds above 20mph while the third is a limited limp home mode with engine speeds limited to approximately 900 RPM. Allegations of stall appear to be related to the limited limp home mode. Vehicles are not likely to unexpectedly stall as a result of this condition, but drivers may characterize the reduced functionality as a stall, even though their vehicle may still has motive capability. Allegations of vehicle surge appear to be related to limp home mode operation. Complaints alleging surge are most likely related to engine RPM fluctuations at low vehicle speeds or idle as the control system engages to prevent engine stall. In limited limp mode, rough-idle conditions may exist while the control system attempts to modulate engine RPMs once the vehicle reaches a reduced speed to maintain approximately 900 RPM. Separately, ODI received 59 complaints alleging incidents of engine stall while driving in model year (MY) 2010-2011 Ford Fusion vehicles. Approximately 60 percent (36) of the incidents occurred at speeds of 40 miles per hour or more. Eighty percent of complaints (47) were received beginning March 2012 and 14 complaints reported that the throttle body was replaced or DTCs associated with limp home modes. Additionally, Ford issued TSB 10-21-6 addressing DTCs associated with idle speed drops and limited limp home mode. The petition is granted on certain model years.Preliminary Evaluation PE13-003 has been opened to assess the scope, frequency and potential safety consequences associated with the alleged defect.See full copy of the closing resume for this defect petition for list of the VOQs associated with the defect petition analysis.

I was in a major high speed frontal crash on April 4th. I hydroplaned on 204 and I almost died and none of my airbags deployed. I have several videos from the tow yard showing that they were still intact and didn't deploy, but this firm won'tlet me upload them. This car has never been in a wreck before, and my airbags were never recalled like other Takota ones around that time period. The wreck so serious that none of the first responders knew how I survived or on crawled out of the car to get help. The only savageable things for parts in that entire car were two floorboards and my airbags didn't deploy at all. I have suffered many lacerations and bruising all over my body.

NHTSA ID

11729724

Incident

Apr 4, 2026

Sunroof on the vehicle just shattered. No impact related cause. Maybe heat.

NHTSA ID

11664348

Incident

Jun 2, 2025

I was driving on the highway, when the car steering started to pull to the left, and an alarm chime was heard from the dash, and a wrench light on the dash came on, as well as a service steering system soon message appeared on the message display. This happened multiple times. I contacted the local Midland Ford Dealer about this issue, as they had replaced the Electronic Rack & Pinion Assembly previously. The same dealer diagnosed the problem as a corroded electrical connection in the harness connector, to the Electronic Rack & Pinion Assembly. I was hoping that they would have covered this issue under a warranty, seeing as they replaced the Rack & Pinion, and that did not fix the original problem. I was charged $624.00 to have the problem diagnosed and the Electronic Rack & Pinion electrical harness connector replaced. The problem has not reoccurred since this repair was done. I am wondering if other 2006 or after Ford Escape vehicles have experienced this same dangerous condition?.

NHTSA ID

11662328

Incident

Aug 1, 2023

The idler pulley on the subject vehicle has failed numerous times, with the mounting bolt shearing at the connection to the timing cover. Upon failure of the pulley the serpentine belt will either fail or become dislodged; when this occurs the steering, alternator, and water pump all stop operating. The vehicle becomes difficult to handle due to the loss of power steering, and is subject to shutting off due to the lack of an alternator and water pump. This particular issue has happened to me on four separate occasions in the last two years; the first time occurred while operating in traffic; the subsequent occasions were noted during startup and were detected before driving. New replacement pulleys will only last approximately 4000-5000 miles before they fail. The power steering pump and air conditioning compressor have been replaced due to concerns that they could be placing extra strain on the serpentine belt, however the issue has occurred even after replacing these components. Internet research notes that this is a common problem of the 2.3L engine in the Escape and other Ford/Mercury models of the same time frame. Nobody has reported a permanent solution; later model vehicles using the same or similar issue came equipped with electric power steering, which likely reduced the load on the pulley and its undersized mounting bolt. The idler pulley on this vehicle has proven to be an Achilles heel and should have been addressed by Ford via a recall and redesigned pulley.

NHTSA ID

11638533

Incident

Sep 11, 2023

Like so many others, I was making a sharp right turn when the vehicle stopped without warning causing cars behind me to slam on their brakes to avoid a chain rear end collision event on a busy intersection. Another driver offered help and got it restarted but the power steering stopped functioning. He pulled it off the road and I then had to drive it home. The light came on after saying "power steering service" and a wrench light. There were no codes to be read and I have been unable to get a straight answer from mechanics. The last said I need the power steering module and the rack and pinion. I finally got him to give me the specific part numbers, both of which are DISCONTINUED. Last week, I told another mechanic the problems and parts I needed and he gave me a total guestimate under $2000, so I decided to go with them and they ordered the parts. When I looked at the estimate, they did not match the part numbers I had been given, and I just found out they didnt include the module because it's discontinued. I cancelled the work. I have no options left that I can afford. THIS PROBLEM IS PERVASIVE IN THESE FORD ESCAPE MODELS AND YEARS, yet they haven't recalled any before 2008. This needs to be addressed because Ive also had the intermittent engine shutdown on the road saying "STOP NOW". Luckily, no accidents or injuries yet, but I wouldn't trust this to travel beyond my area. Shame on Ford!

NHTSA ID

11619631

Incident

Jan 20, 2024

The rear shock tower has rusted out and broken away from the frame which was conformed at a local body shop. The passenger side went first then the driver side went about a year later. There was no warning that this was happening until it broke while driving which made us lose control of the car. When we took it to a repair shop and said it was 2006 escape they responded what side did the shock tower break on this was before we told them it was a shock tower they said it's always that part on a escape I personally know 2 other people who have had the same problem all different years of escapes.

NHTSA ID

11589912

Incident

May 18, 2024

Both rear shocks, mounts, wheel wells, entire length of body door panels passenger seats are just absolutely rusted beyond repair. I've gone to a couple different shops and each one said that there is nothing they can do to fix the issue. Now the vehicle when ridden in just bounces horribly wearing out bearing springs and tires are being worn out. There is only 110759 miles on it and bought this for my wife/ kids cause I've had 3 other escapes in the past so since I work on the road this is prefect sized for then not to big or too small. I've had so many issues this last year with repairs parts and now worried about safety issues.

NHTSA ID

11579065

Incident

Mar 23, 2024

Transmission Stirring pump Spark plugs

NHTSA ID

11562480

Incident

Dec 11, 2023

For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.

The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.

FORD/MERCURY: MIL ON WITH DTC P0351-P0356; MULTIPLE COIL PRIMARY CIRCUIT. BUILT ON OR BEFORE 10/03/05. SOME VEHICLES EQUIPPED WITH A 3.0L ENGINE MAY EXHIBIT A MULFUNCTION INDICATOR LAMP (MIL) ON WITH TWO OR MORE DIAGNOSTIC TROUBLE CODES (DTCS) FOR COIL ON PLUG (COP) PRIMARY CIRCUIT FAULTS. *PE

2005-08 ESCAPE/ESCAPE HYBRID/MARINER - 2006-08 MARINER HYBRID - WHEEL SPEED SENSOR RING REPLACEMENT PROCEDURE UPDATE TO WORKSHOP MANUAL. *NJ

SLOW FUEL FILL AND/OR DTC P0451. *NJ

MALFUNCTION INDICATOR LAMP (MIL) ON WITH DIAGNOSTIC TROUBLE CODE (DTC) U2062 (HYBRID ONLY). *NJ