2006 Chevrolet Corvette

On May 14, 2014, General Motors (GM) submitted a Part 573 defect information report initiating NHTSA Safety Recall 14V-251 to remedy the subject vehicles.GM will remedy a defect condition in the underhood bussed electrical center (UBEC) by modifying the vehicle's electrical harnessing.GM also announced a customer satisfaction bulletin to address this issue on model year (MY) 2008-2013 Chevrolet Corvettes.Both programs will be conducted free of charge.According to GM, when the engine heats up and cools down (from normal use), the plastic material in the UBEC housing expands at a different rate than an electrical conductor routed within it.The difference in expansion rates results in bending of the conductor, a control circuit for the low beam headlights.After multiple thermal cycles, often taking several years of use, the conductor fractures resulting in an open circuit.When this occurs the low-beam headlights will not illuminate.After the engine is turned off and the UBEC cools, the conductor may temporarily reconnect and restore low-beam function, although subsequent failures will occur.This condition does not affect high-beam headlights, marker lamps, turn signals or fog lamps.Simultaneous loss of low-beam headlights could reduce the driver's visibility, increasing the risk of a crash. The ODI report counts noted above, involving the loss of low beam headlights, represents those received at the time of GM's recall filing; however NHTSA has since received additional complaints.GM submitted similar complaints in response to the agency's information request.Among the complaints reported to NHTSA, five alleged minor crashes in which the vehicle ran off the road or into roadside objects due to the sudden loss of headlights.Two of these complaints alleged minor injuries and three alleged property damage.Several other reports to NHTSA alleged close calls due to the loss of lighting.GM states that it has received no reports of crashes, injuries or fatalities as a result of this condition. GM's recall action appears to adequately address the safety risks in the subject vehicles of concern to ODI.Accordingly, the investigation is closed.In addition to recalling the subject vehicles, GM is covering MY 2008-2013 Corvettes, which contain essentially the same UBEC, under a customer satisfaction campaign.ODI notes that these vehicles exhibit a lower likelihood of failure due to their comparatively shorter service life. The VOQs cited above can be viewed at www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10400308, 10415603, 10415867, 10416531, 10421639, 10424391, 10424543, 10445971, 10451733, 10454919, 10460674, 10460750, 10463546, 10466342, 10466857, 10468128, 10469057, 10470616, 10471595, 10474350, 10474368, 10475257, 10486597, 10491670, 10496592, 10496788, 10498100, 10502059, 10505606, 10508507, 10510052, 10511467, 10511517, 10511576, 10511696, 10511699, 10511789, 10511837, 10511994, 10512072, 10512093, 10512154, 10512292, 10512341, 10512856, 10513422, 10514576, 10514802, 10514978, 10515162, 10515311, 10515821, 10519426, 10519879, 10520155, 10521036, 10521585, 10522260, 10523059, 10523064, 10523190, 10525646, 10531602, 10531631, 10532221, 10532439, 10533227, 10533251, 10533339, 10536835, 10537561, 10537612, 10538184, 10541749, 10542468, 10542540, 10542576, 10542708, 10542726, 10543187, 10543970, 10544083, 10544810, 10545441, 10545516, 10547343, 10547561, 10547600, 10548492, 10548588, 10548687, 10548982, 10549272, 10549487, 10550079, 10550260, 10551233, 10551867, 10551926, 10551978, 10552019, 10553258, 10554456, 10554573, 10556002, 10556433, 10556844, 10556984, 1

