2007 Hyundai Tucson

BY LETTER DATED APRIL 15, 2009, HYUNDAI NOTIFIED THE AGENCY THAT IT WILL CONDUCT A SAFETY RECALL (NHTSA RECALL NUMBER 09V122) TO REPLACE THE STOP LAMP SWITCHES ON MANY OF ITS MODEL YEAR 2005-2008 VEHICLES.SEE RECALL 09V122 FOR A COMPLETE LIST. THE AGENCY OPENED ITS INVESTIGATION BASED ON FIVE COMPLAINTS OF STOP LAMP FAILURE ACROSS SEVERAL 2007 HYUNDAI MODELS. THE AGENCY ALSO RECEIVED EARLY WARNING (EWR) REPORTS ON THIS ISSUE.MOST OF THOSE FAILURES WERE TRACED TO THE IMPROPER OPERATION OF THE STOP LAMP SWITCH THAT CONTROLS STOP LAMP ILLUMINATION.A MALFUNCTIONING STOP LAMP SWITCH CAN CAUSE THE VEHICLE'S BRAKE LIGHTS NOT TO LIGHT DURING BRAKING, OR ALTERNATIVELY, IT CAN CAUSE THE BRAKE LIGHTS TO STAY LIT EVEN WHEN A DRIVER TAKES THE FOOT OFF THE BRAKE PEDAL. FAILURE OF THE STOP LAMPS TO ILLUMINATE PROPERLY CREATES THE HAZARD OF REAR END COLLISIONS WHEN DRIVERS FOLLOWING THE SUBJECT VEHICLE DO NOT RECOGNIZE THAT THE VEHICLE IS SLOWING OR STOPPING. HYUNDAI REPORTED ONE CRASH INCIDENT (A FRONTAL IMPACT), WITHOUT INJURY, THAT WAS ALLEGED TO HAVE BEEN CAUSED BY THIS DEFECT.THE AGENCY REVIEWED THE INCIDENT AND CANNOT CONCLUDE THAT IT IS RELATED TO THIS DEFECT. THERE ARE OTHER POTENTIAL PROBLEMS RELATED TO FAILURE OF THE STOP LAMP SWITCH: FAILURE OF THE CRUISE CONTROL TO DISENGAGE, INTERFERENCE WITH PROPER FUNCTIONING OF ANTILOCK BRAKES AND ELECTRONIC STABILITY CONTROL, AND INABILITY TO MOVE THE GEAR SHIFT LEVER OUT OF PARK POSITION.BASED ON THE ABOVE SAFETY RECALL, THIS INVESTIGATION IS CLOSED.

The rear passenger control arm broke off of the subframe due to severe corrosion despite Hyundai applying a corrosion preventative under recall 17-01-013 on 12/1/2015. During all service work following the preventative in 2015, corrosion was never brought up as a concern by the dealership (we have all service records since date of initial purchase). Thankfully we had just reached our destination and were parking the car when the failure happened. Had the part failed 5 minutes earlier, we would have been on the highway at over 60mph and could have been seriously injured or worse. We had our Tucson towed to the dealership for repair as well as additional recall work under Campaign 952 for corrosion of the fuel band. We were contacted by the dealership on 8/22/24 and told that the new subframe could not be installed as the corrosion was so severe, the body mounts had also corroded away so there was nothing to attach the new subframe to. The dealership advised us that our Tucson is now totaled and it is SOLELY due to corrosion that Hyundai has been aware of and has been subject to multiple class action lawsuits over it. This is absolutely unacceptable. This car is still in perfect mechanical condition and the exterior has absolutely ZERO rust but now it can no longer be driven due to Hyundai’s shoddy subframes.

NHTSA ID

11610450

Incident

Aug 15, 2024

Check engine light came on. Had Advanced Auto check and informed it's an airbag module and I've not struck anything

NHTSA ID

11592829

Incident

Jun 6, 2024

PLEASE include my car in recall “CAMP113” see photo! The rear crossmember steel is doing exactly what your recall is for!! Please HELP BEFORE I DIE!

NHTSA ID

11525644

Incident

Jun 6, 2023

The contact's daughter owned a 2007 Hyundai Tucson. The contact stated that while her daughter was driving at approximately 45–50 MPH, she rear-ended another vehicle. The seat belt did not restrain the daughter in the seat, causing her chest to strike the steering wheel and her head to strike the front windshield. Additionally, the air bags did not deploy upon impact. The daughter received medical attention for a fractured sternum and bruising of the lungs. A police report was filed. The vehicle was towed to a tow yard and was not yet deemed totaled by the insurance company. The manufacturer was made aware of the failure and informed the contact that the failure was caused by excessive force upon braking. The failure mileage was approximately 170,000. The VIN was unavailable.

NHTSA ID

11487150

Incident

Jul 28, 2022

Mileage

170,000 mi

The contact owns a 2007 Hyundai Tucson. The contact stated while driving approximately 45 mph when the contact noticed smoke coming from the front driver's side brakes. The contact was able to pull over and had the vehicle towed to the contact's residence. The contact stated no warning lights were illuminated. The vehicle was not taken to a local dealer. The manufacturer was informed of failure and told the contact that their VIN was not included in a recall. The failure mileage was approximately 175,000.

NHTSA ID

11437345

Incident

Oct 5, 2021

Mileage

175,000 mi

Rear subframe has excessive corrosion which lead to a a lower control arm failure. In short the control arm bracket on the subframe rusted away and the control arm fell off. My wife could have been killed. It seems that this same issue pertains to several Tuscons. Car is sitting on transport trailer currently.

NHTSA ID

11437119

Incident

Oct 11, 2021

Took my car to get inspected and would not pass inspection due to rust underneath the vehicle salt corrosion. Was advised that engine was going to fall out. Took my vehicle to Hyuandai dealer for a gas tank recall which they fixed about a month ago and are now denying claims to fix the rust-which the whole car underneath is rusting. Hyundai bowser has rust issues with their vehicles and recalls. Hyundai Bowser PA-51 and Lewis Run Road, Pittsburgh, PA 15236 412-469-2100. My car was at Bowser Dealership on 05/19/2021 and Tina case manger called 06/07/2021 they denied to fix rust salt corrosion on vehicle.

NHTSA ID

11419907

Incident

May 14, 2021

TL* THE CONTACT OWNS A 2007 HYUNDAI TUCSON. THE CONTACT STATED THAT WHILE HAVING A ROUTINE VEHICLE CHECK-UP BY AN INDEPENDENT MECHANIC, THE TECHNICIAN INFORMED THE CONTACT THAT THE TRANSMISSION MAIN SEAL WAS LEAKING. THE VEHICLE WAS TEST DRIVEN AND THE TECHNICIAN INDICATED THAT THE TRANSMISSION NEEDED TO BE REPLACED DUE TO THE MAIN SEAL LEAK. THE TRANSMISSION WAS REPLACED. THE FAILURE RECURRED. ADDITIONALLY, THE HEATER FAILED TO ENGAGE PROPERLY. JOHNNY LONDOFF CHEVROLET (1375 DUNN RD, FLORISSANT, MO 63031, (314) 227-1437) WAS CONTACTED AND INFORMED OF THE FAILURE. THE CONTACT WAS THEN INFORMED THAT THE VIN WAS NOT UNDER RECALL. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND INFORMED THE CONTACT TO CONTACT NHTSA TO FILE A COMPLAINT. THE FAILURE MILEAGE WAS APPROXIMATELY 94,000.

NHTSA ID

11378290

Incident

Sep 29, 2020

Mileage

94,000 mi

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.

Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.