2018 Buick Regal

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

My car was part of recall number 22V465, which was supposed to fix a problem with the electronic brake assist system. The recall repair was done in 2023, but after my battery recently died, the same problem has come back — my brakes are very firm, and I have to press hard to stop. The car is showing trouble codes C028F:04, C1586:04, and V0420:71, all related to the electronic brake control module.

NHTSA ID

11692646

Incident

Oct 11, 2025

This issue is related to the gear shifter on the vehicle. When stopping the car and putting it into park the dashboard shows the message "Shift to Park." this vehicle has only 50,000 miles on it and this issue cause safety issues as the battery on the vehicle will drain as the car can't be turned off with this message. This issue has been reported for this vehicle in NHTSA Bulletin #10252775. However, the manufacturer is stating that it doesn't link to the cars VIN #. With 10 years + of vehicles in the GM family showing this issue and the issue being all over the internet, the issue must be reported for this vehicle.

NHTSA ID

11650765

Incident

Mar 1, 2025

Was driving home from work and my brakes suddenly stopped working, if I press all the way down on the brakes they somewhat work. Checked brake fluid and brake lines and everything seems fine. Could this be from vacuum power brake assist fail?

NHTSA ID

11622365

Incident

Oct 28, 2024

Increased stopping distance during certain brake vacuum loss events. My check engine light goes on and off periodically. When I’m at a red light my whole car shuts off and goes into a neutral mode then once I press the brake it starts back up.

NHTSA ID

11560213

Incident

Nov 1, 2023

The contact owns a 2018 Buick Regal equipped with General Tires, Tire Line: Unknown, Tire Size: 245/45R18, and DOT Number: Unknown. The contact stated that after traveling over 3,000 miles and driving at an undisclosed speed, upon reaching his destination, he became aware that an abnormal buddle had developed on the side wall of the front passenger side tire. The tire was taken to the dealer, who determined that the bubble was the result of the vehicle having been driven over a pothole. All four tires were replaced. The tires were not original to the vehicle. The manufacturer was not notified of the failure. The failure mileage was 29,500.

NHTSA ID

11557228

Incident

Nov 15, 2023

Mileage

29,500 mi

On Monday, August 14th, at approximately 5 pm, my wife and I were traveling in our 2018 Buick Regal towards a red streetlight. I began applying my brakes to come to a stop. I was several car lengths behind a vehicle that was up ahead. My car's engine then revved up and our vehicle kept on going and jerking front and back although I was applying the brakes. Our car failed to stop so I struck the stationary vehicle. I kept on applying the brakes, but the car kept on going and jerking until I struck the car in front a second time. Our vehicles engine continued to revve up and the brakes continued to fail and I struck the rear end of the car in front of me again. The other driver crossed the intersection with us traveling right behind with no control over our vehicle. When we crossed the intersection there was an incline, so this slowed down our car since our brakes did not work, I pulled the steering wheel to the right towards the cement curb, then I put the transmission into Park, then the car's engine revved up once again and made a loud noise. Both vehicles sustained damage. I then was able to turn the engine off. This action was the only maneuver which stopped our car. Both my wife and I had injuries which we were checked at a hospital emergency room. We have our vehicle parked at our home's driveway and it it available for inspection. The fact that our vehicle's brakes failed to function placed me and my passenger and others at risk. My wife called our dealership the following day, and a manager stated we needed to report this incident. Our vehicle has not been inspected at this point. There were no symptoms of the problem that appeared other than the engine making a sound like increasing in speed and the brakes failing. At the hospital I was diagnosed with a concussion. My wife was diagnosed with neck pain since her head kept snapping back and forth and hitting the dashboard area and the headrest. The seatbelts plus the airbags also failed to properly function.

NHTSA ID

11539236

Incident

Aug 14, 2023

The contact owns a 2018 Buick Regal. The contact stated that the front driver’s side seat failed to move forward or backward. The contact took the vehicle to the local dealer, where it was diagnosed with needing the front driver's seat metal frame to be replaced. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 85,164.

NHTSA ID

11496014

Incident

Nov 26, 2022

Mileage

85,164 mi

September 10, 2022 I was backing out of my driveway, but the car would not slow down, and I hit a tree on my neighbor's easement across the street. After a minute, I decided to move the car, put the car in drive, and again the car would not slow down, and wound up hitting the porch of my neighbor 2 houses over. I have used my left foot for braking since 1966, so it is not a case of mixing up pedals. My wife called 911, the police and ambulance showed up, and I was taken to the hospital. After x-rays, ultrasound, and 2 CT scans, it was determined that I did not have a brain bleed and I was sent home. The car was towed, examined by the insurance adjustor and body shop, and determined totalled. There were no warning lights, and only later that night did I remember that I had received a recall letter.

NHTSA ID

11486889

Incident

Sep 10, 2022

PI to help diagnose A/C concern

This preliminary information communicates information about how to determine if a wheel and tires size change is available.

This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts that are being performed on customer’s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer complaint, contact General Motors Technical Assistance Center for further support. For any vehicles that remains unrepaired after being at the dealer for three days or more and a related bulletin or PI is not found, contact General Motors Technical Assistance Center for further support.