2011 Chevrolet Silverado 2500

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

as mentioned by many customers the dash on the vehicles crack and GM refuses to pay for repairs. Now there is a Airbag recall that needs to be completed and I am told by dealer that the dash will crack more and get worse during the repair and they are not responsible for the damage. This is unacceptable and unsafe as it is costing me and consumers more money for a defective product.

NHTSA ID

11659794

Incident

Apr 14, 2025

Engine suddenly stopped running while driving and could not be restarted. It was towed to a local diesel repair shop. Diagnostics showed a catastrophic failure of the high pressure fuel pump which polluted the complete fuel system with metal.

NHTSA ID

11634401

Incident

Dec 19, 2024

The contact owns a 2011 Chevrolet Silverado 2500. The contact received notification of NHTSA Campaign Number: 21V050000 (Air Bags); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA ID

11604511

Incident

Mar 1, 2021

The contact owns a 2011 Chevrolet Silverado 2500. The contact stated while performing a routine inspection of the vehicle, the contact became aware that the entire subframe was severely rusted. The dealer and the manufacturer were not notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 110,000.

NHTSA ID

11601581

Incident

Jul 12, 2023

Mileage

110,000 mi

Reduction tank makes truck only go 55 when the tank is full causing truck to not go flow of traffic there is a recall 11001 but gm dealer will not repair and knew about this and still sold the truck without tell customer about this

NHTSA ID

11593777

Incident

Nov 20, 2019

With all the known issues involving the failing CP4 fuel pumps out in the field, why hasn't there been a nationwide recall on this issue? We're being proactive in getting our LML repaired to save our engine. We want our costs reimbursed. This isn't a "small" matter. It's freakin' huge.

NHTSA ID

11562901

Incident

Jan 1, 2024

The transmission control module (TCM) began acting erratic. At times the transmission will not shift but several times it has gone into park( with no warning) when slowing down causing the wheels to lock and the truck skids to a stop. I was nearly in 2 accidents when this happened. Both time I was hauling a load and caused the traffic behind me have to swerve to not run into me. In looking into the issue I found that in 2011 GM had put out a shop notice that they had a known problem with the TCM and they thought it might be caused by a non-OEM fan belt causing electrical discharge that might impact the TCM. A second shop notice from GM stated that the issue was due to heat and since they has mounted the unit on the fan shroud it should be moved. But none of the shops I went to knew about these shop notices from GM. Thousands of TCMS have failed but no recall. GM has now greatly reduced production of replacement modules and the cost of a new TCM has gone from $400 to $5000 ( Plus programing ) and a long wait time to get one. You can get one refurbished for $1200.

NHTSA ID

11542326

Incident

May 10, 2023

It is a transmission control module wear a lobster transmission into a Garin. Will not let you speed up or speed down and it is unsafe and GM IS making us pay for the bill. The contact stated transmission control module all across the country on back order, you cannot get a dealer to get you one within six months GM should have to do something about this.

NHTSA ID

11539801

Incident

Jul 2, 2023

This Preliminary information communicates direction to find information at www.gmupfitter.com for Police and Special Service Vehicles.

This preliminary information communicates information about how to determine if a wheel and tires size change is available.

This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This Preliminary Information communication provides information to the technician that some owners of Heavy Duty Trucks and Utilities may ask if they can lower their tire pressures. Tire pressures being set to the "Tire and Loading Label" will ensure the safe handling and ride characteristics of the truck and should not be lowered.

This PI Communications information on an alternative product dealers can use to perform 19-NA-255: Wax Coating on Frame Peeling, Metal Shows Corrosion/Rusting due to issue with getting product from current supplier listed in the bulletin.