The Office of Defects Investigation (ODI) opened this investigation based on 30 reports from consumers alleging that, after driving for a short time (5 to 30 minutes), both low beam headlights stopped working simultaneously and without warning. The low beam headlights remained inoperative for the remainder of the drive cycle, however no other lighting is affected.General Motors (GM) provided information in response to ODI's information request letter explaining that the loss of headlights is caused by a fractured low beam circuit wire in the underhood bussed electrical center (UBEC), a device that is similar to a fuse box. The UBEC is located in a high heat area near the engine, and the low beam circuit wire routing within the UBEC makes it susceptible to cyclical stress caused by thermal expansion.The investigation covers model years 2005-2007 Corvettes however ODI also has received four VOQs alleging the same condition in model year 2008 Corvettes. ODI is upgrading the investigation to an Engineering Analysis to further examine the consequences, frequency and scope of this problem. The ODI reports cited above can be reviewed at http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification (ODI) numbers.For MY 2005-2007: 10400308, 10415603, 10415867, 10416531, 10421639, 10424391, 10424543, 10445971, 10451733, 10454919, 10460674, 10460750, 10463546, 10466342, 10466857, 10468128, 10469057, 10470616, 10471595, 10474350, 10474368, 10475257, 10486597, 10491670, 10496592, 10496788, 10498100, 10502059, 10505606, 10508507, 10510052, 10511467, 10511517, 10511576, 10511696, 10511699, 10511789, 10511837, 10511994, 10512072, 10512093, 10512154, 10512292, 10512341, 10513422, 10514802, 10514978, 10515162, 10515311, 10515821, 10519426, 10519879, 10520155, 10521036, 10521585, 10522260, 10523064, 10523190, 10525646, 10531602, 10531631, 10532439, 10533227, 10533251, 10533339For MY 2008: 10512856, 10514576, 10523059, 10532221

On April 26, 2010, at NHTSA's request following this investigation, General Motors submitted a Defect Information Report to NHTSA to correct a defect associated with the Vehicle Stability Control (VSC) system in approximately 40,000 Model Year (MY) 2005 and 2006 Chevrolet Corvette vehicles (NHTSA Recall No. 10V-172).According to the report, these vehicles may have a problem with the Steering Wheel Position Sensor (SWPS) connector created by a fretting condition in the connector (small movement of the pins back and forth creating a residue build up) which could change the electrical resistance and corrupt the information signal to the VSC computer.The VSC system uses the information from the SWPS to calculate the driver's intended vehicle direction; this information is cross referenced to sensors that tell the system which direction the vehicle is actually going and the system will, if it determines a variance indicating the vehicle is in a over-steer or under-steer condition, reduce throttle control and apply braking to make a correction in vehicle direction towards what the system believes is the driver's intended path.GM dealers will inspect the SWPS connector of recalled vehicles and, if necessary, install a terminal position assurance clip to the connector.GM has advised NHTSA that its position is that the inappropriate activations of the VSC system do not present an unreasonable risk to safety because GM believes that the activations are low in occurrence, a rare set of conditions would need to be present, the driver has the ability to maintain direction control if the alleged condition were to occur, and that there are no reports of injuries.NHTSA does not agree.Based on interviews with complainants and testing performed at the NHTSA Vehicle Research and Testing Center in East Liberty, Ohio, ODI believes that the majority of the unwarranted activations of the VSC system occur when turning, in such scenarios as travelling highway entrance or exit ramps or in street traffic conditions.Complainants report the effect produced by the malfunction of the VSC system is sudden unexpected braking and in some cases a sudden unexpected change in vehicle direction which some complainants indicate was sufficient to cause a movement into an adjoining lane of traffic or in some cases into curbing or stationary objects.During the VSC event the brake lights of the Corvette are not illuminated, depriving trailing traffic from indication that braking is occurring and some complainants indicate the braking effect can be severe and last up to 10 seconds in length.Based on available information ODI counts four crashes due to a malfunction of the VSC system; GM is counting one crash due to the problem.In these circumstances NHTSA believes the defect presents an unreasonable risk to motor vehicle safety, and so advised GM when requesting this recall.This investigation is closed based on GM's recall.

