2008 Hyundai Elantra

The Office of Defects Investigation (ODI) of the National Highway Traffic Safety Administration (NHTSA) received a petition letter dated October 10, 2021, requesting an investigation of possible defects in the electronic throttle control (ETC) system on certain Kia vehicles resulting in the opening of DP21-003. Accordingly, Model Year (MY) 2005-2016 Kia Optima/K5, MY 2006-2015 Kia Sorento, MY 2007-2016 Hyundai Elantra, MY 2007-2016 Hyundai Santa Fe, MY 2006-2015 Hyundai Sonatas are all part of the subject population. The petition was originally filed as a Vehicle Owner Questionnaire that can be reviewed at NHTSA.gov under reference (ODI) number 11439675.On November 12, 2021, ODI opened Defect Petition DP21-003 to evaluate the petitioner?s request. ODI performed trend analyses of the VOQs related to vehicle speed control issues for all the subject vehicles and found that none of the 52 Model/Model Year Hyundai/Kia vehicles demonstrated any actionable trend that warranted an investigation.Petitioners submitted 1119 VOQs and non-VOQ cases in which sudden uncommanded acceleration (SUA) or loss of motive power (LOMP) incidents were alleged.For the 1119 reports, 220 were incidents involving crashes, from which 69 subject Hyundai-Kia vehicles were inspected by Hyundai/Kia dealer technicians, Hyundai/Kia engineers, and/or third-party representatives.ODI found the inspections identified no vehicle defects related to the ETC system.Of the 220 crash-involved reports, 13 Event Data Recorder (EDR) records were downloaded successfully and 11 of those indicated driver error: (i.e.) pedal misapplication.A condition where the accelerator pedal is mistakenly applied instead of the brake pedal when the driver wants to stop the vehicle.In addition, ODI reviewed a scientific journal paper published in Forensic Science International in 2016 by Mr. Park et al ., as well as related test videos. ODI does not believe there is any evidence of uncontrollable SUA occurrences in any of the tests reviewed. NHTSA's Office of Vehicle Safety Compliance (OVSC) reviewed the allegations regarding the potential noncompliance with Federal Motor Vehicle Safety Standard No. 124.Based on the information provided, the Agency concludes there is insufficient information for us to determine if a possible non-compliance exists.Finally, both Hyundai and Kia informed ODI that all their vehicles manufactured after 2012 were equipped with an ETC management system, in which the engine speed will go to idle when the system sees signals from both the brake pedal and accelerator pedal at the same time; this is commonly known as the brake-throttle override system.After thoroughly assessing the material submitted by the petitioner, information already in NHTSA's possession, information submitted by Hyundai and Kia in response to an Information Request letter, and the potential risks to safety implicated by the petitioner's allegation, NHTSA does not believe that a formal investigation is warranted. After full consideration of appropriate factors, the petition is denied. A Federal Register Notice (FRN) further detailing NHTSA?s reasons for denial of the petition will be published.

ON AUGUST 19, 2008, HYUNDAI SUBMITTED A DEFECT INFORMATION REPORT TO NHTSA CONCERNING FUEL PUMP FAILURE RESULTING IN ENGINE STALL IN APPROXIMATELY 65,000 MODEL YEAR 2008 HYUNDAI ELANTRA VEHICLES WITH 2.0 LITER BETA ENGINES PRODUCED FROM NOVEMBER 5, 2007, THROUGH JUNE 28, 2008 (NHTSA RECALL NO. 08V-429, HYUNDAI CAMPAIGN 086).THE RECALLED VEHICLES ARE EQUIPPED WITH FUEL PUMPS MANUFACTURED WITH UPPER BODY COMPONENTS FROM A DIFFERENT SUPPLIER THAN THOSE MANUFACTURED PRIOR TO NOVEMBER 5, 2007.ACCORDING TO HYUNDAI, THE NEW SUPPLIER'S UPPER BODY COMPONENTS HAD INCORRECT DIMENSIONAL CHARACTERISTICS RESULTING IN MISALIGNMENT OF THE ARMATURE SHAFT, WHICH CAUSED SOME OF THE FUEL PUMPS TO EXPERIENCE POOR BRUSH-TO-COMMENTATOR CONTACT CONDITIONS THAT COULD RESULT IN ENGINE STALL. THE USE OF ETHANOL BLEND FUEL, CONTAINING UP TO 10 PERCENT ETHANOL, CAUSES A FILM BUILD-UP THAT CREATES HIGH RESISTANCE BETWEEN THE BRUSH AND COMMUTATOR.THE MISALIGNED ARMATURE SHAFT PREVENTS THE BRUSH AND COMMUTATOR FROM MAKING SUFFICIENT CONTACT TO OVERCOME THE HIGH RESISTANCE FILM BUILD-UP, THEREFORE PRODUCING LESS PUMPING PRESSURE THAN REQUIRED TO SUPPLY THE FUEL INJECTION SYSTEM. SIXTY-FOUR OF THE COMPLAINTS (72%), INCLUDING THE CRASH AND INJURY ALLEGATION, INVOLVE THE RECALLED VEHICLES.THE COMPLAINT RATE IN THE SUBJECT VEHICLE POPULATION IS 98.5 PER 100,000 VEHICLES, COMPARED WITH 21.4 IN THE REMAINING POPULATION, WHICH HAS ON AVERAGE BEEN IN SERVICE OVER A YEAR LONGER.THE WARRANTY CLAIM RATE IS ALSO SIGNIFICANTLY HIGHER IN THE RECALLED VEHICLES, WHICH HAD 569 CLAIMS (0.9 PERCENT CLAIM RATE) COMPARED WITH 126 CLAIMS IN THE REMAINING POPULATION (0.1 PERCENT CLAIM RATE). HYUNDAI WILL REPLACE THE FUEL PUMP SUBASSEMBLIES IN THE RECALLED VEHICLES FREE OF CHARGE.THIS PRELIMINARY EVALUATION IS CLOSED WITH HYUNDAI'S RECALL.

