2002 Nissan Sentra

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The contact called regarding the ownership of the 2002 Nissan Sentra. The contact received notification of NHTSA Campaign Number: 20V008000 (Air Bags); and would like the address to be removed from the vehicle recall distribution list because the vehicle owner does not live at the contact’s address. The manufacturer was contacted.

NHTSA ID

11720117

Incident

Feb 24, 2026

Unknown

NHTSA ID

11647072

Incident

Feb 19, 2025

THERE'S SOMETHING WRONG WITH THE COOLING SYSTEM WHEN I RECALL DATA REFRESHED ON NOV 04,2020 1UNREPAIRED RECALLS ASSOCIATED WITH THIS VIN JAN 09,2020 MANUFACTURER RECALL NUMBERPM684 NHTSA RECALL NUMBER20V-008 RECALL STATUSRECALL INCOMPLETE SUMMARY TAKATA HAS DETERMINED THAT A DEFECT RELATED TO MOTOR VEHICLE SAFETY MAY ARISE IN SOME OF THE SUBJECT NON-DESICCATED AMMONIUM NITRATE INFLATORS DUE TO PROPELLANT DEGRADATION OCCURRING AFTER PROLONGED EXPOSURE TO HIGH ABSOLUTE HUMIDITY, HIGH TEMPERATURES AND HIGH TEMPERATURE CYCLING THIS CAR.

NHTSA ID

11373048

Incident

Nov 4, 2020

Mileage

102,000 mi

TL* THE CONTACT OWNS A 2002 NISSAN SENTRA. THE CONTACT STATED THAT WHILE DRIVING 40 MPH OR STOPPED AT A TRAFFIC LIGHT, THE VEHICLE SHUTOFF WITHOUT WARNING. THE CONTACT HAD AN INDEPENDENT MECHANIC REPLACE THE FUEL PUMP, THE SPARK PLUGS, THE FUEL FILTER AND THE EXHAUST PIPES. A DEALER WAS NOT CONTACTED. THE FAILURE PERSISTED. THE MANUFACTURER WAS CONTACTED AND INFORMED OF THE FAILURE. THE FAILURE MILEAGE WAS 120,000.

NHTSA ID

11359850

Incident

Nov 1, 2019

Mileage

120,000 mi

NO LONGER OWN THIS CAR

NHTSA ID

11321630

Incident

Apr 19, 2020

Mileage

100,000 mi

I WAS MADE AWARE RECENTLY( MARCH 2020) THAT THE CAM SENSOR IN MY CAR IS DEFECTIVE. THERE WAS A RECALL ON THIS PART IN 2004. AFTER CONTACTING THE NISSAN CORPORATE HEADQUARTERS, THEY INFORM ME THAT THEIR RECORDS SHOW THE RECALL REMEDY WAS SATISFIED IN 2004. I DO NOT REMEMBER BRINGING THE CAR TO THE DEALERSHIP NOR DOES THE DEALERSHIP HAVE ANY RECORD THE RECALL WAS SATISFIED.

NHTSA ID

11318374

Incident

Mar 16, 2020

Mileage

10,900 mi

TAKATA RECALL. WENT TO DEALERSHIP TO REPLACE THE RECALLED AIRBAG. THEY INSPECTED THE AIRBAG INFLATOR, SAID IT DOES NOT NEED TO BE REPLACED. THEY DID NOT DO ANY REPAIR OR REPLACEMENT WORK ON THE TAKATA AIRBAG DESPITE THE FACT THAT THE RECALL NOTIFICATION STATING THAT THE NISSAN DEALER WILL REPLACE THE AIR BAG INFLATOR WITH A NEW ONE. *DT VIN AVAILABLE *JB

NHTSA ID

11166077

Incident

Jan 9, 2019

I WAS NOTIFIED OF AIR BAG RECALL BY NISSAN. I TOOK MY VEHICLE TO THE LOCAL DEALERSHIP AND THEY AGREED TO FIX BUT WANTED ME TO RELEASE THEM OF RESPONSIBILITY IF THEY CRACKED MY DASH BOARD DURING THE REPAIR. I REFUSED TO GIVE PERMISSION TO DAMAGE MY VEHICLE. AS INSTRUCTED BY THE DEALERSHIP I CALLED 1800 NISSAN CONSUMER AFFAIRS AND REPORTED AND THEY ALSO CONFIRMED THEY COULD REPAIR BUT SAID I WOULD HAVE TO ASSUME RESPONSIBILITY FOR ANY DAMAGE CAUSED BY/DURING THE REPAIR. MY VEHICLE CURRENTLY IS NOT DAMAGED AND I REFUSE TO ASSUME RESPONSIBILITY FOR ANY DAMAGE THEY MAY CAUSE.

NHTSA ID

11128238

Incident

Aug 4, 2018

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).

VEHICLE KEY NOT DETECTED / AUTHENTICATED, ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

WINDOW GLASS WARRANTY INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.