ON SEPTEMBER 17, 2008, ODI OPENED PRELIMINARY EVALUATION PE08-056 TO INVESTIGATE ALLEGATIONS OF INAPPROPRIATE ACTIVATION OF THE ELECTRONIC STABILITY CONTROL (ESC) SYSTEM IN MODEL YEAR (MY) 2005 AND 2006 CHEVROLET CORVETTE VEHICLES.SOME REPORTS RECEIVED BY ODI AND SOME REPORTS TO GENERAL MOTORS (GM) CONTAINED IN GM'S RESPONSE TO PE08-056 ALLEGE THAT THE ESC SYSTEM MALFUNCTIONED CAUSING A SUDDEN AND INAPPROPRIATE BRAKING ACTION WITHOUT ILLUMINATION OF THE BRAKE LIGHTS AND CAUSING THE VEHICLE TO SWERVE LEFT OR RIGHT UNEXPECTEDLY. GM ISSUED A TECHNICAL SERVICE BULLETIN IN JANUARY 2006, LATER REVISED IN OCTOBER 2007 (BULLETIN NO. 06-02-35-002B) CONCERNING ESC PROBLEMS IN MY 2005 AND 2006 CHEVROLET CORVETTE VEHICLES WITH THE TELESCOPING STEERING WHEEL OPTION.THE BULLETIN WAS INTENDED TO CORRECT A FRETTING CORROSION PROBLEM WITH THE STEERING WHEEL POSITION SENSOR CONNECTOR C202. AN ENGINEERING ANALYSIS HAS BEEN OPENED (EA09-002) TO CONTINUE TO ASSES THE SCOPE, FREQUENCY, AND SAFETY-RELATED CONSEQUENCES OF THE ALLEGED DEFECT.

The contact owns a 2006 Chevrolet Corvette. The contact became aware that the VIN was included in NHTSA Campaign Number: 09V491000 (Structure). The vehicle was taken to the local dealer, where the contact was informed that the recall part was no longer available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed that the part had been discontinued. The contact was advised to purchase the part from a junkyard or to order an entire roof from the dealer at his expense. The contact had not experienced a failure.

NHTSA ID

11702411

Incident

Dec 2, 2025

2006 Corvette convertible. Has a strong gas smell after filling up. I understand this is a common problem, but Chevrolet will not acknowledge it. The gas can drip down on the hot exhaust system, and start a fire, burning down our house, or out on the road with us in it! Please help us get this deadly problem resolved, with little expense heaped upon us. Thank you, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11693156

Incident

Aug 30, 2016

Strong fuel smell coming from the vehicle after fueling filling.

NHTSA ID

11682855

Incident

Aug 10, 2025

We were driving 55 and the car stalled. This has happened several times. Been at dealer and the codes show fine they replaced what they thought was issue and it still does this. Very scary

NHTSA ID

11660289

Incident

May 11, 2025

I purchased this car from a dealer in Sarasota Florida. Driving it home from the dealer, I was driving approximately 70 mph on [XXX] near Sarasota. The vehicle suddenly braked and pulled to the left simultaneously. I have taken it to a repair shop that specializes in Corvettes, and trying to ID the problem. In doing research, evidently it is related to the active handling system. There is a recall NHTSA Campaign Number: 10V172000 Manufacturer GENERAL MOTORS CORP. Components STEERING Potential Number of Units Affected 40,028 and a service bulletin 10118. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11639257

Incident

Jan 8, 2025

Vehicle is leaving a strong gas order inside and around the vehicle. This issue is currently awaiting to be inspected but for the meantime, it’s parked inside a garage where it completely fills the area with said odor. This is particularly unsafe due to our water heater also being located in this section of the house. Gas smell first appeared about a month ago and had consistently releasing these vapors. I’ve seen that GM has released a service bulletin for a short period of time but hasn’t officially recalled the fuel issue (faulty fuel system).

NHTSA ID

11638767

Incident

Jan 26, 2025

The contact owns a 2006 Chevrolet Corvette. The contact received recall notifications of NHTSA Campaign Number: 09V491000 (Structure) and would like to be removed from the recall distribution list because the vehicle was no longer equipped with the recalled part. The dealer and the manufacturer were contacted.

NHTSA ID

11634338

Incident

Jan 6, 2025

The contact owns a 2006 Chevrolet Corvette. The contact received notification of NHTSA Campaign Number: 09V491000 (STRUCTURE); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA ID

11628407

Incident

Nov 18, 2024

This PI communicates the requirement to provide a pico file to receive diagnostic assistance from TAC.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

This Preliminary Information communication provides information to the technician about vehicles that have an unusual noise and is difficult to identify, isolate or pinpoint. Technician should get record a sound clip or take a video of the noise for assessment by engineering. Technician will need to call General Motors Technical Assistance Center for further assistance.

This PIC provides a diagnostic check to help technicians test for a weak hydraulic cylinder on a power folding top.