Power steering went out, only had manual steering.

NHTSA ID

11731913

Incident

Mar 10, 2026

The contact owns a 2008 Hyundai Elantra. The contact stated that a week after the dealer performed the recall repair under NHTSA Campaign Number: 20V061000 (Service Brakes, Hydraulic); the contact was made aware that the brake lights had remained illuminated after the vehicle was parked and turned off. The dealer and the manufacturer were not notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 199,950.

NHTSA ID

11718875

Incident

Feb 16, 2026

Mileage

199,950 mi

The car was being driven nomore than 1hr. It began to smoke under the hood. The ABS EMERGENCY BRAKE LIGHT, CHECK ENGINE Then the EPS lights were on. The vehicle was pulled over and stopped. Fire was then observed falling from under the car. The hood was then popped to see the engine mainly on the driver side was totally catching fire. Then it spread. The engine needle never showed over heated. The car took no more than 6 minutes to catch fire from the time it started smoking. It was very scary

NHTSA ID

11702148

Incident

Nov 29, 2025

The engine bay of my car caught fire due to the abs pump and module not turning off. I bought a part but never opened the box because I received a piece of mail stating the recall of that exact issue that they would replace all parts damaged. Which they didn't just installed their relay After Hyundai recall 188 was completed, my ABS pump failed. I believe it was caused by continuous power being applied post-shutdown — the exact defect the recall was meant to fix. The dealer performed an inspection but misrepresented the results and refuses to replace the damaged component under recall. This ABS pump failure is a direct result of the original recall condition — or a failed installation of the relay fix — which continued to keep power applied to the pump while the vehicle was off. This is the exact scenario the recall was intended to prevent. If the failure is caused by that condition, Hyundai is still responsible under recall. The facility which did the recall falsely recorded the mileage on my vehicle as to void any "warranty" associated with the recall as the car hasn't been driven since the module was replaced. I also instructed the diagnosis team of Wesley chapel Hyundai to keep my battery unplugged due to the parasitical drain in order to protect the battery from being dead celled and now I have to replace the battery as well. They also illegally opened a mailed box I had in my car with a part I bought prior to the recall being mailed out which I never took out of the box nor did I open the box and it was fully sealed which is a federal crime. I opened a case in which Hyundai denied helping with this faulty service and are refusing to provide me documents Case no. 41355389.

NHTSA ID

11681965

Incident

Aug 8, 2025

Has not yet been officially diagnosed by a dealer or independent service center, but while turning into a neighborhood at around 15-25 mph the car jerked and the engine suddenly stalled while I was still in the middle of the road. Thankfully I rolled into the neighborhood before an oncoming car made its way over, but it was close. The gas pedal no longer worked, and I had to restart the car. It only drove once more before shutting down and the engine will no longer turn over.

NHTSA ID

11674602

Incident

Jul 15, 2025

The entire undercarriage of the vehicle is rusted, allowed for 3 sections is not sufficient as it does not accurately account for the damage. The Fuel Suspension is also affected from the known Corrosion and Rust issue. I have had to make many costly repairs in the last 4 years and I did not know about this issue with the vehicle I have now had for 17years. Had I , I would have done my own repairs to ensure the unit was safe and operational and not only relied on Hyundai's very delayed and subpar solution - considering my unit is a 2008 and the campaign did not come out until May 2014, of which I know for a fact my car was never listed.

NHTSA ID

11664566

Incident

Jan 1, 2023

The contact owns a 2008 Hyundai Elantra. The contact stated while driving 30 MPH, the vehicle started jerking and stalled. There were no warning lights illuminated. The vehicle was taken to an independent mechanic who diagnosed the vehicle with fuel pump failure. The contact stated that the vehicle stalled intermittently. The vehicle was not repaired. The dealer was not made aware of the failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 172,600.

NHTSA ID

11655889

Incident

Nov 15, 2024

Mileage

172,600 mi

I want to go start my car just now to go to the store and when I turned it on and started it up the ABS lights emergency brake light and EPS light always lit up on my dashboard so I grabbed the manual to try to figure out what it is seen what each was individual thing standard for so I googled each individual and that's when I realized there's a recall for this from my vehicle for the ABS malfunction

NHTSA ID

11597834

Incident

Jun 30, 2024

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.

Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.