2022 Nissan Frontier

the truck is acquired new with a factory installed 110 Inverter and 2 outlets, one inside the passenger compartment, and one in the truck bed. i was investigating issues i have with some devices not working properly when use with the truck supplied 110v power.. i used a residential outlet tester on each outlet and found that the polarity of the outlet inside the passenger compartment had the hot & neutral lines swapped, creating a potentially dangerous situation.. if one were to have something plug into both outlets and touch both items you could get voltage across the body.. also it is possible to get voltage from an item plugged into the incorrect outlet to the vehicle frame ( ground). also even though they are 3 prog outlets, the actual ground plug does not seem to be connected to anything, the tester shows an open ground.

NHTSA ID

11767820

Incident

Sep 29, 2026

A warning light came on my dash. When I took it to the dealership they told me my airbag module would need to be replaced based on their diagnostic. They told me my airbags are possibly not working at this time. I feel this is a huge safety issue. Since I am unable to afford the $2919.90 to have it replaced I am driving a unsafe vehicle.

NHTSA ID

11764535

Incident

Sep 14, 2026

After some driving my Forward Driving Aids light comes on showing the Front Sensor is blocked which it isn't and my Radio sounds like static which will stop if I turn the radio off then back on again but does it multiple times while driving also gets very staticy when a phone is plugged in to charge.

NHTSA ID

11748365

Incident

Jan 2, 2026

While driving the Automatic Braking System (ABS), Traction Control, forward collision, rear collision and system fault triangle alerts displayed resulting in systems being disabled. Pulled code, C1116, while waiting for dealer service availability. Dealer confirmed the issue is known, and Nissan issued a technical bulletin, NTB22-084, on Sept 29 2022 for issue impacting the ABS Control Module. According to Nissan this module issue impacts the ABS, TCS, collision detection, and cruise control systems.

NHTSA ID

11746916

Incident

Jun 26, 2026

We are having trouble with the passenger door being inoperative. It will not unlock with the fob or manually, trapping the occupant in the passengers seat. Using AI we determined this is not an isolated problem. A person of my age cannot get out of the car which could present a very serious problem for the occupant.

NHTSA ID

11742483

Incident

Jun 3, 2026

The rear view camera stays dark for at least 1 minute a few times a week when starting the vehicle. This is after the software update.

NHTSA ID

11730165

Incident

Oct 24, 2025

If i get any snow at all on the front of the vehicle. The front accident warning does not work.

NHTSA ID

11730163

Incident

Mar 26, 2025

See attached document for complaint.

NHTSA ID

11723659

Incident

Jan 19, 2026

WIRING HARNESS REPAIR INFORMATION This bulletin is no longer active. For future reference, see the HRK mobile app and the Electronic Parts Catalog (EPC). Please discard previous versions of NTB14-032.

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

EXCESSIVE WIND NOISE FROM WINDSHIELD AREA YOU CONFIRM The customer states there is a screeching, humming, buzzing, whistling and/or squealing type wind noise from the windshield/roof area of the vehicle, AND The wind noise is most noticeable at speeds of 50 mph or higher. ACTION Use the SERVICE PROCEDURE starting on page 4 to install two (2) pieces of foam (one on each side) between the windshield molding and the body roof line. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual

AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions:  When contamination or foreign material adhere to the lane camera viewing window on the windshield.  When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield.  When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information:  Refer to the following pages.  Use the search keyword “blinking” in the ESM.